2016 Citroen BERLINGO MULTISPACE steering

171
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2016
The temporary tyre repair kit consists of  a   compressor   and   a   bottle  
(containing

  a   sealant).
Using the kit
- Tick  the   deflated   wheel   on   the  speed
  limitation   sticker   then   affix  
the

  sticker   to   the   vehicle's   steering  
wheel

  to   remind   you   that   a   wheel   is  
in

  temporary   use.
-

Clip the bottle
1 on the
compressor 2.
-

Connect the bottle
1 to the valve of
the
  tyre   to   be   repaired.
-
 
T
ake   care   to   unwind   the  
compressor

  pipe   before   connecting  
it

  to   the   bottle.
-

Connect the power lead to one of
the

  vehicle's   12V   sockets.
-
 
Switch
  on   the   compressor   by  
pressing button

A until the tyre
pressure
  reaches   2.0   bars.   If   this  
pressure cannot be reached, the
tyre

  cannot   be   repaired.
-
 
Remove
  and   store   the   compressor.
-
 
Drive
  immediately,   for   a   few   miles  
(kilometres),

  at   reduced   speed,   to  
fill

  the   puncture.
-
 
Adjust
  the   pressure   using   the  
compressor

  in   accordance   with   the  
recommendation

 
for
 
the
 
vehicle
 
and
 
check

  that   the   leak   is   filled   correctly  
(no

  further   loss   of   pressure).
-
 
Drive
  at   reduced   speed   (50 mph  
[80

  km/h]).  
The
  tyre   must   be  
examined

  and   repaired   by   a  
specialist

  as   soon   as   possible.
a
fter use, the bottle can be stored in
a   plastic   bag,   supplied   in   the   kit,   to  avoid staining your vehicle with traces
of
  fluid.
Warning:
  the   sealant   product   is  
harmful

  if   swallowed   and   causes  
irritation

  to   the   eyes.
Keep
  it   out   of   reach   of   children.
a

fter use, do not discard the bottle into
the
  environment,   take   it   to   a   CITROËN  
dealer or to an specialised waste
disposal

  site.
Replacement
  bottles   of   sealant   are  
available

  from   CITROËN   dealers.
TEMPORARY PUNCTURE
REP

AIR KIT
The kit is located in one of the two storage   compartments   located  
under

  the   front   seats.
Vehicles
  supplied   with   a   temporary  
puncture

  repair   kit   do   not   have   a   spare  
wheel

  or   tooling   (jack,   wheelbrace,   ...).
QUICk HELP
8
Changing a wheel

189
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2016
Fuses under the bonnet
after opening the bonnet, unclip and tilt
the corresponding box to gain access
to
  the   fuses. Fuses
F Amperes  Aa
llocation
1 20 Engine
  management
2 15 Horn
3 10 Front
  and   rear   wash-wipe   pump
4 20 Headlamp
  wash   pump
5 15 Engine
  components
6 10 Steering wheel angle sensor,
d SC
7 10Brake
  switch,   clutch   switch
8 25 Starter
  motor
9 10Headlamp
  beam   motor,   fleet   management   unit
10 30 Engine
  components
11 40
n

ot used
12 30 Wipers
13 40 Built-in
  systems   interface
14 30 Pump
15 10 Right-hand
  main   beam   headlamp
16 10 Left-hand
  main   beam   headlamp
17 15Right-hand
  dipped   beam   headlamp
18 15 Left-hand
  dipped   beam   headlamp
QUICk HELP
8
Changing a fuse

191
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2016
Without lifting (4 wheels on the
road)
You should always use a towing arm.
BEING TOWED
This procedure involves the use of
the towing eye supplied with the tools
for
  changing   a   wheel.
From the front
- Unclip the cover by pressing the
bottom  part.
-
 
Fully
  screw   in   the   removable  
towing eye.
From the rear
- Unclip the cover using a coin or the
flat  part   of   the   towing   eye,
-
 
Fully
  screw   in   the   removable  
towing eye. When towing with the engine
switched

  off,   there   is   no   braking   or  
steering

  assistance.
Lifting (only 2 wheels on the
road)
It is preferable to raise the vehicle
using
  professional   lifting   equipment.Vehicles fitted with a manual
gearbox (Diesel version)
In
  the   case   of   vehicles   fitted   with  
a

  manual   gearbox,   the   gear   lever  
must

  be   in   neutral,   failure   to   observe  
this

  special   condition   may   result   in  
damage

  to   transmission   and   braking  
components

  and   the   absence   of  
braking

  assistance   when   the   engine   is  
started

  again.
Section
 
8,
 
"Changing
 
a
 
wheel".
QUICk HELP
8
Having your vehicle towed

Audio and Telematics
201
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
7-inch touch screen tablet
GPS satellite navigation - Multimedia audio - Bluetooth® telephone
Contents
First steps
2 02
Steering
 
mounted
 
controls
 
2
04
Menus
205
na

vigation

206
na

vigation - Guidance
2
14
Tr a f fi c
 2

18
Radio Media

2
20
Radio
226
d

a
B (di

gital
a
u

dio Broadcasting) radio
2
28
Media


230
Settings


234
Connected services
2

42
Internet browser
2

43
MirrorLink
TM 246
C
arPlay® 250
T
elephone

254
Frequently
  asked   questions  
2
62
The
 
system
 
is
 
protected
 
in
 
such
 
a
 
way
 
that
 
it
 
will
 
only
 
operate
 
in
 
y

our
 
vehicle. As
 
a
 
safety
 
measure,
 
the
 
driver   should   only   carry   out   operations  
w

hich
 
require
 
prolonged
 
attention   while   the   vehicle   is   stationary.
The
 
display
 
of
 
an
 
energy
 
economy   mode   message   signals   that  
e

lectrical
 
systems
 
operating
 
are   going   into   standby.
Refer
 
to
 
the
 
energy
 
economy   mode   section.
TECHNOLOGY on BOARD
10

Audio and Telematics
204
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
Steering mounted controls
Radio: select the previous/next preset s tation.
Media:
  select   a   genre   /   artist   /   folder  
f

