2015 Peugeot RCZ boot

43
RCZ_en_Chap02_ouvertures_ed01-2015
OPERATING FAULT
L
OCKING
THE
VEHICLE WITHOUT
ACTIV
ATING
THE


ALARM
F Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fixed illumination of the indicator lamp
in the button indicates a fault with the system.
Have

it checked by a PEUGEOT

dealer or a qualified workshop.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
F

unlock the vehicle using the key in the driver's door lock,
F


open the door; the alarm is triggered,
F


switch on the ignition; the alarm stops; the indicator lamp in the
button goes of

f.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
flashing
of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched

on, this flashing stops immediately.
This
is indicated by sounding of the siren and flashing of the direction
indicators for thirty seconds.
2 minutes after closing the last door or the boot, the system is activat\
ed
automatically
.
F To
avoid triggering the alarm when entering the vehicle, first press
the remote control unlocking button.
AUTOMATIC ACTIVATION *
* Depending on country of sale.
2/
ACCESS

46
RCZ_en_Chap02_ouvertures_ed01-2015
DOORS
OPENING
From outside
F After unlocking the vehicle completely using the remote control or
the key, take hold of the door handle then pull it.
The window lowers automatically by a few millimetres to permit
opening of the door

.
In freezing conditions, the presence of ice may hinder the automatic
partial opening of the window; remove the ice which may have formed
along the lower seal, located at the base of the window.
When
the selective unlocking is activated, the first press of the
remote control unlocking button permits unlocking of the driver's
door only

.
From inside
F Pull the door control to open the door; this unlocks this vehicle
completely .
The window lowers automatically by a few millimetres to permit
opening of the door

.
With the selective unlocking activated:
-

the driver's door control unlocks the driver's door and the fuel
filler

flap only.
-

the passenger's door control unlocks the passenger's door
and the boot.
The interior door controls do not operate when the vehicle is
deadlocked.
If you leave the door open for more than one minute, the window
rises again.
Pull the handle again to reactivate the system.

47
RCZ_en_Chap02_ouvertures_ed01-2015
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.-

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot
lid and fuel filler flap from inside the vehicle.
Locking
F Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
F Press this button again to unlock the vehicle.
The red indicator lamp on the button goes of f.
Locking / deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp flashes and the button is inactive.
F

With normal locking, pull on the interior door control lever to
unlock the vehicle.
F


With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
-

first

lock

the

vehicle

using

the

remote

control

or

the

key,
-

avoid spraying the upper part of the windows,
-


keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly:
Be aware of the risk of pinching when the window rises
automatically on closing the door

.
-

when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
2/
ACCESS

48
RCZ_en_Chap02_ouvertures_ed01-2015
Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).
Activation / deactivation
You can activate or deactivate this function.
F
With the ignition on, press the button for more than two seconds.
A


confirmation message appears in the screen.
EMERGENCY LOCKING
To lock or unlock the doors mechanically in the event of a central
locking
system failure or flat battery.
Locking the driver's door
F Insert the key in the lock, then turn it to the right.
Unlocking the driver's door
F Insert the key in the lock, then turn it to the left.
Locking the passenger door
F Using the key, remove the black cap on the edge of the door.
F
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door

.
F Remove
the key and refit the cap.
Unlocking the passenger door
F Pull the interior door opening control.
ANTI-INTRUSION SECURITY
This function permits automatic and simultaneous locking of the doors,
boot lid and fuel filler flap as soon as the vehicle speed exceeds 6 mph
(10 km/h).
Operation
If one of the doors is open, the automatic central locking does not take\

place.
If the boot lid is open, the automatic central locking of the doors is
active.

49
RCZ_en_Chap02_ouvertures_ed01-2015
BOOT
OPENING
F Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
F

Lift the boot lid.
This


action
also unlocks the doors and the fuel filler flap.
Using the manual control; vehicle unlocked
F Press the opening control above the number plate.
F
Lift the boot lid.
CLOSING
F Lower the boot lid using one of the interior grab handles.
F
If necessary
, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly: -

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.
Using the remote control
Emergency locking
If the central locking system fails (flat battery), you are advised to disconnect the battery.
-

when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Never grasp the boot lid by the active spoiler
.
2/
ACCESS

58
RCZ_en_Chap03_confort_ed01-2015
ACCESS TO THE REAR SEATS
REAR SEATS
Two-seat bench with one-piece fixed seat cushion and one-piece folding backrest.
The
rear seat headrests are fixed.
FOLdING dOWN THE REAR BACKREST
RETURNING THE REAR BACKREST TO THE UPRIGHT POSITION
When returning the backrest to the upright position, ensure that it is
locked securely to assure your safety. F
Open the boot.
F

Pull the backrest release handle, located under the shelf.
When transporting long objects, do not place a load of more
than 30 kg on the rear of the backrest.
Do not place rough objects on the rear of the backrest which
could damage it.
F

Check

that

the

front

seat

has

been

moved

forward

sufficiently.
F

Pull the control upwards to fold the backrest; this control does not
release the seat cushion.
When put back in place, the backrest returns to its initial position.
The backrest can be folded down to increase the boot storage space.
The backrest release control is located in the boot.
F

Check

that

the

front

seats

have

been

moved

forward

sufficiently.
F

Check that nothing has been left on the rear seats.
F


Store the seat belt buckles on their respective securing points
located between the headrests. F

Fold the backrest down onto the seat cushion.

60
RCZ_en_Chap03_confort_ed01-2015
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
F
T
o obtain an even air distribution, take care not to obstruct
the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
F

Do not cover the sunshine sensor
, located on the dashboard;
this is used for regulation of the air conditioning system.
F

Operate the air conditioning system for at least 5 to
10

minutes, once or twice a month to keep it in good working
order.
F Ensure
that the passenger compartment filter is in good
condition

and have the filter elements replaced regularly

(refer to the "Checks" section).
W

e recommend the use of a combined passenger
compartment
filter.
Thanks
to its special active additive,
it

contributes to the purification of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
F


T
o ensure correct operation of the air conditioning system,
you are also advised to refer to the warranty and maintenance
record for information on when it should be checked.
F

If the system does not produce cold air
, switch it off and
contact
a PEUGEOT

dealer or a qualified workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance. The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal. If after an extended stop in sunshine, the interior temperature is
very
high, first ventilate the cabin for a few moments.
Put
the air flow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer

.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING

73
RCZ_en_Chap03_confort_ed01-2015
BOOT FITTINGS
1. Stowing rings
2.
Storage net
3.


Storage well

(see details on following page)
3/
EASE OF USE and COMFORT