Page 113 of 688
1132. Instrument cluster
2
Instrument cluster
GS350_250_OM_OM30E16E_(EE)
■Adjusting the display positionHigher
Lower
■Setting the brightness
The brightness of the display is automatically adjusted in accordance
with the brightness of the surrounding environment. However, the
brightness can also be manually adjusted in 9 stages.Brighter
Darker
Making the display easier to see
1
2
1
2
GS350_250_OM_OM30E16E_(EE).book Page 113 Tuesday, July 8, 201 4 7:11 PM
Page 114 of 688
1142. Instrument cluster
GS350_250_OM_OM30E16E_(EE)
When the vehicle approaches an
intersection, the direction the vehi-
cle should go is guided by the arrow.
When the vehicle approaches an
intersection, the route guidance will
start and the distance
* to the inter-
section will also be displayed.
*: The distance decreases in increments
of 50 m (164 ft.) and the distance indi-
cation will disappear when the vehicle
passes through the intersection.
Route guidance display (vehicles with navigation system)
GS350_250_OM_OM30E16E_(EE).book Page 114 Tuesday, July 8, 201 4 7:11 PM
Page 115 of 688
1152. Instrument cluster
2
Instrument cluster
GS350_250_OM_OM30E16E_(EE)
The audio display can be shown or hidden.Press and hold the “DISP” button
until the screen changes.
Customization can be performed
when the head-up display is on and
the vehicle is traveling at less than 8
km/h (5 mph).
Press the “DISP” button to switch
between on and off.
On and off will be switched between
each time the button is pressed.
If the button is left alone without being
operated for a short time, setting will
be finished automatically.
Display customization
1
2
GS350_250_OM_OM30E16E_(EE).book Page 115 Tuesday, July 8, 201 4 7:11 PM
Page 116 of 688

1162. Instrument cluster
GS350_250_OM_OM30E16E_(EE)
■Head-up display
●The head-up display may seem dark and hard to see when viewed through sun-
glasses, especially polarized sunglasses.
Adjust the brightness of the head-up display or remove your sunglasses.
●When the head-up display is turned off, it will remain off even if the engine switch is
turned to IGNITION ON mode after the engine switch has been turned off.
●The startup image will be displayed on the head-up display after the engine switch
has been turned to IGNITION ON mode while the head-up display switch is set to
on.
■When the battery is disconnected
The customize settings of the head-up display will be reset.
CAUTION
■Before using the head-up display
Check that the position and brightness of the head-up display image does not
interfere with safe driving. Incorrect adjustment of the image’s position or bright-
ness may obstruct the driver’s view and lead to an accident, resulting in death or
serious injury.
NOTICE
■To prevent damage to components
●Do not place any drinks near the head-up
display projector. If the projector gets wet,
electrical malfunctions may result.
●Do not place anything on or put stickers
onto the head-up display projector.
Doing so could interrupt head-up display
indications.
●Do not touch the inside of the head-up dis-
play projector or thrust sharp edges or the
like into the projector.
Doing so could cause mechanical malfunc-
tions.
GS350_250_OM_OM30E16E_(EE).book Page 116 Tuesday, July 8, 2014 7:11 PM
Page 117 of 688
117
2
2. Instrument cluster
Instrument cluster
GS350_250_OM_OM30E16E_(EE)
Fuel consumption information
Remote Touch screen
Remote Touch knob
“MENU” button
Fuel consumption information can
be displayed on the Remote Touch
screen.
Vehicles with a 12.3-inch display: The fuel consumption information can
be displayed and operated on the side display.
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 117 Tuesday, July 8, 201 4 7:11 PM
Page 118 of 688
1182. Instrument cluster
GS350_250_OM_OM30E16E_(EE)
Press the “MENU” button on the Remote Touch, then select on the
“Menu” screen.
■Trip information
If the “Past record” screen is displayed, select “Trip information”.Resetting the consumption
data
Fuel consumption in the past
15 minutes
Current fuel consumption
Average vehicle speed since
the engine was started.
Elapsed time since the engine was started.
Cruising range ( →P. 1 1 9 )
Average fuel consumption for the past 15 minutes is divided by color into past
averages and averages attained since the engine switch was last turned to
IGNITION ON mode. Use the displayed average fuel consumption as a ref-
erence.
The image is an example only, and may vary slightly from actual conditions.
Fuel consumption
1
2
3
4
5
6
GS350_250_OM_OM30E16E_(EE).book Page 118 Tuesday, July 8, 201 4 7:11 PM
Page 119 of 688

1192. Instrument cluster
2
Instrument cluster
GS350_250_OM_OM30E16E_(EE)
■Past record
If the “Trip information” screen is displayed, select “Past record”.Resetting the past record data
Best recorded fuel economy
Average fuel consumption
Previous fuel consumption
record
Updating the average fuel
consumption data
The average fuel consumption history is divided by color into past averages
and the average fuel consumption since the last reset. Use the displayed aver-
age fuel consumption as a reference.
The image is an example only, and may vary slightly from actual conditions.
■Updating the past record data
Update the average fuel consumption by selecting “Update” to measure the current
fuel consumption again.
■Resetting the data
The fuel consumption data can be deleted by selecting “Clear”.
■Cruising range
Displays the estimated maximum distance that can be driven with the quantity of fuel
remaining.
This distance is computed based on your average fuel consumption.
As a result, the actual distance that can be driven may differ from that displayed.
1
2
3
4
5
GS350_250_OM_OM30E16E_(EE).book Page 119 Tuesday, July 8, 201 4 7:11 PM
Page 120 of 688