2014 MITSUBISHI OUTLANDER SPORT MPG

Multi information display
Instruments and controls 6-13
6
E00537600026
This displays the approximate driving range(how many more kilometres or miles you candrive).EV cruising range display (A)This displays the distance that can be traveledwith the remaining power in the drive battery.To t a l c r u i s i n g r a n g e d i s p l a y ( B )This displays the distance that can be traveledwith the remaining power in the drive batteryand the remaining amount of fuel.
E00531201072
This displays the average fuel consumptionfrom the last reset to the present time.There are the following 2 mode settings.Refer to “Changing the reset mode for aver-age fuel consumption” on page 6-16.For information on how to change the aver-age fuel consumption display setting, refer to“Changing the function settings” on page6-15.
EV cruising range display/Total cruising range display
NOTE
zThe driving range may vary depending onthe driving conditions
and habits. Treat the
distance displayed as just a rough guideline. zWhen the drive battery is charged or thevehicle is refueled, th
e cruising range display
is updated. However, if the charge level islow or the refueling amount is small, it can-not be updated correctly. Fully charge thebattery or refill to full tank whenever possi-ble.
zOn rare occasions, the value displayed forthe driving range may change if you areparked on an extremely steep incline. This isdue to the movement of fuel in the tank anddoes not indicate any malfunction.zThe display setting can be changed to thepreferred units (km or miles).Refer to “Changing the function settings” onpage 6-15.zWhen the EV cruising range falls belowapproximately 1 km (1 mile), the EV cruis-ing range display shows “---”.zWhen the total cruising range falls belowapproximately 50 km (30 miles), the totalcruising range disp
lay shows “---”.
Av e r a g e f u e l c o n s u m p t i o n d i s -play
NOTE
NOTE
zThe average fuel consumption display can bereset separately for the auto reset mode andfor the manual reset mode.z“---” is displayed when the average fuel con-sumption cannot be measured or when it is99.9 L/100 km (99.9 miles) or more.zThe initial (default) setting is “Auto resetmode”.zThe average fuel consumption will dependon the driving conditions (road conditions,how you drive, etc.). The displayed fuel con-sumption may vary from the actual fuel con-sumption. Treat the fuel consumptiondisplayed as just
a rough guideline.
zThe memory of the auto reset mode or man-ual reset mode for the average fuel consump-tion display is erased if the auxiliary batteryis disconnected.zThe display setting can be changed to thepreferred units {km/L, mpg (US), mpg (UK)or L/100 km}.Refer to “Changing the function settings” onpage 6-15.
BK0203201EN.book 13 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Multi information display
Instruments and controls 6-17
6
zWhen the operation mode is in ACC orOFF for about 4 hours or longer, the aver-age fuel consumption display is automati-cally reset.
E00523001778
The display unit for fuel consumption can beswitched. The distance and amount units arealso switched to match the selected fuel con-sumption unit.1. Press and hold the multi information dis-play switch for about 2 seconds or more toswitch from the setting mode screen to themenu screen.Refer to “Changing the function settings”on page 6-15.
2. Lightly press the multi information dis-play switch to select “AVG UNIT (fuelconsumption display setting)”.3. Press and hold the multi information dis-play switch for about 2 seconds or more todisplay “AVG UNIT”.4. Lightly press the multi information dis-play switch to select the units.5. Press and hold the multi information dis-play switch for about 2 seconds or more tochange the setting to the selected unit.
The distance units is also switched in the fol-lowing combinations to match the selectedfuel consumption unit.
E00523101737
The display unit for temperature can beswitched.1. Press and hold the multi information dis-play switch for about 2 seconds or more toswitch from the setting mode screen to themenu screen.Refer to “Changing the function settings”on page 6-15.2. Lightly press the multi information dis-play switch to select “ ” (temperatureunit setting).
NOTE
zThe average fuel consumption display can bereset separately for the auto reset mode andfor the manual reset mode.zThe memory of the auto reset mode or man-ual reset mode for the average fuel consump-tion display is erased if the auxiliary batteryis disconnected.
Changing the fuel consumption display unit
NOTE
zThe display units for the average fuel con-sumption and the driving range is switched,but the units for the indicating needle (speed-ometer), the odometer and the tripmeter willremain unchanged.
