2016 Alfa Romeo 4C power steering

suitable power and torque for the
acceleration requested by the driver.
When implementing the "Kick Down"
function, the system ensures varying
transmission management in
accordance with the selected DNA
mode.
LEVERS ON THE
STEERING WHEEL
These enable sequential gear shifting
fig. 79.
– steering wheel stalk "+(pulling stalk
towards driver, see fig. 80 ): engage
higher gear;
– steering wheel stalk "–(pulling stalk
towards driver, see fig. 80 ): engage
lower gear.The engagement of a lower (or higher)
gear is only permitted if the engine rpm
allow it.
STARTING THE CAR
To start the engine press the brake
pedal: the system engages neutral (N)
automatically.
After the starting procedure, 1st gear (
1) or reverse (R) can be engaged.
Irrespective of the mode selected (
AUTO/MANUAL), to engage 1st gear
or reverse (R), it is necessary to press
the brake pedal and press the1button
on the transmission control panel (or
the "+" steering wheel stalk) to engage
1st gear or theRbutton to engage
reverse.
When 1st gear is engaged, the system
sets itself toAUTOmode.
Neutral (N) can be engaged again by
pressing theNbutton with the brake
pedal pressed.When the1,NorRbuttons are
pressed (or "+" steering wheel stalk is
operated) without pressing the brake
pedal, no gear change request is
implemented by the system.
IMPORTANT Reverse cannot be
engaged by pressing the "-" stalk on
the steering wheel.
Important information
If starting is requested with a
transmission failure (see "Warning lights
and messages" paragraph), carry out
the “Delayed start-up” procedure: when
the key is turned to AVV for at least 7
seconds with brake pedal pressed, the
engine will be started. The system will
remain in “recovery” condition.
If the engine does not start, contact a
dedicated Alfa Romeo Dealership.
When the driver's door is opened, the
system activates the hydraulic
components so that they are prepared
for the subsequent engine starting.
MOVING THE CAR
The car can set off both in 1st gear and
reverse (R).
Notes (concerning car start-up)
The gears can only be engaged by
pressing the brake pedal. If the brake
pedal is not depressed, the display will
show a dedicated message.
It is not possible to set off in a higher
gear than 1st: if this is attempted, the
display shows a dedicated message.
79A0L0071
80A0L0072
98
STARTING AND DRIVING

103)The vehicle's driving characteristics
will be modified with the space-saver wheel
fitted. Avoid violent acceleration and
braking, abrupt steering and fast cornering.
The overall duration of the space-saver
wheel is about 3000 km, after which the
relevant tyre must be replaced with another
one of the same type. Never install a
standard tyre on a rim that is designed for
use with a space-saver wheel. Have the
wheel repaired and refitted as soon as
possible. Using two or more space-saver
wheels at the same time is forbidden. Do
not grease the threads of the stud bolts
before fitting them: they might slip out.
104)The jack is a tool developed and
designed only for changing a wheel, if a
tyre gets punctured or damaged, on the
vehicle with which it is supplied or on other
vehicles of the same model. Any other use,
e.g. to jack up other vehicle models or
different things, is strictly prohibited. Never
use it to carry out maintenance or repairs
under the vehicle or to change
summer/winter wheels and vice versa.
Never position yourself under a jacked
vehicle. If any work under the vehicle is
necessary, contact the Alfa Romeo Service
Network. Incorrectly positioning the jack
may cause the vehicle to fall: use it only in
the positions indicated. Do not use the jack
for loads higher than the one shown on its
label. Never start the engine with vehicle
raised. If the vehicle is raised more than
necessary, everything can become more
unstable, with the risk of the vehicle
dropping violently. Thus, lift the vehicle only
as needed in order to access the spare
tyre.
105)The space-saver wheel cannot be
fitted with snow chains.IMPORTANT
14)Contact a dedicated Alfa Romeo
Dealership as soon as possible to have the
correct tightening of the wheel stud bolts
checked.
15)When turning the jack handle make
sure that it can turn freely without scraping
your hand against the ground. The moving
components of the jack ("worm screw" and
joints) can also cause injuries: avoid
touching them. If you come into contact
with lubricating grease, clean yourself
thoroughly.
CHANGING A BULB
16)
106) 107) 108)
GENERAL
INSTRUCTIONS
Before changing a bulb check the
contacts for oxidation;
replace blown bulbs with others of
the same type and power;
after replacing a headlight bulb,
always check its alignment;
when a light is not working, check
that the corresponding fuse is intact
before changing the bulb. For the
location of fuses, refer to the paragraph
“If a fuse blows” in this chapter.
IMPORTANT When the weather is cold
or damp or after heavy rain or washing,
the surface of headlights or rear lights,
may steam up and/or form drops of
condensation on the inside. This is a
natural phenomenon due to the
difference in temperature and humidity
between the inside and the outside of
the glass which does not indicate a
fault and does not compromise the
normal operation of lighting devices.
The mist disappears quickly when the
lights are turned on, starting from the
centre of the diffuser, extending
progressively towards the edges.
112
IN AN EMERGENCY

Oddments pocket............34
On-board instruments
display..................58
engine coolant temperature
indicator.................60
fuel level gauge............60
On-board instruments........58
rev counter...............60
Speedometer..............60
Parking...................96
Handbrake...............96
Parking lights................28
Parking sensors..............48
Passenger side front airbag.......90
Passenger side front airbag and
child restraint systems........91
Performance...............160
Plafoniera bagagliaio
sostituzione lampada........119
Plugs (type)................149
Power socket................34
Pre-Fill system (RAB - Ready Alert
Brake)...................43
Pretensioners................86
Load limiters..............86
Protecting the environment.......56
Pulsante TRIP RESET..........66
Radio system...............47
Radio transmitters and mobile
phones................5,48Raising the car..............124
Rear direction indicators........117
Rear fog light................32
Rear fog light/reversing light......118
Rear view mirrors.............20
Internal mirror.............20
Refuelling.................162
Refuelling the car.............54
Rev counter.................60
Rims
dimensions..............157
rims and tyres............155
wheels and tyres...........139
Roof lights..................31
Front roof light.............31
Ruote....................155
Saving fuel................101
SBR system (Seat Belt Reminder) . . .85
Scheduled Servicing Plan.......128
Screen wiper/washer...........29
“Smart washing” function......30
Seat belts..................84
Use ....................84
Seats.....................18
Setup menu.................60
Side lights/brake lights.........117
Side lights/daytime running lights
(DRL)
bulb replacement..........116Side lights/dipped headlights......28
Snow chains...............103
Snow tyres................102
Speedometer................60
Speedometer (speed indicator).....60
Starting the engine.........95,105
Bump starting............105
Jump starting.............105
Steering..................154
Steering lock................18
Steering wheel...............20
Storage compartments..........33
Sun visors..................35
Suspension................153
Symbols...................14
Technical data..............146
The keys...................15
Key with remote control.......15
Key without remote control.....15
Third brake lights
bulb replacement..........118
Towing the car..............125
Attaching the tow hook......125
TPMS (Tyre Pressure Monitoring
System)..................50
Transmission...............151
Trip Computer...............65
Ty r e s
Fix&Go automatic (kit).......106