2013 TOYOTA SIENNA inflation pressure

811
6-1. Specifications
6
Vehicle specifications
SIENNA_OM_OM45472U_(U)
19-inch tires
Tire size
P235/50R19 99V,
T155/80R17 101M (spare)
Tire inflation pressure
(Recommended cold tire
inflation pressure)Front: 36 psi (250 kPa, 2.5 kgf/cm2 or bar)
Rear: 36 psi (250 kPa, 2.5 kgf/cm2 or bar)
Spare:60 psi (420 kPa, 4.2 kgf/cm2 or bar)
Wheel size 19 x 7J, 17 x 4T (spare)
Wheel nut torque76 ft•lbf (103 N•m, 10.5 kgf•m)

818 6-1. Specifications
SIENNA_OM_OM45472U_(U)
Run-flat tire (RFT) or standard tire( P. 761)
This vehicle can be equipped with eit her run-flat tires (RFT) or stan-
dard tires. An “RFT” or “DSST” mark is molded on the sidewall of
the run-flat tire.
Tire ply composition and materials
Plies are layers of rubber-coated parallel cords. Cords are the
strands which form the plies in a tire.
Radial tires or bias-ply tires
A radial tire has “RADIAL” on the sidewall. A tire not marked
“RADIAL” is a bias-ply tire.
TUBELESS or TUBE TYPE
A tubeless tire does not have a tube and air is directly put into the
tire. A tube type tire has a tube inside the tire and the tube main-
tains the air pressure.
Load limit at maximum cold tire inflation pressure ( P. 693)
Maximum cold tire in flation pressure ( P. 810)
This means the pressure to which a tire may be inflated.
Summer tires or all season tires ( P. 694)
An all season tire has “M+S” on the sidewall. A tire not marked
“M+S” is a summer tire.
“TEMPORARY USE ONLY” ( P. 770)
A compact spare tire is identified by the phrase “TEMPORARY USE
ONLY” molded on its sidewall. This tire is designed for temporary
emergency use only.

824 6-1. Specifications
SIENNA_OM_OM45472U_(U)
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation pres-
sure Tire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressure The maximum cold inflated
pressure to which a
tire may be inflated, s hown on the sidewall of
the tire
Recommended infla-
tion pressure Cold tire inflation pressure recommended by a
manufacturer
Accessory weight The combined weight (in excess of those stan-
dard items which may be replaced) of auto-
matic transmission, power steering, power
brakes, power windows, power seats, radio
and heater, to the extent that these items are
available as factory-installed equipment
(whether installed or not)
Curb weight The weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine
Maximum loaded vehi-
cle weight The sum of:
(a) Curb weight
(b) Accessory weight
(c) Vehicle capacity weight
(d) Production options weight

827
6-1. Specifications
6
Vehicle specifications
SIENNA_OM_OM45472U_(U)
Tire related termMeaning
CT A pneumatic tire with an inverted flange tire
and rim system in which the rim is designed
with rim flanges pointed radially inward and the
tire is designed to fit on the underside of the
rim in a manner that encloses the rim flanges
inside the air cavity of the tire
Extra load tire A tire designed to operate at higher loads and
at higher inflation pressures than the corre-
sponding standard tire
Groove The space between two adjacent tread ribs
Innerliner The layer(s) forming the inside surface of a
tubeless tire that contains the inflating medium
within the tire
Innerliner separation The parting of the innerliner from cord material
in the carcass
Intended outboard
sidewall (a) The sidewall that contains a whitewall,
bears white lettering, or bears manufac-
turer, brand, and/or model name molding
that is higher or deeper than the same
molding on the other sidewall of the tire, or
(b) The outward facing sidewall of an asym- metrical tire that has a particular side that
must always face outward when mounted
on a vehicle
Light truck (LT) tire A tire designated by its manufacturer as prima-
rily intended for use on lightweight trucks or
multipurpose passenger vehicles
Load rating The maximum load that a tire is rated to carry
for a given inflation pressure
Maximum load rating The load rating for a tire at the maximum per-
missible inflation pressure for that tire

828 6-1. Specifications
SIENNA_OM_OM45472U_(U)
Tire related termMeaning
Maximum permissible
inflation pressure The maximum cold inflation pressure to which
a tire may be inflated
Measuring rim The rim on which a tire is fitted for physical
dimension requirements
Open splice Any parting at any junction of tread, sidewall, or
innerliner that extends to cord material
Outer diameter The overall diameter of an inflated new tire
Overall width The linear distance between the exteriors of
the sidewalls of an inflated tire, including eleva-
tions due to labeling, decorations, or protective
bands or ribs
Passenger car tire A tire intended for use on passenger cars, mul-
tipurpose passenger vehicles, and trucks, that
have a gross vehicle weight rating (GVWR) of
10,000 lb. or less
Ply A layer of rubber-coated parallel cords
Ply separation A parting of rubber compound between adja-
cent plies
Pneumatic tire A mechanical device made of rubber, chemi-
cals, fabric and steel or
other materials, that,
when mounted on an automotive wheel, pro-
vides the traction and contains the gas or fluid
that sustains the load
Radial ply tire A pneumatic tire in which the ply cords that
extend to the beads are laid at substantially 90
degrees to the centerline of the tread

