2014 Peugeot RCZ dashboard

30
Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the
corresponding system has come into operation.
It may be accompanied by an audible signal.
Depending on your version of instrument panel, illumination of the
indicator lamp may also be accompanied by:
- a symbol in the central instrument panel screen and a message in the multifunction screen,
or
- a symbol and a message in the central instrument panel screen.
Warning lamp is on Cause Action / Observations
Left-hand
direction
indicato r fl ashing with
buzzer.
The lighting stalk is pushed
down.

Right-hand direction
indicator fl ashing with
buzzer. The lighting stalk is pushed up.
Hazard warning
lamps fl ashing with
audible signal. The hazard warning lamps
switch, located on the dashboard,
has been operated. The left-hand and right-hand direction indicators and their
associated indicator lamps fl ash simultaneously.
Sidelamps fi xed. The lighting stalk is in the
"Sidelamps" position or the
"AUTO" position with low light.
Dipped beam
headlamps fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position or in the "AUTO" position
in conditions of low light.
Main beam
headlamps fi xed. The lighting stalk is pulled
towards you. Pull the stalk again to return to dipped beam
headlamps.

1/
MONITORING
Warning lamp is on Cause Action / Observations
Rear foglamp fi xed. The rear foglamp is switched on. Turn the ring on the stalk rearwards to switch off the rear
foglamp.
Diesel engine
pre-heating fi xed. The ignition switch is at the
2nd position (ignition on). Wait until the warning lamp has switched off before starting.
The duration for which the warning lamp is on is
determined by the climatic conditions.
Parking
brake
fi xed. The parking brake is applied or
not properly released. Release the parking brake to switch off the warning lamp,
keeping your foot on the brake pedal.
Observe the safety recommendations.
For further information on the parking brake, refer to the
"Parking brake" section.
Passenger's
front airbag fi xed on the
seat belt and
passenger's front
airbag warning
lamps display. The control switch, located on
the passenger's side of the
dashboard, has been placed in
the
"ON" position.
The passenger's front airbag is
activated.
In this case, do not install a
"rearward facing" child seat. While you do not have a rearward facing child seat fi tted
to the front passenger seat, it is recommended that the
passenger's front airbag be activated.
On the other hand, before fi tting a rearward facing child
seat, you must turn the control switch to the
"OFF"
position.

32
Deactivation warning lamps
If one of the following warning lamps comes on, this confi rms that the
corresponding system has been switched off intentionally.
It is accompanied by an audible signal and a message on the screen.
Depending on your version of instrument panel, illumination of the
deactivation lamp is also accompanied by:
- a symbol in the central instrument panel screen and a message in the multifunction screen,
or
- a symbol and a message in the central instrument panel screen.
Warning lamp is on Cause Action / Observations
Passenger's
front airbag fi xed, in the seat
belt and front
passenger's
airbag warning
lamps display. The control switch, located
on the passenger's end of
the dashboard, is set to the
OFF
position.
The passenger's front airbag is
deactivated.
You can install a "rearward
facing" child seat on the front
seat. Before installing a "rearward facing" child seat on the front
seat, it is
essential to deactivate the passenger's front
airbag.
On the other hand, where no "rearward facing" child seat is
present, it is recommended that the airbag be reactivated:
set the control to the ON position.

38
LIGHTING DIMMER
Permits manual adjustment of the brightness of the instruments and
controls to suit the ambient light level. Only operates when the vehicle\

lighting is on, with the exception of the daytime running lamps.
Activation
 Press the button to change the brightness of the instruments and controls.
 When the lighting reaches the minimum setting, release the button, then press again to increase it.
or
 When the lighting reaches the maximum setting, release the button, then press again to reduce it.
 When the lighting reaches the level of brightness required, release the button.
Deactivation
When the vehicle lighting is off, or in day mode on vehicles fi tted with
daytime running lamps, pressing the button does not have any effect.
CLOCK
The analogue clock, located between the central vents of the
dashboard, does not have an adjustment button.
To set the time, refer to the section relating to your multifunction
screen's confi guration menu.
The clock is synchronised with the multifunction screen time; once the
the setting has been confi rmed on the multifunction screen, the hands
will turn to synchronise with the screen, and each time the ignition is \
switched on.

