2014 MERCEDES-BENZ CLS COUPE engine

[x] Cancel search: engine

Page 188 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual information about this from your Mercedes-
Benz Service Centre.
Brake pads/linings and discs that are either
new or have been replaced only achieve opti- mum braking effect after several hundred kil-

Page 189 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual and is therefore unsuitable for that purpose.
Changes in the outside temperature are dis-
played after a short delay.
Indicated temperatures just above the freez-
ing point do not guarantee that the r

Page 192 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual trol off
trol off
message in the multifunction dis-
play for approximately five seconds.
i The last speed stored is cleared when you
switch off the engine. SPEEDTRONIC
Important safety notes SPEEDTRON

Page 193 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual Selecting variable SPEEDTRONIC
If there is a change of drivers, advise the new
driver of the limit speed stored.
X Check whether LIM indicator lamp :is on.
If it is on, variable SPEEDTRONIC is already

Page 194 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual speed is set. Press the cruise control lever
up : for a higher speed or down ;for a
lower speed.
X To adjust the set speed in 1 km/h incre-
ments: briefly press the cruise control
lever up :to the pre

Page 196 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual If DISTRONIC PLUS no longer detects a vehi-
cle in front, it may unexpectedly accelerate to the speed stored.
This speed can:
R be too high for a filter lane or a slip road
R be so high in the right l

Page 199 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual Even if the vehicle in front leaves the detec-
tion range, DISTRONIC PLUS temporarily
maintains the current driving speed and does not accelerate. This is based on the current
map data in the navigati

Page 201 of 417

MERCEDES-BENZ CLS COUPE 2014  Owners Manual =
Specified minimum distance to the vehi-
cle in front; adjustable
? Own vehicle
X Select the Distance display
Distance display function
using the on-board computer
(Y page 249).
Display when DISTRONI