Fuel consumption
Distance
(driving range)
L/100 km
km
mpg (US)
mile (s)
mpg (UK)
mile (s)
km/L
km
Changing the temperature unit
BK0203201EN.book 17 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

4-wheel drive operation7-20 Starting and driving
7
The S-AWC operation status is displayed.
E00636501039
While the drive mode is in the “4WD LOCK”position, if the ECO mo
de switch is switched
ON, the drive mode will be changed to “ECOLOCK” mode.If the ECO mode switch is switched OFF, thedrive mode will be returned to “4WD LOCK”mode.Refer to the “ECO mode switch” on page6-46.
E00606602083
Yo u r v e h i c l e h a s b e e n d e s i g n e d p r i m a r i l y f o ruse on pavement.But its unique 4-wheel drive system allowsyou to occasionally travel on unpaved roads,to campgrounds, picnic sites, and similarlocations.Not only does this ensure better handling ondry, paved roads but also permits better trac-tion when driving on slippery, wet or snow-covered roads and when moving out of mud.But it is not suitable for heavy off road use ortowing in rough conditions.It is particularly important to note that 4-wheel drive may not give sufficient hillclimbing ability and regenerative brake onsteep slopes. You should try to avoid drivingon steep slopes.Also, you must exercise caution when drivingon sand and mud and when driving throughwater because sufficient traction may not beavailable in certain circumstances.Please avoid driving the vehicle through areaswhere the tyres may get stuck in deep sand ormud.
Display example Ya w c o n t r o l f u n c t i o n d i s p l a yThe amount of the yaw moment is displayedas a bar graph.A,D- Clockwise yaw moment about the
vehicle’s center of gravity
B,C- Counterclockwise yaw moment about
the vehicle’s center of gravity
To r q u e d i s t r i b u t i o n f u n c t i o n d i s p l a yThe torque distribution between the front andrear wheels is displayed in section E of themeter as a bar graph.
WA R N I N GzAlways concentrate on
your driving first.
Keep your eyes and mind on the road. Dis-tractions while driving can lead to an acci-dent.
When the ECO mode switch is ON
4-wheel drive operation
BK0203201EN.book 20 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Acoustic Vehicle Alerting System (AVAS)
Starting and driving 7-25
7
zWhen the vehicle speed is about 3 km/h to35 km/h and engine is not running.
The sound does not start in the followingcases. zWhen the vehicle speed is about 3 km/h orless and the brake pedal is depressed.zWhen the vehicle speed is about 35 km/hor more.zWhen the select position is “P” (PARK)position.zWhen the AVAS OFF indicator in themeter is illuminating.zWhen the engine is running.
When the operation mode is set to “ON”, theAVA S O F F i n d i c a t o r c o m e s o n a n d g o e s o u tin a few seconds.
E00631701052
If the operation mode is put in ON, the AVASis automatically turned on.The AVAS should be turned on while normaldriving.When driving on the freeway etc., it is possi-ble to turn off by pressing the AVAS OFFswitch.
If pressing the AVAS OFF switch, the audiblealarm not sound and indicator lamp illumi-nates.If pressing the AVAS OFF switch once again,the AVAS is activated and the indicator lampgoes off.
WA R N I N GzEven if the Acoustic Vehicle Alerting Sys-tem (AVAS) sounds, pay special attentionto pedestrians.Pedestrians may not notice the oncomingvehicle, which may cause an accidentresulting in serious
personal
injury or
death.CAUTIONzAlways confirm the indicator lamp goes offbefore driving. If the indicator lamp blinks, the operationmode is put in OFF, and the operation modeis put in OFF once again. It is not abnormallyif the indicator lamp goes off. If the indicatorlamp blinks again, have the vehicle inspectedat a MITSUBISHI MOTORS AuthorisedService Point as
soon as possible.
AVA S O F F s w i t c h
WA R N I N GzNever turn the Acoustic Vehicle AlertingSystem (AVAS) off if there is a possibilitywhere the pedestrian exists.NOTE
zIf the operation mode is put in OFF, whilethe AVAS has been turned off, and the opera-tion mode is put in ON once again, the AVASis activated.
BK0203201EN.book 25 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分