2014 MERCEDES-BENZ CLS ESP

ProblemPossible causes/consequences andSolutions

The yellowESP®
warning lamp flashes
while the vehicle is in
motion.
ESP®or traction control has intervened because there isarisk of
skidding or at least one wheel has started to spin.
Cruise control or DISTRONIC PLUS is deactivated.
XWhen pulling away,only depress the accelerator pedal as far as
necessary.
XEase off the accelerator pedal while the vehicle is in motion.
XAdapt your driving style to suit the road and weather conditions.
XDo not deactivate ESP®.
For exceptions, see: (Ypage 68).

The yellowESP®OFF
warning lamp is lit while
the engine is running.
ESP®is deactivated.
GWARNING
If ESP®is switched off, ESP®is unable to stabilize the vehicle.
There is an increased risk of skidding and an accident.
XReactivate ESP®.
For exceptions, see: (Ypage 68).
XAdapt your driving style to suit the road and weather conditions.
If ESP®cannot be activated:
XDrive on carefully.
XHave ESP®checked ataqualified specialist workshop.

AMG vehicles only:
The yellow SPORT
handling mode warning
lamp is lit while the
engine is running.
SPORT handling mode is activated.
GWARNING
When SPORT handling mode is switched on, ESP®is unable to
stabilize the vehicle.
There is an increased risk of skidding and an accident.
XOnly switch to SPORT handling mode in accordance with the
conditionsdescribed in the "Activating/deactivating SPORT
handling mode" section (Ypage 70).
270Indicator and warning lampsinthe instrument cluster
On-board computer and displays

ProblemPossible causes/consequences andSolutions

The yellowESP®and
ESP®OFF warning
lamps are lit while the
engine is running.
ESP®,BAS,BAS PLUS, PRE-SAFE®,PRE-SAFE®Brake, the HOLD
function and hill start assist are not available due toamalfunction.
ATTENTION ASSIST is deactivated.
GWARNING
The brake system continues to function normally, but without the
functions listed above.
The braking distance in an emergency braking situation can thus
increase.
If ESP®is not operational, ESP®is unable to stabilize the vehicle.
There is an increased risk of skidding and an accident.
XObserve the additional display messages in the multifunction
display.
XDrive on carefully.
XVisitaqualified specialist workshop.

The yellowESP®and
ESP®OFF warning
lamps are lit while the
engine is running.
ESP®,BAS, PRE-SAFE®,the HOLD functionand hill start assist are
temporarilyunavailable.
BAS PLUSand PRE-SAFE®Brake mayalsohavefailed.
ATTENTIONASSIST is deactivated.
self-diagnosisisnot yetcomplete.
GWARNING
The brake system continues to function normally, but without the
functions listed above.
The braking distance in an emergencybraking situation can thus
increase.
If ESP®is not operational, ESP®is unable to stabilize the vehicle.
There is an increased risk of skidding and an accident.
XCarefully drive onasuitable stretch of road, making slight
steeringmovements ataspeed above 12 mph (20 km/h).
The functions mentioned above are available again when the
warning lamp goes out.
If the warning lamp is still on:
XObserve the additional display messages in the multifunction
display.
XDrive on carefully.
XVisitaqualified specialist workshop.
Indicator and warning lampsinthe instrument cluster271
On-board computer and displays
Z

Tires
ProblemPossible causes/consequencesandSolutions

The yellow tire pressure
monitor warninglamp
(pressure loss/
malfunction) is lit.
The tire pressure monitor hasdetectedalossofpressure in at
leastone of the tires.
GWARNING
With tire pressures which aretoo low, there isarisk of the
following hazards:
Rthey may burst, especially as the load and vehicle speed
increase.
Rthey may wear excessively and/or unevenly, which may greatly
impair tire traction.
Rthe driving characteristics, as well as steeringand braking, may
be greatly impaired.
There isarisk of an accident.
XStop the vehicle without making any sudden steeringorbraking
maneuvers. Pay attention to the traffic conditions as you do so.
XSecure the vehicle against rolling away (Ypage 167).
XObserve the additional display messages in the multifunction
display.
XCheck the tires and, if necessary, follow the instructions for a
flat tire (Ypage 321).
XCheck the tire pressure (Ypage 342).
XIf necessary, correctthe tire pressure.

