2015 Peugeot RCZ ignition

177
RCZ_en_Chap08_info-pratiques_ed01-2015
CHANGING A FUSE
ACCESS TO THE TOOLS
The extraction tweezer is fitted to the back of the dashboard fusebox cover
.
To gain access to them:
F turn
the screw a quarter of a turn to the left,
F

unclip the cover by pulling at the top right,
F


remove the cover completely and turn it over
,
F remove
the carrier on which is fitted the tweezer.
CHANGING A FUSE
Before changing a fuse, tit is necessary to:
F
identify the cause and correct it,
F


switch of
f all electrical consumers,
F

immobilise the vehicle and switch of
f the ignition,
F

identify the failed fuse using the allocation tables and drawings
presented on the following pages.
T

o replace a fuse, you must:
-

use the special tweezer to extract the fuse from its housing and
check

the condition of its filament,
-

always replace a failed fuse with a fuse of the same rating (same
colour);

a different rating fuse may cause malfunctions (risk of fire).
Good Failed
Tweezer
If the fault recurs soon after changing a fuse, have the electrical
system of your vehicle checked by a PEUGEOT dealer or a
qualified
workshop.
8/
PRACTICAL INFORMATION

179
RCZ_en_Chap08_info-pratiques_ed01-2015
dASHBOARd FUSES
The fusebox is placed in the lower section of the dashboard (left-hand \
side). It consists of two boxes.
Access to the fuses
F Refer to the paragraph "Access to the tools".
Fuse tables
Fuse N° RatingFunctions
F2 30 ALocking and deadlocking earth.
F3 5 AAirbags, active bonnet and pretensioners
control unit.
F4 10 AClutch pedal switch, electrochromatic
rear view mirror, automatic gearbox,
switching and protection unit.
F5 30 AOne-touch electric windows, folding door
mirrors supply.
F7 5 AFront and rear courtesy lamps, map
reading lamps, sun visor lighting, glove
box lighting.
F8 20 AAudio
equipment, audio/telephone,
multifunction

screen, tyre under-inflation
detection, clock.
F9 30 A12 V socket.
F10 15 ASteering mounted controls.
F

11 15 ALow current ignition switch.
F12 15 AInstrument panel, air conditioning,
driver's seat memory unit, rain /
sunshine sensor, airbags.
Box 1
8/
PRACTICAL INFORMATION

185
RCZ_en_Chap08_info-pratiques_ed01-2015
TOWING YOUR VEHICLE
Towing from the front
F On the front bumper , unclip the cover by pressing on the left.
F
Screw the towing eye in fully
.
F

Install the towing arm.
F


Place the gear lever in neutral (position N

for an automatic
gearbox).
Failure to follow this advice could result in damage to certain
components (braking, transmission...) and the absence of
braking assistance the next time the engine is started.
F


Unlock the steering by turning the ignition key one notch and
release the parking brake.
F


Switch on the hazard warning lamps on both vehicles.
F


Move of
f gently and drive slowly and for a short distance only.
Towing from the rear
It is also possible to pull your vehicle from the rear, but only in
exceptional circumstances (vehicle in a parking space, off the road...).
F
On the rear bumper
, unclip the cover by pressing on the left.
F

Screw the towing eye in fully
.
F

Install the towing bar
.
F

Place the gear lever in neutral (position N

for an automatic
gearbox).
F

Switch on the hazard warning lamps on both vehicles.
F


Move of
f very gently to pull the vehicle out.
* Except version with symmetrical twin exhaust tailpipes.
TOWING ANOTHER VEHICLE *
F On the rear bumper, unclip the cover by pressing on the left.
F
Screw the towing eye in fully
.
F

Install the towing bar
.
F

Switch on the hazard warning lamps on both vehicles.
F


Move of
f gently and drive slowly and for a short distance only.
8/
PRACTICAL INFORMATION

202
RCZ_en_Chap10a_BTA_ed01-2015
EMERGENCY OR ASSIST ANCE CALL
In an emergency, press this button for more than
2 seconds. Flashing of the green LED and a voice
message
confirm that the call has been made to the
"PEUGEOT

