234
C4-2_en_Chap11_info-pratique_ed01-2015
C4-2_en_Chap11_info-pratique_ed01-2015
Changing a wheel
Access to the tools
The tools are installed in the boot under the
f l o o r.
To gain access to them:
F
o
pen the boot,
F
r
aise the floor,
F
s
ecure it by hooking its cord on the hook
o
n the rear shelf support,
F
w
ith a standard size spare wheel, unclip
and
remove the box in the middle of the
w
heel containing the tools,
or
F
w
ith a "space-saver" spare wheel; lift the
w
heel at the rear towards you for access to
the
storage box containing the tools.
List of tools
All of these tools are specific to your vehicle. Do not use them for other purposes.
1.
W
heelbrace.
F
or removing the wheel trim and the wheel
f
ixing
bol
ts.
2.
J
ack with integral handle.
F
or raising the vehicle.
3.
B
olt cover removal tool.
F
or removing the bolt head protectors on
a
lloy wheels.
4.
S
ocket for the security bolts (located in the
g
love box).
F
or adapting the wheelbrace to the special
"s
ecurity"
b
olts.
5.
C
hock (with ETG6 electronic gearbox
v
e r s i o n).
Wheel with trim
When removing the wheel , detach the trim first using the wheelbrace 1 pulling at the valve p
assage hole.
When refitting the wheel ,
refit the trim starting by placing its notch facing the valve and
p
ress around its edge with the palm of your hand.
Procedure
for
changing
a
faulty
wheel
for
the
spare
wheel
using the tools provided with the vehicle.
Practical information
237
C4-2_en_Chap11_info-pratique_ed01-2015
C4-2_en_Chap11_info-pratique_ed01-2015
Removing a wheel
* position R for an electronic gearbox; P for an
automatic gearbox.
List of operations
F Remove the chromed bolt cover from each o
f the bolts using the tool 3 (according to
e
quipment).
F
F
it the security socket 4 on the
wheelbrace
1 to slacken the security bolt.
F
S
lacken the other bolts using the
w
heelbrace 1
o
n l y.
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level,
s
table and non-slippery ground.
Apply
the parking brake unless it has
b
een programmed to automatic mode,
s
witch off the ignition and engage first
g
ear* to lock the wheels.
Check
that the braking warning lamps
i
n the instrument panel are on (not
f
lashing).
The
occupants must get out of the
v
ehicle and wait where they are safe.
If
necessary, place a chock under the
w
heel diagonally opposite the wheel to
be c
hanged.
Never
go underneath a vehicle raised
u
sing a jack; use an axle stand.
11
Practical information
258
C4-2_en_Chap11_info-pratique_ed01-2015
C4-2_en_Chap11_info-pratique_ed01-2015
Protect your eyes and face before
handling the battery.
All
operations on the battery must be
c
arried out in a well ventilated area and
away
from naked flames and sources
o
f sparks, so as to avoid the risk of
e
xplosion or fire.
Do
not try to charge a frozen battery;
t
he battery must first be thawed out to
a
void the risk of explosion. If the battery
h
as been frozen, before charging have
i
t checked by a CITROËN dealer or a
q
ualified workshop who will check that
t
he internal components have not been
d
amaged and the casing is not cracked,
w
hich could cause a leak of toxic and
c
orrosive acid.
do n
ot reverse the polarity and use only
a
12 V charger.
Do
not disconnect the terminals while
t
he engine is running.
Do
not charge the batteries without
d
isconnecting the terminals first.
Wash
your hands after wards.do n ot push the vehicle to start the
engine if you have an electronic or
a
utomatic gearbox.
Some
functions
are
not
available
if
the
b
attery
is
not
sufficiently
charged.
It is advisable to disconnect the battery if
the
vehicle
is
to
be
left
unused
for
more
t
han
one
month.
The batteries contain harmful substances s uch as sulphuric acid and lead. They m
ust be disposed of in accordance
w
ith regulations and must not, in any
c
ircumstances, be discarded with household
w
aste.
Take
used remote control batteries and
v
ehicle batteries to a special collection point.
Practical information
263
C4-2_en_Chap11_info-pratique_ed01-2015
C4-2_en_Chap11_info-pratique_ed01-2015
Towing the vehicle
The towing eye is installed in the boot under the floor.
To
gain access to it:
F
o
pen the boot,
F
r
aise the floor,
F
s
ecure it by hooking its cord on the hook
o
n the rear parcel shelf
s
upport,
F
r
emove the towing eye from the holder.
Access to the tools General recommendations
In the following cases, you must always call o
n a professional recovery service:
-
v
ehicle broken down on a motor way or
f
ast road,
-
f
our-wheel drive vehicle,
-
w
hen it is not possible to put the
gearbox
into neutral, unlock the
s
teering, or release the parking brake,
-
t
owing with only two wheels on the
g
round,
-
w
here there is no approved towing arm
a
vailable...
Procedure
for
having
your
vehicle
towed
or
for
towing
another
vehicle
using
a
removable
towing
ey
e.
Observe
the
legislation
in
force
in
your
c
o unt r y.
Ensure
that
the
weight
of
the
towing
vehicle
i
s
higher
than
that
of
the
towed
vehicle.
The
driver
must
remain
at
the
wheel
of
the
t
owed
vehicle
and
must
have
a
valid
driving
l
icence.
When
towing
a
vehicle
with
all
four
wheels
o
n
the
ground,
always
use
an
approved
t
owing
arm;
rope
and
straps
are
prohibited.
The
towing
vehicle
must
move
off
gently.
