2014 JEEP WRANGLER Owners Manual

Page 177 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual control in the multifunction lever. These lights are also
controlled automatically by the Illuminated Entry Sys-
tem.A courtesy light is also found in the rear of the center
console. You can turn this

Page 178 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual The rear cargo light may be turned on by pressing the
lens. Press the lens a second time to turn the light off.When a door is open and the interior lights are on,
rotating the dimmer control to the ex

Page 179 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual WINDSHIELD WIPERS AND WASHERS
The windshield wiper/washer control lever is located on
the right side of the steering column. The front wipers are
operated by rotating a switch, located at the end of t

Page 180 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual CAUTION!
In cold weather, always turn off the wiper switch and
allow the wipers to return to the park position before
turning off the engine. If the wiper switch is left on
(Continued)
CAUTION!(Contin

Page 181 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual NOTE:The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph (16 km/h),
delay times will be doubled.
Windshield Washers
To use the washer, pull the lever toward you an

Page 182 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual Mist Feature
Push down on the wiper lever to activate a single wipe to
clear off road mist or spray from a passing vehicle. As
long as the lever is held down, the wipers will continue
to operate.
NOTE

Page 183 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual Push down on the lever to unlock the steering column.
With one hand firmly on the steering wheel, move the
steering column up or down, as desired. Pull upwards on
the lever to lock the column firmly i

Page 184 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual NOTE:In order to ensure proper operation, the Elec-
tronic Speed Control System has been designed to shut
down if multiple Speed Control functions are operated at
the same time. If this occurs, the El