142
RCZ_en_Chap07_verifications_ed01-2015
PETROL ENGINES
The various caps and covers allow access for checking the levels of the various fluids and for replacing certain components.
1.
Power steering reservoir
.
2.
Screenwash and headlamp wash reservoir
.
3.
Coolant reservoir
.
4. Brake
fluid reservoir.
5.
Battery / Fuses. 6.
Fusebox.
7. Air
filter.
8.
Engine oil dipstick.
9.
Engine oil filler cap.
143
RCZ_en_Chap07_verifications_ed01-2015
DIESEL ENGINE
The various caps and covers allow access for checking the levels of the various fluids, for replacing certain components and for priming the fuel system.
1.
Power steering reservoir
.
2.
Screenwash and headlamp wash reservoir
.
3.
Coolant reservoir
.
4. Brake
fluid reservoir.
5.
Battery / Fuses.
6.
Fusebox. 7. Air
filter.
8.
Engine oil dipstick.
9.
Engine oil filler cap.
10.
Priming pump.
11
.
Bleed screw
.
7/
CHECKS
F0
147
RCZ_en_Chap07_verifications_ed01-2015
dIESEL FUEL A dd ITIVE LEVEL ( dIESEL WITH
P
ARTICLE FILTER )
The additive reservoir low level is indicated by fixed illumination of this warning lamp, accompanied by an audible signal and a
message
that the particle filter additive level is too low.
Topping up
The reservoir must be topped up without delay by a PEUGEOT dealer
or a qualified workshop.
USEd PROdUCTS
Avoid prolonged contact of used oil or fluids with the skin.
Most of these fluids are harmful to health or indeed very corrosive.
Do
not discard used oil or fluids into sewers or onto the ground.
Take
used oil to a PEUGEOT
dealer or a qualified workshop
(France) or to an authorised waste disposal site.
COOLANT LEVEL
The coolant level should be close to the "MAx" mark but
should never exceed it.
When the engine is warm, the temperature of the coolant is regulated
by the fan.
In addition, as the cooling system is pressurised, wait at least one hou\
r
after switching of
f the engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap by two turns to allow the \
pressure to drop. When the pressure has dropped, remove the cap and
top up the level. The cooling fan may start after switching off the engine: take care
with articles and clothing that might be caught by the fan blades.
Fluid specification
The coolant must conform to the manufacturer's recommendations.
SCREENWASH AN d HEA d LAMP WASH FLUI d
In the case of vehicles fitted with headlamp washers, the low fluid
level is indicated by an audible signal and a message in
the instrument panel screen.
T
op up the reservoir when you next stop the vehicle.
Fluid specification
For optimum cleaning and to avoid freezing, this fluid must not be topped up with or replaced with plain water .
In
wintry conditions, the use of an ethyl alcohol or methanol base fluid is
recommended.
7/
CHECKS