829
6-1. Specifications
6
Vehicle specifications
SIENNA_OM_OM45472U_(U)
Tire related termMeaning
Reinforced tire A tire designed to operate at higher loads and
at higher inflation pressures than the corre-
sponding standard tire
Section width The linear distance between the exteriors of
the sidewalls of an inflated tire, excluding ele-
vations due to labeling, decoration, or protec-
tive bands
Sidewall That portion of a tire between the tread and
bead
Sidewall separation The parting of the rubber compound from the
cord material in the sidewall
Snow tire A tire that attains a traction index equal to or
greater than 110, compared to the ASTM E-
1136 Standard Reference Test Tire, when
using the snow traction test as described in
ASTM F-1805-00, Standard Test Method for
Single Wheel Driving Traction in a Straight Line
on Snow-and Ice-Covered Surfaces, and which
is marked with an Alpine Symbol ( ) on at
least one sidewall
Te s t r i m The rim on which a tire is fitted for testing, and
may be any rim listed as appropriate for use
with that tire
Tread That portion of a tire that comes into contact
with the road
Tread rib A tread section running circumferentially
around a tire
Tread separation Pulling away of the tread from the tire carcass

868 Alphabetical index
SIENNA_OM_OM45472U_(U)
Spare tireInflation pressure...................810
Storage location .................... 763
Spark plug ................................806
Specifications...........................800
Speech command switch ........ 549
Speedometer ............................ 244
Steering wheel Adjustment ............................ 137
Audio switches ......................477
Column lock release......227, 233
Stop lights
Replacing light bulbs ............. 725
Wattage .................................812
Storage feature.........................586
Storage precautions ................363
Stuck If your vehicle becomes
stuck ...................................794
Sunshades Rear door ..............................617
Roof....................................... 150
Sun visors.................................604
Switch Engine switch ................226, 229
Fog light switch ..................... 282
Ignition switch................226, 229
Light switches........................ 268
Power back door .....................82
Power door lock switch ...........61
Power window switch ....144, 148
Window lock switch ............... 144
Wiper and washer switch .......................... 284, 292 Tachometer .............................. 244
Tail lights
Replacing light bulbs ............. 725
Switch ................................... 268
Wattage................................. 812
Talk switch ............................... 549
Telephone switch..................... 549
Theft deterrent system Alarm..................................... 162
Engine immobilizer
system ................................ 159
Theft prevention labels ........... 165
Tire inflation pressure ............. 699
Tire information Glossary ................................ 824
Size ....................................... 810
Tire identification number...... 819
Uniform tire quality
grading................................ 821
Tires Chains ................................... 367
Checking ............................... 688
If you have a flat tire...... 761, 763
Inflation pressure .................. 699
Information ............................ 817
Replacing .............................. 763
Rotating tires ......................... 689
Size ....................................... 810
Snow tires ............................. 367
Tire pressure warning system ........................ 688, 749
Tools ......................................... 763
Total load capacity .................. 366T

876
SIENNA_OM_OM45472U_(U)
GAS STATION INFORMATION
Auxiliary catch leverP. 667Fuel filler doorP. 155
Hood release lever P. 6 6 7Fuel filler door opener P. 1 5 5Tire inflation pressure
P. 810
Back door openerP. 8 2
Fuel tank capacity
(Reference) 20.9 gal. (79 L, 17.4 Imp.gal.)
Fuel typeUnleaded gasoline with an Octane Rating of 87
(Research Octane Number 91)
Cold tire inflation
pressure
P. 8 1 0
Engine oil capacity
(Drain and refill
reference)qt. (L, Imp.qt.)
1AR-FE engine 2GR-FE engine
Without filter 4.2 (4.0 , 3.5) 6.0 (5.7, 5.0)
With filter 4.6 (4.4, 3.9) 6.4 (6.1, 5.4)
Engine oil type Toyota Genuine Motor Oil or equivalent
Oil grade P. 804
1AR-FE engine:
ILSAC multigrade engine oil
2GR-FE engine:
ILSAC GF-5 multigrade engine oil
Recommended oil viscosity:
0W-20