rom   the   list.
Select
  the   previous/next   entry   in  
a m

enu.
Decrease
  volume.
Radio:
  automatic   search   for   a   higher  
f

requency.
Media:
  Select   next   track.
Media,
  press   and   hold:   fast   for ward.
Jump
  in   the   list. Mute:
  cut   the   sound   by   pressing  
t

he   volume   increase   and   decrease  
bu

ttons
 s
imultaneously.
Restore the sound by pressing one of
the
  two   volume   buttons.
Radio:
  automatic   search   for   a   lower  f
requency.
Media:
  select   previous   track.
Media,
  press   and   hold:   fast   back.
Jump
  in   the   list.
Change
  the   audio   source.
Confirm
  a   selection.
Call/end
  call   on   the   telephone.
Press
  for   more   than   2   seconds:  
a

ccess   to   the   telephone   menu. Increase
  volume.

Audio and Telematics
230
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
Media
USB playerSelection of source
The steering mounted SRC ( s o u r c e)
button can be used to go to the next
media
  source,   available   if   the   source  
i

s   active.
Select
  change   of   source.
Press on Radio Media
to display the
primary
 pag
e.
The
 
system
 
builds
 
playlists
 
(in
 
temporary
 
m

emory),
 
an
 
operation
 
which
 
can
 
take
 
from
 
a

 
few
 
seconds
 
to
 
several
 
minutes
 
at
 
the
 
first
 
c

onnection.
Reduce
 
the
 
number
 
of
 
non-music
 
files
 
and
 
the
 n
umber
 
of
 
folders
 
to
 
reduce
 
the
 
waiting
 
time.
The
 
playlists
 
are
 
updated
 
every
 
time
 
the
 
i

gnition is switched off or connection of a USB
memory
 
stick.
 
The
 
lists
 
are
 
memorised:
 
if
 
they
 
a

re
 
not
 
modified,
 
the
 
subsequent
 
loading
 
time
 
w

ill
 
be
 
shorter.
Insert
 
the
 
USB
 
memory
 
stick
 
into
 
the
 
USB
 
port
 
o

r connect the USB device to the USB port
using
 
a
 
suitable
 
cable
 
(not
 
supplied).
Auxiliary (AUx) s
ocket
Connect the portable device (MP3 player…) to t
he   auxiliary   Jack   socket   using   an   audio   cable  
(

not
 sup
plied).
First
  adjust   the   volume   of   your   portable   device  
(

to   a   high   level).   Then   adjust   the   volume   of   your  
a

udio   system.
Display
  and   management   of   the   controls   are  
v

ia   the   portable   device. Choose
  the   source.

Audio and Telematics
260
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
Managing paired
telephones
This function allows the connection or
disconnection of a peripheral device as
well  as   the   deletion   of   a   pairing. Using the telephone is not
recommended
  while   driving.
Park
  the   vehicle.
Make
  the   call   using   the   steering  
m

ounted   controls.
Press on Telephone
to display the
primary
 pag

e.
Press
  on   the   secondary   page.
Select " Bluetooth " to display the list
of
  paired   peripheral   devices.
Select
  the   peripheral   in   the   list.
Select " Search for devices "
o

r "Connect / Disconnect " to start or
end the Bluetooth connection with
the
  selected   device.
o

r "Delete "
  to   delete   the   pairing.
Receiving a call
An incoming call is announced by a ring and a superimposed   display   in   the   screen.
Make
  a   short   press   on   the   steering  
m

ounted   TEL button to accept an
incoming
 c

all.
Make
  a   long   press
on
  the   steering   mounted   TEL button
to
  reject   the   call.
o

r Select "End call".
Making a call
Calling a new number
Press on Telephone to display the
primary pag e.
Enter
  the   phone   number   using   the  
d

igital
 k
eypad.
Press " Call"
  to   start   the   call.
Calling a contact
Press on Telephone to display the
primary pag e.
Or
  make   a   long   press
on
  the   steering   mounted   TEL
 
button.

Audio and Telematics
 269
Berlingo-2-VP_en_Chap10b_Rd45_ed01-2016
Audio system
Audio system / Bluetooth®
Contents
First
 
steps
 2 70
Steering
 
mounted
 
controls
 
2
71
Menus
 
2
72
Radio
 
2
72
M e d i a
 2

74
Telephone
 2

78
Screen
 
menu
 
map(s)
 
2
80
Frequently
 
asked
 
questions
 
2
84
Your
 
Audio
 
system
 
is
 
coded
 
in
 
such
 
a
 
way
 
that
 
it
 
will
 
only
 
operate
 
i

n
 
your
 
vehicle. As
 
a
 
safety
 
measure,
 
the
 
driver
 
must
 
only
 
carry
 
out
 
operations
 w

hich
 
require
 
prolonged
 
attention
 
while
 
the
 
vehicle
 
is
 
stationary.
When the engine is switched off and to prevent discharging of the
battery,
 
the
 
audio
 
equipment
 
may
 
switch
 
off
 
after
 
a
 
few
 
minutes.
TECHNOLOGY on BOARD
10