Connect SOS" centre*.
The

green

LED

remains on (without flashing) when communication is
established. It goes of

f at the end of communication. When the ignition is switched on, the green
LED comes on for 3 seconds indicating that
the system is operating correctly.
Pressing
this button again immediately cancels the request.
The
cancellation is confirmed by a voice message.
Press
this button for more than 2 seconds to request assistance if the vehicle breaks down.
A


voice message confirms that the call has been made**.
Pressing

this

button again immediately cancels the request.
The
green
LED


goes

off.

Cancellation is confirmed by a voice message.
To cancel a call, tell the "PEUGEOT Connect SOS" call centre that the call
was a mistake.
"PEUGEOT Connect SOS" immediately locates your vehicle, starts
communication with you in your language**, and where necessary sends
the appropriate public emergency services**. In countries where the
service is not available, or when the locating service has been expressl\
y
declined, the call sent directly to the emergency services (112) without the
vehicle location.
If an impact is detected by the airbag control unit, and
independently of the deployment of any airbags, an emergency call
is made automatically.
*

Subject to the general conditions for the service available from dealers\

and to technological and technical limitations. If

the orange LED flashes: there is a system
fault.
If the orange LED is on continuously: the
backup battery must be replaced.
In either case, contact a PEUGEOT

dealer.
If you purchased your vehicle outside the PEUGEOT dealer network,
we
invite you to have a dealer check the configuration of these services
and,

if desired, modified to suit your wishes. In a multi-lingual country,
configuration

is possible in the official national language of your choice.
For
technical reasons and in particular to improve the quality of
"PEUGEOT

CONNECT services" services to customers, the manufacturer
reserves the right to carry out updates to the vehicle's on-board telema\
tic
system.
PEUGEOT Connect SOS PEUGEOT Connect Assistance
Operation of the system
** Depending on the geographical cover of "PEUGEOT Connect SOS",
"PEUGEOT Connect Assistance" and the official national language
selected by the owner of the vehicle.



The list of countries covered and PEUGEOT
CONNECT services
services is available from dealers or at www.peugeot.co.uk.

06
227
RCZ_en_Chap10b_RT6-2-8_ed01-2015
USING THE TELEPHONE
Select "Connect" and confirm.
The system of fers to connect the
telephone:
-

in "
Hands-free mode" (telephone
only),
-

in "
Audio" mode (streaming: playing
music
files on the telephone),
-

or "
All" (for selection of both
modes).
Select "OK"
and confirm. Then accept automatic connection on the telephone to allow the
telephone to reconnect automatically every time the vehicle is
started.
The ability of the system to connect in only one mode depends on
the telephone. The two modes may both connect by default. The "Hands-free mode" should be used in preference if
"Streaming" is not desired.
The services available depend on the network, the SIM card and the compa\
tibility of the Bluetooth telephone used. Check the telephone
manual and with your network provider for details of the services availa\
ble to you.
Depending on the type of telephone, the system will ask you to
accept or not the transfer of your contacts.
On return to the vehicle, the last telephone connected
automatically reconnects, within around 30 seconds after
switching on the ignition (Bluetooth activated and visible).
To modify the automatic connection mode, remove the pairing
and pair the telephone again with the desired mode.
Enter
a minimum 4 figure code in the telephone
and

confirm.
Enter the same code in the system,
select "OK" and confirm.
Select the name of the desired
peripheral from the list of devices
detected
then confirm.