74
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
 To obtain an even air distribution, take care not to obstruct the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
 Do not cover the sunshine sensor, located on the dashboard; this is used for regulation of the air conditioning system.
 Operate the air conditioning system for at least 5 to 10 minutes, once or twice a month to keep it in good working order.
 Ensure that the passenger compartment fi lter is in good condition and have the fi lter elements replaced regularly (refer
to the "Checks" section).
We recommend the use of a combined passenger compartment fi lter. Thanks to its special active additive,
it contributes to the purifi cation of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
 To ensure correct operation of the air conditioning system, you are also advised to refer to the warranty and maintenance
record for information on when it should be checked.
 If the system does not produce cold air, switch it off and contact a PEUGEOT dealer or a qualifi ed workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance. The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal. If after an extended stop in sunshine, the interior temperature is
very high, fi rst ventilate the cabin for a few moments.
Put the air fl ow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING

11 4
RCZ_EN_CHAP05_SECURITE_ED02-2013
FRONT AIRBAGS
System which protects the driver and front passenger in the event of
a serious front impact in order to limit the risk of injury to the head \
and
chest.
The driver's airbag is fi tted in the centre of the steering wheel; the front
passenger's airbag is fi tted in the dashboard above the glove box.
Deployment
The airbags are deployed, except the passenger's front airbag if it is
deactivated, in the event of a serious front impact to all or part of th\
e
front impact zone A , in the longitudinal centreline of the vehicle on a
horizontal plane and directed from the front to the rear of the vehicle.\

The front airbag infl ates between the chest and head of the front
occupant of the vehicle and the steering wheel, driver's side, and the
dashboard, passenger's side to cushion their forward movement.
Deactivation
Only the passenger's front airbag can be deactivated:
 with the ignition off , insert the key in the passenger airbag
deactivation switch,
 turn it to the "OFF" position,
 then, remove the key keeping the switch in the new position.
To assure the safety of your child, the passenger's front airbag
must be deactivated when you install a "rearward facing" child
seat on the front passenger seat.
Otherwise, the child would risk being seriously injured or killed if
the airbag were deployed. This warning lamp comes on in the passenger's front airbag
warning lamps display when the ignition is on and until the
airbag is reactivated.

5/
SAFETY
RCZ_EN_CHAP05_SECURITE_ED02-2013
For the airbags to be fully effective, observe the following
safety rules:
Sit in a normal upright position.
Wear a correctly adjusted seat belt.
Do not leave anything between the occupants and the airbags
(a child, pet, object...). This could hamper the operation of the
airbags or injure the occupants.
After an accident or if the vehicle has been stolen or broken into,
have the airbag systems checked.
All work on the airbag system must be carried out by a PEUGEOT
dealer or a qualifi ed workshop.
Even if all of the precautions mentioned are observed, a risk of
injury or of minor burns to the head, chest or arms when an airbag
is deployed cannot be ruled out. The bag infl ates almost instantly
(within a few milliseconds) then defl ates within the same time
discharging the hot gas via openings provided for this purpose.
Front airbags
Do not drive holding the steering wheel by its spokes or resting your
hands on the centre part of the wheel.
Passengers must not place their feet on the dashboard.
If possible, do not smoke as deployment of the airbags can cause
burns or the risk of injury from a cigarette or pipe.
Never remove or pierce the steering wheel or hit it violently.
Lateral airbags
Do not fi x or attach anything to the seat backs. This could cause
injury to the chest or arms if the lateral airbag is triggered.
Do not sit with the upper part of the body any nearer to the door than
necessary.

6/
DRIVING
IGNITION SWITCH
ELECTRONIC ENGINE IMMOBILISER
STARTING THE VEHICLE
 Insert the key in the ignition switch.
The system recognises the starting code.
 Turn the key fully towards the dashboard to position 3 (Starting) .
 When the engine starts, release the key.
SWITCHING THE VEHICLE OFF
 Immobilise the vehicle.
 Turn the key fully towards you to position 1 (Stop) .
 Remove the key from the ignition switch.
Key left in the "Ignition on" position
On opening the driver's door, an alert message is displayed,
accompanied by an audible signal, to remind you that the key is
still in the ignition switch at position 1 (Stop) .
If the key has been left in the ignition switch at position 2 (Ignition
on) , the ignition will be switched off automatically after one hour.
To switch the ignition back on, turn the key to position 1 (Stop) ,
then back to position 2 (Ignition on) .
The key contains an electronic chip which has a special code. When
the ignition is switched on, this code must be recognised in order for
starting to be possible.
A few minutes after the ignition is switched off, this electronic engine
immobiliser locks the engine management system and prevents starting
of the engine by anyone who does not have the key.
In the event of a malfunction, you are informed by lighting of this
warning lamp, an audible signal and a message on the screen.
In this case, your vehicle does not start; contact a PEUGEOT
dealer as soon as possible.
Switching off the engine leads to a loss of braking assistance.