2015 LEXUS RX450h light

6724-3. Do-it-yourself maintenance
■ How to initialize the tire pressure warning system
Park the vehicle in a safe place and turn the “POWER” switch off. Initialization cannot be performed while the vehicle is moving.
Adjust the tire inflation pressure to the specified co ld tire inflation
pressure level. (  P. 8 0 7 )Make sure to adjust the tire pressure to the specified cold tire inflation
pressure level. The tire pressure warning system will operate based on
this pressure level.
Turn the “POWER” switch to ON mode.
Press and hold the tire pressure
warning reset switch until the tire
pressure warning light blinks
slowly 3 times.
Wait for a few minutes with th e “POWER” switch on and then
turn the “POWER” switch off.STEP 1
STEP 2
STEP 3
STEP 4
STEP 5

6734-3. Do-it-yourself maintenance
4
Maintenance and care Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique
ID code. When replacing a tire pressure warning valve and transmitter, it
is necessary to register the ID code. Ha ve the ID code registered by your
Lexus dealer. ■
When to replace your vehicle’s tires
Tires should be replaced if: ●
You have tire damage such as cuts, splits, cracks deep enough to expose the
fabric, and bulges indicating internal damage.●
A tire goes flat repeatedly or cannot be properly repaired due to the size or
location of a cut or other damage.
If you are not sure, consult with your Lexus dealer.■
Replacing tires and wheels
If the ID code of the tire pressure warn ing valve and transmitter is not registered,
the tire pressure warning system will not work properly. After driving for about 20
minutes, the tire pressure warning light blin ks for 1 minute and stays on to indicate a
system malfunction.■
Tire life
Any tire over 6 years old must be checked by a qualified technician even if it has sel-
dom or never been used or damage is not obvious.■
If the tread on snow tires wears down below 0.16 in. (4 mm)
The effectiveness of the tires as snow tires is lost.■
Routine tire inflation pressure checks
The tire pressure warning system does not replace routine tire inflation pressure
checks. Make sure to check tire inflation pressure as part of your routine of daily
vehicle checks.

6754-3. Do-it-yourself maintenance
4
Maintenance and care ■
The initialization operation ●
Make sure to carry out initialization af ter adjusting the tire inflation pressure.
Also, make sure the tires are cold before carrying out initialization or tire infla-
tion pressure adjustment.●
If you have accidentally turned the “POWER ” switch off during initialization, it is
not necessary to press the reset switch again as initialization will restart auto-
matically when the “POWER” switch has been turned to ON mode for the next
time.●
If you accidentally press the reset switch when initialization is not necessary,
adjust the tire inflation pressure to th e specified level when the tires are cold,
and conduct initialization again.■
When the initialization of the tire pressure warning system has failed
Initialization can be completed in a few minutes. However, in the following cases,
the settings have not been recorded and the system will not operate properly. If
repeated attempts to record tire inflation pressure settings are unsuccessful, have
the vehicle inspected by your Lexus dealer. ●
When operating the tire pressure warnin g reset switch, the tire pressure warn-
ing light does not blink 3 times. ●
After carrying out the initialization proc edure, the tire pressure warning light
blinks for 1 minute then stays on after driving for 20 minutes.

6774-3. Do-it-yourself maintenance
4
Maintenance and care CAUTION■
Tire pressure warning system operation
The tire pressure warning system may not provide warning immediately if a tire
bursts or if sudden air leakage occurs.■
When inspecting or replacing tires
Observe the following precautions to prevent accidents. Failure to do so may cause
damage to parts of the drive train, as we ll as dangerous handling characteristics,
which may lead to an accident resu lting in death or serious injury.●
Do not mix tires of different makes, mode ls or tread patterns. Also, do not mix
tires of remarkably different treadwear.●
Do not use tire sizes other th an those recommended by Lexus.●
Do not mix differently constructed tires (radial, bias-belted or bias-ply tires).●
Do not mix summer, all season and snow tires.●
Do not use tires that have been used on another vehicle.
Do not use tires if you do not know how they were used previously.●
Do not tow if your vehicle has a compact spare tire installed.■
When initializing the tire pressure warning system
Do not push the tire pressure warning reset switch without first adjusting the tire
inflation pressure to the specified level. Otherwise, the tire pressure warning light
may not come on even if the tire inflation pressure is low, or it may come on when
the tire inflation pressure is actually normal.

