
4
208_en_Chap01_vue-ensemble_ed01-2015
Exterior view
Remote control key 11-17, 32
-   opening / closing
-   anti-theft protection
-   guide-me-home lighting
-  starting
-  switching off
-  battery
Boot 28, 31
-   opening / closing
-   emergency release
Reversing camera   121
Temporary puncture repair kit  203-207
Wipers 83 - 86
Changing a wiper blade
 86
Demisting - Defrosting  72-73
Changing bulbs   158-160
-   rear lamps
- 3
rd brake lamp
-  number plate lamps
-  foglamp
Fuel tank, misfuel prevention  180-183
Running out of Diesel fuel  184
Sunroof blind 
26
Roof bars  164
Accessories  169-171
Advice on care  172
Road holding   13 6 -13 8
Snow chains  171
Under-inflation  200-202
Tyre pressures  206 -207, 219
Spare wheel   208-214
- tools
-  removing / refitting
Lighting controls
 145-151
LED lamps  150
Daytime running lamps  150
Headlamp beam adjustment  152
Cornering lighting   153
Changing bulbs   154-158
-  front lamps
-  foglamps
-   direction indicator repeaters
D o o r  m i r r o r s   11 0 -111
Doors  16 -18, 31
-   opening / closing
-  central locking
-   emergency control
Courtesy lighting  25
Alarm  29-30
Electric windows  81- 82 Par k A ssist
  12 2-125
Parking sensors   119-120
Towbar   165 -166
Towing   167-168 
Over view  

46
208_en_Chap03_Indicateurs_ed01-2015
Warning / indicator lampStateCause Action / Observations
Engine oil 
pressure fixed.
There is a fault with the engine 
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a PEUGEOT 
dealer or a qualified workshop.
Battery charge fixed. The battery charging circuit has a 
fault (dirty or loose terminals, slack or 
cut alternator belt, ...). The warning lamp should go off when the engine is 
started.
If it does not go off, contact a PEUGEOT dealer or a 
qualified workshop.
Low fuel level
fixed with the needle 
in the red zone. There remains approximately 5 litres 
of fuel in the tank.
At this point, you begin to use the fuel 
reserve. Refuel as soon as possible to avoid running out of 
fuel.
This warning lamp will come on every time the ignition 
is switched on, until a sufficient addition of fuel is 
made.
Fuel tank capacity: approximately 50 litres
.
Never continue to drive until you run out of fuel, as 
this could damage the emission control and injection 
systems.
flashing with the 
needle in the red 
zone.
There remains very little fuel in the 
tank.
Under-inflation fixed. The pressure in one or more wheels 
is too low. Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the 
tyres are cold.
+ flashing then fixed, 
accompanied by the 
Service warning lamp.The tyre pressure monitoring system 
has a fault or no sensor is detected 
on one of the wheels. Under-inflation detection is not assured.
Have the system checked by a PEUGEOT dealer or a 
qualified workshop. 
Indicators  

137
208_en_Chap05_conduite_ed01-2015
Anti-lock braking system 
(ABS) and electronic brake 
force distribution (EBFD)
Operation
In emergency braking, press 
very firmly without releasing the 
pressure. When changing wheels (tyres and rims), 
make sure that these are approved for 
your vehicle.
Normal operation of the ABS may make 
itself felt by slight vibrations of the brake 
pedal.
The fixed illumination of this warning 
lamp indicates that there is a fault 
with the ABS.
When this warning lamp comes on, 
coupled with the STOP
 and ABS 
warning lamps, accompanied by 
The vehicle retains conventional braking. Drive 
carefully at moderate speed.
an audible signal and a message, it indicates 
that there is a fault with the electronic brake 
force distribution (EBFD).
You must stop as soon as it is safe to do so.
In both cases, have the system checked by a 
PEUGEOT dealer or a qualified workshop as 
soon as possible.
5 
Driving  

143
208_en_Chap05_conduite_ed01-2015
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in the 
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof 
bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations on 
maintenance
Check the tyre pressures regularly, when cold, referring to the label in 
the door aperture, driver's side.
Carry out this check in particular:
- before a long journey,
-  at each change of season,
-  after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle serviced regularly (engine oil, oil filter, air filter, 
passenger compartment filter...) and observe the schedule of 
operations recommended in the manufacturer's service schedule.
With a BlueHDi Diesel engine, if the SCR system is faulty your vehicle 
becomes polluting; go to a PEUGEOT dealer or a qualified workshop 
without delay to have the emissions of nitrous oxides brought back to 
the legal level.
When refuelling, do not continue after the third cut-off of the nozzle to 
avoid any over flow.
At the wheel of your new vehicle, it is only after the first 1 800 miles  
(3 000 kilometres) that you will see the fuel consumption settle down to 
a consistent average.
5 
Driving  

