Page 609 of 688

6097-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
CAUTION
■Precautions for use of the sealant
●Ingesting the sealant is hazardous to your health. If you ingest sealant, consume
as much water as possible, and then immediately consult a doctor.
●If sealant gets in eyes or adheres to skin, immediately wash it off with water. If dis-
comfort persists, consult a doctor.
■When fixing the flat tire
●Stop your vehicle in a safe and flat area.
●Do not touch the wheels or the area around the brakes immediately after the
vehicle has been driven.
After the vehicle has been driven, the wheels and the area around the brakes may
be extremely hot. Touching these areas with hands, feet or other body parts may
result in burns.
●Connect the valve and hose securely with the tire installed on the vehicle.
●If the hose is not properly connected to the valve, air leakage may occur or seal-
ant may be sprayed out.
●If the hose comes off the valve while inflating the tire, there is a risk that the hose
will move abruptly due to air pressure.
●After inflation of the tire has completed, the sealant may splatter when the hose is
disconnected or some air is let out of the tire.
●Follow the operation procedure to repair the tire. If the procedures not followed,
the sealant may spray out.
●Keep back from the tire while it is being repaired, as there is a chance of it burst-
ing while the repair operation is being performed. If you notice any cracks or
deformation of the tire, turn off the compressor switch and stop the repair opera-
tion immediately.
●The repair kit may overheat if operated for a long period of time. Do not operate
the repair kit continuously for more than 35 minutes.
●Parts of the repair kit become hot during operation. Be careful handling the
repair kit during and after operation. Do not touch the metal part connecting the
bottle and the compressor. It will be extremely hot.
●Do not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located,
such as the pad of the steering wheel, it may prevent the SRS air bag from operat-
ing properly.
GS350_250_OM_OM30E16E_(EE).book Page 609 Tuesday, July 8, 2014 7:11 PM
Page 610 of 688
6107-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
CAUTION
■Driving to spread the liquid sealant evenly
●Drive the vehicle carefully at a low speed. Be especially careful when turning and
cornering.
●If the vehicle does not drive straight or you feel a pull through the steering wheel,
stop the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If tire inflation pressure is 130 kPa (1.3 kgf/cm
2 or bar, 19
psi) or less, the tire may be severely damaged.
GS350_250_OM_OM30E16E_(EE).book Page 610 Tuesday, July 8, 201 4 7:11 PM
Page 611 of 688

6117-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
NOTICE
■When performing an emergency repair
●Perform the emergency repair without removing the nail or screw that has punc-
tured the tread of the tire. If the object that has punctured the tire is removed,
repair by the emergency tire puncture repair kit may not be possible.
●The repair kit is not waterproof. Make sure that the repair kit is not exposed to
water, such as when it is being used in the rain.
●Do not put the repair kit directly onto dusty ground such as sand at the side of the
road. If the repair kit vacuums up dust etc., a malfunction may occur.
■Handling the emergency tire puncture repair kit
●The repair kit power source should be 12 V DC suitable for vehicle use. Do not
connect the repair kit to any other source.
●If gasoline splatters on the repair kit, the repair kit may deteriorate. Take care not
to allow gasoline to contact it.
●Store the emergency tire puncture repair kit in the trunk.
The kit may be thrown around during sudden braking and so forth, damaging the
kit.
●Store the repair kit in the trunk out of reach of children.
●Do not disassemble or modify the repair kit. Do not subject parts such as the air
pressure indicator to impacts. This may cause a malfunction.
■To avoid damage to the tire pressure warning valves and transmitters (vehicles
with the tire pressure warning system)
When a tire is repaired with liquid sealants, the tire pressure warning valve and
transmitter may not operate properly. If a liquid sealant is used, contact any autho-
rized Lexus dealer or repairer, or another duly qualified and equipped professional
or other qualified service shop as soon as possible. Make sure to replace the tire
pressure warning valve and transmitter when replacing the tire. (→P. 4 6 8 )
GS350_250_OM_OM30E16E_(EE).book Page 611 Tuesday, July 8, 201 4 7:11 PM
Page 612 of 688

