2014 JEEP WRANGLER wipers

[x] Cancel search: wipers

Page 113 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual ▫60/40 Split Folding Rear Seat — Four-Door
Models ........................... .167
 TO OPEN AND CLOSE THE HOOD .........169
 LIGHTS ............................ .170
▫ Multifunction Lever ....

Page 179 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual WINDSHIELD WIPERS AND WASHERS
The windshield wiper/washer control lever is located on
the right side of the steering column. The front wipers are
operated by rotating a switch, located at the end of t

Page 180 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual CAUTION!
In cold weather, always turn off the wiper switch and
allow the wipers to return to the park position before
turning off the engine. If the wiper switch is left on
(Continued)
CAUTION!(Contin

Page 181 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual NOTE:The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph (16 km/h),
delay times will be doubled.
Windshield Washers
To use the washer, pull the lever toward you an

Page 182 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual Mist Feature
Push down on the wiper lever to activate a single wipe to
clear off road mist or spray from a passing vehicle. As
long as the lever is held down, the wipers will continue
to operate.
NOTE

Page 296 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual Raise the windshield and reinstall the side bars as soon as
the task that required their removal is completed and
before you return to on-road driving. Both you and your
passenger should wear seat bel

Page 343 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual Headlamps with Wipers (Available with Auto
Headlights Only)
When on is selected, and the headlight switch is in the
AUTO position, the headlights will turn on approxi-
mately 10 seconds after the wipe

Page 577 of 678

JEEP WRANGLER 2014 JK / 3.G Owners Manual Proper towing or lifting equipment is required to prevent
damage to your vehicle. Use only tow bars and other
equipment designed for this purpose, following equip-
ment manufacturer ’s instructions.
Page:   1-8 9-16 next >