The yellow tire pressure
monitor warning lamp
(pressure loss/
malfunction) flashes for
approximately one
minute and then
remains lit.
The tire pressure monitor is faulty.
GWARNING
The system is possibly unable to recognize or register low tire
pressure.
There isarisk of an accident.
XObserve the additional display messages in the multifunction
display.
XVisitaqualified specialist workshop.
276Indicator and warning lampsinthe instrument cluster
On-board computer and displays

Useful information
iThis Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences are
possible. Please notethat your vehicle may
not be equipped with all features
described. This also applies to safety-
related systemsand functions.
iRead the information on qualified
specialist workshops: (Ypage 26).
Stowage areas
Loading guidelines
GWARNING
If objects, luggage or loads are not secured or
not secured sufficiently, they could slip, tip
over or be flung around and thereby hit vehicle
occupants.There isarisk of injury,
particularly in the eventofsudden braking or
asuddenchange in direction.
Always store objectssothat they cannot be
flung around. Secure objects, luggageor
loads against slipping or tipping before the
journey.
GWARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Exhaust
gases can enter the vehicle interior if the
trunk lid is open when the engine is running,
especially if the vehicle is in motion. There is
arisk of poisoning.
Always switch off the engine before opening
the trunk lid. Never drive with the trunk lid
open.
The handling characteristics ofaladen
vehicle are dependent on the distribution of
the load within the vehicle. For this reason,
you should observe the following notes when
transportingaload:
RNever exceed the maximum permissible
gross vehicle weight or the gross axle
weight rating of the vehicle (including
occupants). The values are specified on the
vehicle identification plate on the B-pillar of
the driver's door.
RThe trunk is the preferred place to carry
objects.
RPosition heavy loads as far forwards as
possible and as low down in the trunk as
possible.
RThe load must not protrude above the
upper edge of the seat backrests.
RAlways place the load against the rear or
front seat backrests. Make sure that the
seat backrests are securely locked into
place.
RAlways place the load behind unoccupied
seats if possible.
RUse the cargo tie down rings and the parcel
nets to transport loads and luggage.
RUse cargo tie-down rings and fastening
materials appropriate for the weight and
size of the load.
RSecure the load with sufficiently strongand
wear-resistant tie-downs. pad sharp edges
for protection.
Stowage space
Important safety notes
GWARNING
If you do not correctly store objectsinthe
vehicle interior, they can slip or be flung
around, thus strikingvehicle occupants.
There isarisk of injury, especially when
braking or abruptly changing directions.
278Stowage areas
Stowage and features

backrest forwards, the respective front
seat moves forward slightly, when
necessary, in order to avoid contact.
XVehicles without memoryfunction:if
necessary,movethe driver's or front-
passengerseat forwards.
XOpen the trunk.
XPull right-hand or left-hand rear seat
backrest release handle.
The correspondingrear seat backrest is
released.
XFold rear seat backrestforwards.
XMove the driver's or front-passenger seat
back if necessary.
Folding the seat backrest back
!Make sure that the seat belt does not
become trapped when folding the rear seat
backrest back. Otherwise, it could be
damaged.
XMove the driver's or front-passenger seat
forward if necessary.
XFold rear seat backrestback until it
engages.
If the rear seat backrest is not engaged and
locked, this will be shown in the
multifunction display in the instrument
cluster.Awarning tone also sounds.
XMovethedriver'sorfront-passenger seat
back if necessary.
iYou should always engage therear seat
backrests if you do notneed the through-
loading feature. This will prevent
unauthorized access to the trunkfrom the
vehicle interior.
Securing cargo
Cargo tie-down rings
General notes
Observe the following notes on securing
loads:
RObserve the loading guidelines
(Ypage 278).
RSecure the load using the cargo tie-down
rings.
RDistribute the load on the cargo tie-down
rings evenly.
RDo not use elastic straps or netstosecure
aload, as these are only intended as an
anti-slip protection for light loads.
RDo not route tie-downs across sharp edges
or corners.
RPad sharp edges for protection.
282Stowage areas
Stowage and features

AMG vehicles
XTo open:brieflypress the trim on
cover.
The stowagecompartment opens.
XLiftupthe coverofsocket.
XTo close:folddowncover.
Socket in the rear-compartment center
console
XSlide coverforwards.
XLift up the cover of socket.
Socket in the trunk
XLift up the cover of socket.
mbrace
Important safety notes
!You must havealicense agreement to
activate the mbrace service. Make sure
that your system is activated and ready for
use. To register, press theMB Info call
button.Ifany of the steps mentioned are
not carried out, the system may not be
activated.
If you have questions about the activation,
contact one of the following telephone
hotlines:
RUSA:Mercedes-Benz Customer
Assistance Center at
1-800-FOR-MERCedes
(1-800-367-6372)or1-866-990-9007
RCanada:Customer Serviceat
1-888-923-8367
Shortly after successfully registeringwith the
service,auser ID and password will be sent
to you by post. USA only: you can use this
password to log ontothe mbrace area under
"Owners Online" athttp://
www.mbusa.com.
The system is available if:
Rit has been activated and is operational
Rthe corresponding mobile phone network
is available for transmitting data to the
Customer Center
290Features
Stowage and features