6127-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If the engine will not start
One of the following may be the cause of the problem:
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
●The engine may be flooded.
Try to restart the engine again following correct starting procedures.
(→ P. 2 3 7 )
●There may be a malfunction in the engine immobilizer system.
(→ P. 8 0 )
One of the following may be the cause of the problem:
●The battery may be discharged. ( →P. 6 2 1 )
●The battery terminal connections may be loose or corroded.
The engine starting system may be malfunctioning due to an electrical
problem such as electronic key battery depletion or a blown fuse. How-
ever, an interim measure is available to start the engine. ( →P. 613)
If the engine will not start even th ough correct starting procedures are
being followed ( →P. 237), consider each of the following points:
The engine will not start even though the starter motor operates
normally.
The starter motor turns over slowly, the interior lights and head-
lights are dim, or the horn does not sound or sounds at a low vol-
ume.
The starter motor does not turn over
GS350_250_OM_OM30E16E_(EE).book Page 612 Tuesday, July 8, 201 4 7:11 PM
Page 613 of 688

6137-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
One of the following may be the cause of the problem:
●One or both of the battery terminals may be disconnected.
●The battery may be discharged. (→P. 6 2 1 )
●There may be a malfunction in the steering lock system.
Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional if the problem cannot be repaired, or if repair procedures
are unknown.
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the engine switch is functioning nor-
mally:
Set the parking brake.
Shift the shift lever to P.
Turn the engine switch to ACCESSORY mode.
Press and hold the engine switch for about 15 seconds while depress-
ing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may be
malfunctioning. Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another du ly qualified and equipped professional.
The starter motor does not turn ov er, the interior lights and head-
lights do not turn on, or the horn does not sound.
Emergency start function
1
2
3
4
GS350_250_OM_OM30E16E_(EE).book Page 613 Tuesday, July 8, 201 4 7:11 PM
Page 614 of 688
6147-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If the shift lever cannot be shifted from P
Set the parking brake.
Turn the engine switch to ACCESSORY mode.
Depress the brake pedal.
Press the shift lock override but-
ton.
The shift lever can be shifted while the
button is pressed.
If the shift lever cannot be shifted with your foot on the brake pedal,
there may be a problem with the shift lock system (a system to prevent
accidental operation of the shift lever). Have the vehicle inspected by
any authorized Lexus dealer or repair er, or another duly qualified and
equipped professional immediately.
The following steps may be used as an emergency measure to ensure
that the shift lever can be shifted:
1
2
3
4
GS350_250_OM_OM30E16E_(EE).book Page 614 Tuesday, July 8, 201 4 7:11 PM
Page 615 of 688
615
7
7-2. Steps to take in an emergency
When trouble arises
GS350_250_OM_OM30E16E_(EE)
If the parking brake cannot be released
●Shift the shift lever to P.
●Turn the engine switch off.
●Check that the parking brake indicator is off.
●Chock the tires.
In the event that the battery is discha
rged or switch operation does not
release the parking brake, the parking brake can be released manually
using the procedure below. This procedure should be performed only if
necessary, such as in an emergency.
If the switch cannot be operated even when the battery is normal, the
parking brake system may be ma lfunctioning. Have the vehicle
inspected by any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional immediately.
Before releasing the parking brake manually
GS350_250_OM_OM30E16E_(EE).book Page 615 Tuesday, July 8, 201 4 7:11 PM
Page 616 of 688
6167-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
Take out the parking brake
release tool and the screwdriver
from the trunk. (→P. 578, 593)
Fit the parking brake release tool into
the screwdriver handle.
Vehicles with a spare tire: Take out the spare tire. ( →P. 582)
Vehicles without a spare tire: Remove the center auxiliary box.
( → P. 5 9 6 )
Remove the plug.
Insert the tool and press it down
firmly while turning it counter-
clockwise until it stops.
Releasing the parking brake manually
1
2
3
XVehicles with a compact spare
tire or an emergency tire
puncture repair kit XVehicles with a full-size spare
tire
4
GS350_250_OM_OM30E16E_(EE).book Page 616 Tuesday, July 8, 201 4 7:11 PM