2013 SSANGYONG KORANDO lock

8510-00
Door lock/unlock switch
Function of door lock/unlock switch
There are 5 actuators in door lock/unlock system (including tailgate). All of them can control the
corresponding door lock and unlock separately. But, the driver door lock switch can control all door
locks. The BCM controls the lock/unlock switch using the door lock/unlock relay. This is a same control
type with Auto door lock function that locks the doors when the vehicle speed exceeds 30 km/h. (see
circuit diagram)
Door lock/unlock relay (integrated in BCM)
Door lock/unlock switch
When the door lock/unlock switch is pressed while all doors including the tailgate are locked, all doors
will be unlocked. When the switch is pressed again, all doors will be locked.

Door lock/unlock control by door LOCK switch
When moving the driver or passenger door lock (knob) switch to LOCK from UNLOCK position, BCM
sends the LOCK signal for 0.5 seconds.
When moving the driver or passenger door lock (knob) switch to UNLOCK from LOCK position, BCM
sends the UNLOCK signal for 0.5 seconds.
The LOCK (UNLOCK) operation by the door lock (knob) switch is not available when sending the
LOCK (UNLOCK) signal by any other method such as remote control key.
When reconnecting the battery, the door lock (knob) switch is not operational regardless of the door
lock switch positions.
All doors stay unlocked when receiving the door lock signal in 0.5 seconds after closing the doors. 1.
2.
3.
4.
5.

8510-00
Door lock/unlock control by central door lock switch
When pressing the central door lock/unlock switch, BCM sends the LOCK or UNLOCK signal
according to the previous condition of driver door lock switch for 0.5 seconds.
The central door dock switch is not available when the system is in theft deterrent mode.
When turning the ignition off, all doors are automatically unlocked if any of the door lock (knob)
switches is in LOCK position.
When pressing the central door lock switch with any door open, the system unlocks the doors
immediately after locking them. 1.
2.
3.
4.

Outside rearview mirror switch
(1) Overview
Outside mirror folding/unfolding switch
The outside mirrors are folded/unfolded
whenever pressing this switch.
Mirror selection switch
LH: Driver side mirror
RH: Passenger side mirror A.
B.Mirror aiming switch
Adjust the selected mirror up, down, left,
or right by pressing the corresponding
edges of the switch to get a desired view. C. It is mounted to the door trim and can be adjusted to up, down, left or right so that the driver can obtain a
clear view of the rear of the vehicle depending on the driver's physical condition. The driver can fold the
outside rearview mirror when passing by the narrow road or parking the vehicle. Do not fold or unfold the
outside rearview mirrors manually since the outside rearview mirror folding switch is a push-lock type
switch. This may cause a malfunction of the relevant devices.
2) Outside Mirror Switch

Lower main panel switch
3) Lower Main Panel Switch
Rear fog lamp switch (EU ONLY)
Steering wheel heating switchHLLD (Headlamp Leveling Device)4WD LOCK switch
ESP OFF switch This helps the driver to drive the vehicle comfortably by operating the switch for the driving situation.

8510-00
4WD LOCK switch
This switch is of push lock type, which
enables to increase/decrease the
torque to the rear wheels in AWD
mode.
Steering wheel heating
switch
This switch is of push return type,
which is used to activate or deactivate
the steering wheel heating function.
ESP OFF switch
The ESP OFF switch is of push return
type, which is used to stop or resume
the ESP function.
4WD LOCK switch
This switch is of push lock type, which
enables to increase/decrease the
torque to the rear wheels in AWD
mode.
HLLD
(Headlamp Leveling Device)
The headlamp aiming can be adjusted
by using this dial-type switch.
Rear fog lamp switch
(EU ONLY)
This switch is of push return type,
which sends ON/OFF signal to the
BCM so that the BCM can switch on
the lamps by activating the rear fog
lamp relay.

How to operate 4WD LOCK switch
When the switch is pressed, 4WD LOCK mode is activated (4WD LOCK indicator lamp comes on). If
you press the switch again, the system enters 4WD AUTO mode (indicator lamp goes off).
4WD AUTO mode (normal)
4WD LOCK switch
(1) 4WD LOCK switch
This provides a slip control for the rear wheels depending on the driving conditions such as stationary,
straight-line motion or cornering motion.
4WD LOCK mode (4WD LOCK switch pressed)
In 4WD LOCK mode, the 4WD LOCK control works in the same way as the AUTO mode, but it
increases the driving force to the rear wheels more than in AUTO mode.
If the rear wheel speed is over 40 km/h, the vehicle enters into the 4WD AUTO mode automatically. If
it is below 35 km/h, the vehicle returns to the 4WD LOCK mode. -
-
4WD mode operation table
4WD LOCK switch Vehicle speed Drive mode
Deactivated (4WD AUTO) Unlimited 4WD AUTO
Activated (4WD LOCK) 40 km/h or higher 4WD AUTO
Activated (4WD LOCK) Below 35 km/h 4WD LOCK
4WD: 4WD stands for Four Wheel Drive and drives all the wheels to maximize the vehicle's driving
force on the unpaved road, rough road, steep hills, sandy or muddy road for enhanced driving
performance.
Electric AWD (All Wheel Drive): 4-wheel drive is an electric drive system in which the vehicle is
usually driving in 2WD mode but, if the vehicle determines that 4WD is needed because of the
differences in slip and cornering between front and rear wheels, road gradient and etc., it is switched
to 4WD automatically by the E-coupling control unit.

8510-00
Door coupled room lamp operation and dimming control
When opening any of doors while the room lamp switch in overhead console is pressed in ("Door"
coupled position), the front and center room lamps come on. If the key is removed and door stays open,
the room lamps automatically goes off after 10 minutes. The sleep mode will be deactivated when the
door is locked or closed with the lamp OFF automatically.
When closing the door with IGN ON, the room lamps go off immediately.
When closing the door with IGN OFF, the room lamps stay on for 2 seconds more and are dimmed
out the side fascia panel.
When turning the ignition switch to ON position during dimming out operation, the room lamps go off
immediately.
When receiving the door unlock signal with IGN OFF, key removed and door closed, the overhead
console room lamp/center room lamp come on for 30 seconds.
For specification with the SKM, the lamps come on by the REKES unlock or passive unlock
signal.
When receiving the door unlock signal again while the lamps stay on by the REKES or passive
unlock signal, the overhead console/center room lamps stays on for 30 seconds more. (the lamps
stay on when receiving door unlock signal)
When opening a door during the coupled operation and dimming operation, the room lamps stays
ON. When closing it again, the lamps stay on for 2 seconds more and are dimmed out for 3 seconds.
While the room lamps dim out when the driver/passenger/rear doors are open and closed, they go off
immediately when entering into the theft deterrent mode.
The room lamps come on when AUTO approach signal is received. 1.
2.
3.
4.
5.
6.
7.
8.