6954-3. Do-it-yourself maintenance
4
Maintenance and care ■ Engine compartment (type B fuse box)
Fuse Ampere Circuit1
RR DEF 50 A Rear window defogger2
AIR SUS 50 A3
HEATER 50 A Air conditioning system4
ABS NO. 1 50 A Electronically controlled brake system5
RDI FAN NO. 1 40 A Electric cooling fans6
RDI FAN NO. 2 40 A Electric cooling fans7
H-LP CLN 30 A Headlight cleaner8
PBD 30 A Power back door9
HV R/B NO. 1 30 A PCU, IGCT NO. 2, IGCT NO. 3,
INV W/P
10
PD 50 A A/F, H-LP RH HI, H-LP LH LO, H-LP
RH LO, H-LP LH HI, HORN, S-
HORN
11
ABS NO. 2 50 A Electronically controlled brake system
12
HV R/B NO. 2 80 A ABS MAIN NO. 1, ABS MAIN NO.
2, A/C W/P, BATT FAN, OIL PMP

6974-3. Do-it-yourself maintenance
4
Maintenance and care 24
AM2 7. 5 A Starter system25
ECU-B NO. 2 7. 5 A Air conditioning system, front passen-
ger occupant classification system,
audio system, vehicle dynamics inte-
grated management, power windows,
electric power steering system26
MAYDAY/TEL 7. 5 A MAYDAY/TEL27
IMMOBI 7. 5 A IMMOBI28
ABS MAIN
NO. 3 15 A Brake system29
DRL 7. 5 A Daytime running light system30
IGN 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem31
DOME 10 A Vanity mirror lights, luggage compart-
ment lights, interior lights, personal
lights, door courtesy lights, footwell
lights, scuff lights
32
ECU-B NO. 1 10 A Tilt and telescopic steering, multiplex
communication system, meters and
gauges, driving position memory,
power seats, power back door, head-
up display, starter system, outside rear
view mirror, steering sensor, garage
door opener
33
EFI NO. 1 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem
34
WIP-S 7. 5 A Cruise controlFuse Ampere Circuit

6984-3. Do-it-yourself maintenance
35
ECU-IG1 NO. 4 10 A Air conditioning system, rear window
defogger, electronically controlled
brake system, electric cooling fans36
BK/UP LP 7. 5 A Back-up lights37
ECU-IG1 NO. 5 15 A Air conditioning system38
ECU-IG1 NO. 6 10 A Head light cleaner, cruise control, air
conditioning system, Blind Spot Moni-
tor39
EFI NO. 2 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem40
F/ P M P 15 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem41
DEICER 25 A Windshield wipers and washer
42
STOP 7. 5 A Vehicle Proximity Notification System,
vehicle dynamics integrated manage-
ment, stop lights, multiport fuel injec-
tion system/sequential multiport fuel
injection system, shift lock control sys-
tem, starter system, cruise control43
TOW I N G BAT T 20 A44
TOW I N G 30 A Trailer lights45
FILTER 10 A
46
IG1 MAIN 30 A ECU-IG1 NO. 6, BK/UP LP, ECU-
IG1 NO. 5, ECU-IG1 NO. 4
47
H-LP RH HI 15 A Right-hand headlight (high beam)
48
H-LP LH HI 15 A Left-hand headlight (high beam)Fuse Ampere Circuit

6994-3. Do-it-yourself maintenance
4
Maintenance and care
■ Engine compartment (type C fuse box) 49
BIXENON 10 A50
H-LP RH LO 15 A Right-hand headlight (low beam)51
H-LP LH LO 15 A Left-hand headlight (low beam)52
HORN 10 A Horn53
A/F 20 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem54
S-HORN 7. 5 A S-HORN
Fuse Ampere Circuit1
ABS MAIN NO. 1 10 A Brake system
2
ABS MAIN
NO. 2 10 A Brake system
3
BATT FAN 15 A Battery cooling fan
4
OIL PMP 10 A Hybrid system
5
A/C W/P 10 A Air conditioning systemFuse Ampere Circuit