When
towing
a
vehicle
with
the
engine
off,
t
here
is
no
longer
any
power
assistance
for
b
raking
or
steering.
11
Practical information
264
C4-2_en_Chap11_info-pratique_ed01-2015
C4-2_en_Chap11_info-pratique_ed01-2015
F On the front bumper, unclip the cover by p
ressing at the bottom.
F
S
crew the towing eye in fully.
F
I
nstall the towing bar.
Towing your vehicle
F On the rear bumper, unclip the cover b y p
ressing at the bottom.
F
S
crew the towing eye in fully.
F
I
nstall the towing bar.
F
S
witch on the hazard warning lamps on
b
oth vehicles.
F
M
ove off gently, drive slowly and for a short
di
stance.
Towing another vehicle
F Unlock the steering by turning the key i
n the ignition one notch and release the
par
king
b
rake.
F
S
witch on the hazard warning lamps on
b
oth vehicles.
F
M
ove off gently, drive slowly and for a short
di
stance.F
P
lace the gear lever in neutral
(
position
N
on an electronic or
automatic gearbox).
F
ailure to observe this instruction
could result in damage to
c
ertain components (braking,
t
ransmission...) and
the absence of braking assistance
t
he next time the engine is started.
Practical information
275
C4-2_en_Chap12_caracteristique_ed01-2015
C4-2_en_Chap12_caracteristique_ed01-2015
* The maximum power corresponds to the value type-approved on a test bed, under conditions defined in European legislation (Directive 1999/99/EC).
Petrol engines and gearboxes
.../1: model fitted with low rolling resistance tyres.
.../2: model
fitted with very low rolling resistance tyres.
Petrol engine
VTi 95Puretech 110 V Ti 120
Gearbox Manual
(5 - speed) Manual
(5 - speed) Manual
(5 - speed) Automatic
(4 - speed)
Model code:
NC... 8FR0HNZ6
HNZ6/1
HNZ6/2 5FS0
5FS9
5FS9/D
Cubic capacity (cc)
1 397
1 199
1 598
Bore x stroke (mm)
77 x 72.5
75 x 90.5
77 x 85.8
Max power*: EU standard (kW)
7081 88
Max power engine speed (rpm)
6 000
5 500 6 000
Max torque: EU standard (Nm)
13 5205 160
Max torque engine speed (rpm)
4 0001 500 4 250
Fuel UnleadedUnleaded Unleaded
Catalytic converter Ye sYe s Ye s
Engine oil capacity (in litres) 4.253.5 4.25
12
Technical data
276
C4-2_en_Chap12_caracteristique_ed01-2015
C4-2_en_Chap12_caracteristique_ed01-2015
* The maximum power corresponds to the value type-approved on a test bed, under conditions defined in European legislation (Directive 1999/99/EC).
. ../S:
model fitted with Stop & Start.
.../1: model
fitted with low rolling resistance tyres.
.../2:
model fitted with very low rolling resistance tyres.
Petrol engine
Puretech 130 S&STHP 155
Gearbox Manual
(6- speed) EAT6 Automatic
(6- speed) ETG6 Electronic
(6- speed)
Model code:
NC... HNYM/S
HNYM/1S HNY T/S
HNY T/1S
HNY T/2S 5FV8/P
Cubic capacity (cc)
1 199
1 598
Bore x stroke (mm)
70 x 90.5
77 x 85.8
Max power*: EU standard (kW)
96115
Max power engine speed (rpm)
5 5006 000
Max torque: EU standard (Nm)
230240
Max torque engine speed (rpm)
1 750
1 400
Fuel UnleadedUnleaded
Catalytic converter Ye sYe s
Engine oil capacity (in litres) 3.54,25
Technical data
277
C4-2_en_Chap12_caracteristique_ed01-2015
C4-2_en_Chap12_caracteristique_ed01-2015
* The kerb weight is equal to the unladen weight + driver (75 kg).
* * T he weight of the braked trailer can be increased, within the GTW limit, if the GV W of the towing vehicle is reduced by an equal amount.
Warning:
towing using a lightly loaded towing vehicle may have an adverse effect on its road holding.
Petrol weights and towed loads (in kg)
The GTW and towed load values indicated are valid up to a maximum altitude of 1 000 metres; the towed load mentioned must be reduced by 10 % for each additional 1 000 metres of altitude.
When
towing, the maximum authorised speed is reduced (comply with the legislation in force in your country).
High
ambient temperatures may result in a reduction in the per formance of the vehicle to protect the engine; if the ambient temperature is above 37 °C,
l
imit the towed load.
Petrol engine
VTi 95Puretech 110 V Ti 120
Gearbox Manual
(5 - speed) Manual
(5 - speed) Manual
(5 - speed) Automatic
(4 - speed)
Model code:
NC... 8FR0HNZ6
HNZ6/1 -/2 5FS05FS9
5FS9/D
-
U
nladen weight
1 2001 200 1 205 1 270
-
K
erb weight*
1 275
1 275
1 280
1 345
-
G
ross vehicle weight (GV W)
1 720
1 770
1 765
1 755
-
G
ross train weight (GTW)
o
n a 12 % gradient
2 920
2 970
3 065
3 055
-
B
raked trailer (within the GTW limit)
o
n a 12 % gradient
1 200
1 2001 300
1 300
-
B
raked trailer** (with load transfer within the
G
TW limit)
1 450
1 4501 550 1 550
-
U
nbraked trailer
635635640 670
-
R
ecommended nose weight
75757575
12
Technical data