General notes
An emergency call is dialed automatically if
an air bag or Emergency Tensioning Device is
triggered.
iYou cannot end an automatically
triggered emergency call yourself.
An emergency call can alsobeinitiated
manually.
As soon as the emergency call has been
initiated, the indicator lamp in the SOS button
flashes. The multifunction display shows the
Connecting Callmessage.
The audio outputismuted.
Once the connection has been made, the
Call Connectedmessage appears in the
multifunction display.
All important information on the emergency
is transmitted, for example:
RCurrent location of the vehicle (as
determined by the GPS system)
RVehicle identification number
RInformation on the severity of the accident
Shortly after the emergency call has been
initiated,avoice connection is automatically
established between the Mercedes-Benz
Customer Assistance Center and the vehicle
occupants.
RIf the vehicle occupants respond, the
Mercedes-Benz Customer Assistance
Center attempts to get more information
on the emergency.
RIf there is no response from the vehicle
occupants, an ambulance is immediately
sent to the vehicle.
If no voice connection can be established to
the response center, the system was unable
to initiate an emergency call. This can occur
for instance if the relevant mobile phone
network is not available. The indicator lamp
in the SOS button flashes continuously.
TheCall Failedmessage appears in the
multifunction displayand must be confirmed.
In this case, summon assistance by other
means.
Making an emergency call
GWARNING
It can be dangerous to remain in the vehicle,
even if you have pressed the SOS button in an
emergency if:
Ryou see smoke inside or outside of the
vehicle, e.g. if there isafire after an
accident
Rthe vehicle is onadangerous section of
road
Rthe vehicle is not visible or cannot easilybe
seen by other road users, particularly when
dark or in poor visibility conditions
There isarisk of an accident and injury.
Leave the vehicle immediately in this or
similar situations as soon as it is safe to do
so. Move toasafe location along with other
vehicle occupants. In such situations, secure
the vehicle in accordance with national
regulations, e. g. withawarning triangle.
XTo initiate an emergency call
manually:press coverbriefly to open.
XPress SOS buttonbriefly.
The indicator lamp in SOS button
flashes until the emergency call is
concluded.
XWait foravoice connection to the
Mercedes-Benz Customer Assistance
Center.
XAfter the emergency call, close cover.
iIf the mobile phone network is
unavailable, mbrace will not be able to
make the emergency call. If you leave the
292Features
Stowage and features

vehicleimmediatelyafter pressing the SOS
button, you willnot know whethermbrace
placed the emergency call. In this case,
always summon assistance by other
means.
Roadside Assistance button
XPress Roadside Assistance button.
This initiatesacall to the Mercedes-Benz
Customer Assistance Center. The indicator
lamp in Roadside Assistance button
flashes while the call is active. The
multifunction display shows the
Connecting Callmessage. The audio
output is muted.
Ifaconnection can be made, theCall
Connectedmessage appears in the
multifunction display.
Ifamobile phone network and GPS reception
are available, the system transfers data to the
Mercedes-Benz Customer Assistance Center,
for example:
RCurrent location of the vehicle
RVehicle identification number
iThe COMAND display indicates thatacall
is active. Duringthe call, you can changeto
the navigation menu by pressingthe NAVI
button on COMAND,for example.
Voice output is not available.
Avoice connection is established between
the Mercedes-Benz Customer Assistance
Center and the vehicle occupants.
From the vehicle remote malfunction
diagnosis, the Mercedes-Benz Customer
Assistance Center can ascertain the nature of
the problem (Ypage 297).
The Mercedes-Benz Customer Assistance
Center either sendsaqualified Mercedes-
Benz technician or arranges for your vehicle
to be transported to the nearest authorized
Mercedes-Benz Center. You may be charged
for services such as repair work and/or
towing.
Further details are available in your mbrace
manual.
iThe system has not been able to initiate
aroadside assistance call, if:
Rthe indicator lamp for Roadside
Assistance call buttonis flashing
continuously.
Rno voice connection to the Mercedes-
Benz Customer Assistance Center was
established.
This may be because the corresponding
mobile phone network is not available.
TheCall Failedmessage appears in the
multifunction display.
XTo endacall:press thebutton on the
multifunctionsteering wheel.
or
XPress the corresponding button for ending
aphone callonCOMAND.
MB Info call button
Features293
Sto wag ea nd featur es
Z