08
242
RCZ_en_Chap10b_RT6-2-8_ed01-2015
Insert the CD in the player, insert the USB
memory stick in the USB player or connect the
USB peripheral to the USB port using a suitable
cable (not supplied).
The system builds playlists (in temporary
memory), an operation which can take from
a few seconds to several minutes at the first
connection.
Reduce

the number of non-music files and the
number of folders to reduce the waiting time.
The playlists are updated every time the ignition
is switched of

f or connection of a USB memory
stick. However, the system memorises these
lists
and if they are not modified, the loading
time will be shorter

.
Play starts automatically after a period which
depends on the capacity of the USB memory
stick. Selection of source
The SOURCE button on the steering mounted controls allows a
direct change to the next media source. "C d / C d MP3"
"USB, iPod "
"AUX"
"STREAMING"
"RA
d IO"
Press MUSIC to display the "ME
d IA"
menu.
Select "Following media source " and
confirm.
Repeat the operation as many times as necessary to obtain the
desired media source (except for radio which is accessible either
with SOURCE or RA
d IO).
Sources
MUSIC MEdIA
PLAYERS

05
267
RCZ_en_Chap10c_RD45_ed01_2015
PEUGEOT CONNECT USB
The system puts together playlists (temporary memory) created
over a period which depends on the capacity of the USB device.
The other sources are available during this time.
The playlists are updated each time the ignition is switched off or
each time a USB memory stick is connected.
When connecting for the first time, the classification suggested
is

by folder. When you reconnect, the classification selected
previously is retained.Connect the memory stick to the port, directly or
using

a lead. If the audio equipment is switched
on, the USB source is detected as soon as it
is connected. Play begins automatically after a
delay which depends on the capacity of the USB
memory stick.
The

file formats supported are .mp3 (mpeg1
layer 3 only) and .wma (standard 9 only

,
128 kbits/sec compression).
Certain playlist formats are supported (.m3u, ...)
On reconnection of the previous memory stick
used, play is resumed automatically with the last
track played.
This unit consists of a USB port and an auxiliary
Jack

socket*.

The


audio

files

are

transmitted

from a portable device - digital player or a USB
memory stick - to your PEUGEOT

Connect
Sound (RD5) and heard via the vehicle's
speakers.
USB memory stick or Apple
® player of
generation 5 or later:
-

Use only USB memory sticks formatted
F

AT32 (File Allocation Table),
-

the Apple® player lead is essential,
- navigation
through the file database is also
possible by means of the steering mounted
controls.
Using the PEUGEOT CONNECT USB
Connecting a USB memory stick
Other Apple
® players of earlier generations and
players using the MTP protocol*:
-

play via

j ack- j ack lead only (not supplied),
- navigation
through the file database is from
the portable device. * Depending on vehicle.

06
270
RCZ_en_Chap10c_RD45_ed01_2015
BLUETOOTH
For safety reasons and because they require prolonged attention on the part of the driver, the operations for pairing of the Bluetooth
mobile telephone with the Bluetooth hands-free system of your
audio
equipment must be carried out with the vehicle stationary
and the ignition on.
Press the MENU button.
A

window is displayed with a message that a search is in progress.
Activate the telephone's Bluetooth function
and ensure that it is "visible to all" (telephone
configuration).
In the menu, select:
-

Bluetooth telephone function -
Audio
-

Bluetooth configuration
-

Perform a Bluetooth search The services of

fered depend on the network, the SIM card and the
compatibility of the Bluetooth equipment used.
Consult your telephone's manual and your operator to find out which
services are available to you.
Bluetooth telephoneScreen C
The TELEPHONE menu permits access to the following functions
in particular: Directory*, Call list, Pairing management. The first 4 telephones recognised are displayed in this window.
A virtual keypad is displayed in the
screen: enter a code with at least 4 digits.
Confirm
by pressing OK.
A message that the pairing has been successful appears in the
screen. Select the telephone to be connected from the list. Only one
telephone can be connected at a time.
A message is displayed in the screen of the
telephone chosen. To accept the pairing, enter the
same
code on the telephone, then confirm with OK.
The automatic connection authorised is only active after the
telephone
has been configured.
The directory and the call list can be accessed after the
synchronisation period.
(Available according to model and version)
* If your telephone is fully compatible.
If pairing fails, the number of attempts is not limited.
Go to www.peugeot.co.uk for more information (compatibility,
more help, ...).
Pairing a telephone / First connection