2014 Lexus GS250 Owner's Manual

529 6-3. Do-it-yourself maintenance
6
Maintenance and care
GS350_250_OM_OM30E16E_(EE)
Install the cover of the back
end of the mirror, installing the
lower side and the upper side
in that order.
When installing the lower side of
the cover, insert the side turn signal
light pin into the hole in the cover.
Secure the cover with screws
and reconnect the connectors
back together.
Secure the cords by returning them
to the hooks as they were.
Align the tabs, and secure the
mirror by pushing in each
diagonally-opposite pair of
tabs in order.
Make sure to insert the tabs in
order as shown in the illustration,
and push them in until a click is
heard.
If you do not hear the click, do not
force the tabs in. Instead, remove
the mirror and check that the tabs
are aligned.
10
11
12
GS350_250_OM_OM30E16E_(EE).book Page 529 Tuesday, July 8, 2014 7:11 PM

5306-3. Do-it-yourself maintenance
GS350_250_OM_OM30E16E_(EE)
■Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
●Headlights
●Front position lights/daytime running lights
●LED front fog lights (if equipped)
●Side turn signal lights
●Stop/tail lights
●Tail lights
●Rear fog light
●High mounted stoplight
●License plate lights
■Discharge headlights (if equipped)
If voltage to the discharge bulbs is insufficient, the bulbs may not come on, or may go
out temporarily. The discharge bulbs will come on when normal power is restored.
■LED lights
The lights other than the discharge headlights (if equipped), halogen front fog lights
(if equipped), front turn signal lights, rear turn signal lights, back-up light and outer
foot lights each consist of a number of LEDs. If any of the LEDs burn out, take your
vehicle to any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional to have the light replaced.
■Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not indi-
cate a malfunction. Contact any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional for more information in the following situations:
●Large drops of water have built up on the inside of the lens.
●Water has built up inside the headlight.
■When replacing light bulbs
→P. 5 1 3
GS350_250_OM_OM30E16E_(EE).book Page 530 Tuesday, July 8, 201 4 7:11 PM

531 6-3. Do-it-yourself maintenance
6
Maintenance and care
GS350_250_OM_OM30E16E_(EE)
CAUTION
■Replacing light bulbs
●Turn off the lights. Do not attempt to replace the bulb immediately after turning
off the lights.
The bulbs become very hot and may cause burns.
●Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid
getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
●Fully install light bulbs and any parts used to secure them. Failure to do so may
result in heat damage, fire, or water entering the headlight unit. This may damage
the headlights or cause condensation to build up on the lens.
●While the headlights are turned on, and for
a short time after they have been turned off,
metal components at the rear of the head-
light assembly will be extremely hot. To pre-
vent burns, do not touch these metal
components until you are certain they have
cooled down.
Metal components
GS350_250_OM_OM30E16E_(EE).book Page 531 Tuesday, July 8, 2014 7:11 PM

5326-3. Do-it-yourself maintenance
GS350_250_OM_OM30E16E_(EE)
CAUTION
■Discharge headlights
●Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional before replacing the discharge headlights (including light
bulbs).
●Do not touch the discharge headlight’s high voltage socket when the headlights
are turned on.
An extremely high voltage of 30000 V will be discharged and could result in
death or serious injury by electric shock.
●Do not attempt to take apart or repair the headlight bulbs, connectors, power
supply circuits, or related components.
Doing so could result in electric shock and death or serious injury.
■To prevent damage or fire
●Make sure bulbs are fully seated and locked.
●Check the wattage of the bulb before installing to prevent heat damage.
NOTICE
■When replacing the outer foot lights
If the front window is stopping you from conducting the replace operation prop-
erly, open the window on the side you are working on to allow you enough space to
work. Continuing the operation without giving yourself enough space to work
could lead you to scratch the vehicle.
GS350_250_OM_OM30E16E_(EE).book Page 532 Tuesday, July 8, 2014 7:11 PM

533
7When trouble arises
GS350_250_OM_OM30E16E_(EE)
7-1. Essential informationEmergency flashers...................534
If your vehicle has to be stopped
in an emergency ......................535 7-2. Steps to take in an emergency
If your vehicle needs to be towed................................ 536
If you think something is wrong....................................... 542
Fuel pump shut off system ...... 543
If a warning light turns on or a warning buzzer sounds..... 544
If a warning message is displayed ................................ 552
If you have a flat tire (vehicles with a spare tire) .......................577
If you have a flat tire (vehicles without a spare tire) ............... 592
If the engine will not start .......... 612
If the shift lever cannot be shifted from P..............................614
If the parking brake cannot be released...................615
If the electronic key does not operate properly ...................... 618
If the vehicle battery is discharged ...............................621
If your vehicle overheats ......... 625
If the vehicle becomes stuck ......................... 628
GS350_250_OM_OM30E16E_(EE).book Page 533 Tuesday, July 8, 201 4 7:11 PM

5347-1. Essential information
GS350_250_OM_OM30E16E_(EE)
Emergency flashers
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch once
again.
■Emergency flashers
If the emergency flashers are used for a long time while the engine is not operating,
the battery may discharge.
The emergency flashers are used to warn other drivers when the vehi-
cle has to be stopped in the road due to a breakdown, etc.
GS350_250_OM_OM30E16E_(EE).book Page 534 Tuesday, July 8, 2014 7:11 PM

535
7
7-1. Essential information
When trouble arises
GS350_250_OM_OM30E16E_(EE)
If your vehicle has to be stopped in an emergency
Steadily step on the brake pedal wi
th both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required to
slow the vehicle.
Shift the shift lever to N.
XIf the shift lever is shifted to N
After slowing down, stop the vehicle in a safe place by the road.
Stop the engine.
XIf the shift lever cannot be shifted to N
Keep depressing the brake pedal with both feet to reduce vehicle
speed as much as possible.
To stop the engine, press and
hold the engine switch for 2 con-
secutive seconds or more, or
press it briefly 3 times or more in
succession.
Stop the vehicle in a safe place by the road.
Only in an emergency, such as if it becomes impossible to stop the vehi-
cle in the normal way, stop the ve hicle using the following procedure:
1
2
3
4
3
Press and hold for 2 seconds or more
or press briefly 3 times or more
4
CAUTION
■If the engine has to be turned off while driving
Power assist for the brakes and steering wheel will be lost, making the brake pedal
harder to depress and the steering wheel heavier to turn. Decelerate as much as
possible before turning off the engine.
5
GS350_250_OM_OM30E16E_(EE).book Page 535 Tuesday, July 8, 201 4 7:11 PM

5367-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If your vehicle needs to be towed
The following may indicate a problem with your transmission. Contact any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional or commercial towing service before towing.
●The engine is running but the vehicle will not move.
●The vehicle makes an abnormal sound.
If towing is necessary, we recommen d having your vehicle towed by any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional or commercial towing service, using a wheel-lift
type truck or flatbed truck.
Use a safety chain system for all to wing, and abide by all state/provin-
cial and local laws.
Situations need to contact dealers before towing
GS350_250_OM_OM30E16E_(EE).book Page 536 Tuesday, July 8, 201 4 7:11 PM