166
208_en_Chap07_ Amenagements_ed01-2015
Driving advice
Distribution of loads
F Distribute the load in the trailer so that the 
heaviest items are as close as possible to 
the axle and the nose weight approaches 
the maximum permitted without 
exceeding  it.
Air density decreases with altitude, thus 
reducing engine performance. Above 
1 000 metres, the maximum towed load must 
be reduced by 10 % for every 1 000 metres of 
altitude.
Side wind
F  Take into account the increased sensitivity 
to side wind.
Cooling
Towing a trailer on a slope increases the 
temperature of the coolant.
As the fan is electrically controlled, its cooling 
capacity is not dependent on the engine speed.
F To lower the engine speed, reduce your 
speed.
The maximum towed load on a long incline 
depends on the gradient and the ambient 
temperature.
In all cases, keep a check on the coolant 
temperature.
F If the warning lamp and the 
STOP  warning lamp come on, 
stop the vehicle and switch off 
the engine as soon as possible.
Braking
Towing a trailer increases the braking distance.
To avoid overheating of the brakes on a long 
mountain type of descent, the use of engine 
braking is recommended.
Ty r e s
F  Check the tyre pressures of the towing 
vehicle and of the trailer, observing the 
recommended pressures.
Lighting
F Check the electrical lighting and signalling 
on the trailer.
Refer to the "Technical data" section for details 
of the weights and towed loads which apply to 
your vehicle. 
Fittings  

200
208_en_Chap08_Informations-pratiques_ed01-2015
Under-inflation
The under-inflation detection system 
does not replace the need for vigilance 
on the part of the driver.
This system does not avoid the need to 
check the tyre pressures (including the 
spare wheel) every month as well as 
before a long journey.
Driving with under-inflated tyres impairs 
road holding, extends braking distances 
and causes premature tyre wear, 
particularly under arduous condition 
(high loading, high speed, long journey).The inflation pressures defined for 
your vehicle can be found on the tyre 
pressure label.
See the "Identification markings" 
section.
Tyre pressures should be checked 
when the tyres are "cold" (vehicle 
stopped for 1 hour or after a journey of 
less than 6 miles (10 km) at moderate 
speeds).
Other wise (when hot), add 0.3 bar to 
the pressures shown on the label.
Driving with under-inflated tyres 
increases fuel consumption.
Under-inflation detection system which 
automatically checks the pressures of the tyres 
while driving.
The system monitors the pressures in the four 
tyres, once the vehicle is moving.
It compares the information given by the four 
wheel speed sensors with reference values, 
which must be reinitialised ever y time the 
tyre pressures are adjusted or a wheel 
changed
.
The system triggers an alert as soon as it 
detects a drop in the inflation pressure of one 
or more tyres. 
Practical information  

201
208_en_Chap08_Informations-pratiques_ed01-2015
Under-inflation alert
The loss of pressure detected does not 
always cause visible bulging of the tyre. 
Do not satisfy yourself with just a visual 
check.This is given by fixed illumination of 
this warning lamp, accompanied by 
an audible signal and, depending on 
equipment, the display of a message.
F  Reduce speed immediately, avoid 
excessive steering movements and sudden 
braking
F  Stop the vehicle as soon as it is safe  
to do so. F 
In the event of a puncture, use the 
temporary puncture repair kit or the spare 
wheel (depending on equipment),
or
F  if you have a compressor, such as the one 
in the temporary puncture repair kit, check 
the pressures of the four tyres when cold,
or
F  if it is not possible to make this check 
immediately, drive carefully at reduced 
speed. The alert is maintained until the system 
is reinitialised.
The under-inflation alert is only 
dependable if the system has been 
reinitialised with all four tyres inflated to 
the correct pressures.
Snow chains
The system does not have to be 
reinitialised after fitting or removing 
snow chains.
8 
Practical information  

202
208_en_Chap08_Informations-pratiques_ed01-2015
Reinitialising
It is necessary to reinitialise the system every 
time one or more tyre pressure is adjusted, and 
after changing one or more wheels.
A label attached to the middle pillar, driver's 
side, gives a reminder of this.Before reinitialising the system, ensure 
that the pressures of the four tyres are 
correct for the use of the vehicle and in 
line with the recommendations on the 
tyre pressure label.
The under-inflation detection system 
does not give a warning if a pressure is 
incorrect at the time of reinitialisation. F 
With the ignition on and the 
vehicle stationary, press this 
button for about 3 seconds then 
release it, an audible signal 
confirms the reinitialisation.
The new pressure settings registered 
are considered to be reference values 
by the system.
Reinitialisation of the system is done with the 
ignition on and the vehicle stationary.
F Press " Under-inflation 
initialisation ".
From the "
Driving assistance " menu 
of the touch screen:
F  Confirm the instruction by pressing " Ye s", 
an audible signal and a message confirm 
the reinitialisation.
Operating fault
The flashing and then fixed illumination of the 
under-inflation warning lamp accompanied 
by illumination of the Service warning lamp 
indicates a fault with the system.
In this case, under-inflation monitoring of the 
tyres is no longer assured.
Have the system checked by a PEUGEOT 
dealer or a qualified workshop.
Touch screen Screen A
Before doing anything to the system, 
the pressures of the four tyres must be 
checked and the system reinitialised. 
Practical information