2013 Lancia Flavia light

WEATHER STRIP CARE –
SOFT AND HARD TOP
Lubricate all top and door glass
weather strips periodically with a
weather strip lubricant to keep them
soft and pliable.FUSES
INTEGRATED POWER
MODULE
The Integrated Power Module is lo-
cated in the engine compartment near
the air cleaner assembly. This center
contains cartridge fuses and mini
fuses. A label that identifies each
component may be printed on the in-
side of the cover. Refer to the graphic
below for FUSES/TIPM location.
Cavity
Cartridge Fuse Mini Fuse Description
1 40 Amp Green —Power Top Module
2 —
20 Amp Yellow
Brake Vacuum Pump
3 — 10 Amp Red Center High Mounted Stop Light
(CHMSL)/Brake Switch
4 — 10 Amp RedIgnition Switch
5 — 20 Amp YellowTrailer Tow (when present)
6 — 10 Amp RedPower Mirror Switch/Climate Controls
7 — 30 Amp GreenIgnition Off Draw (IOD) Sense 1
8 — 30 Amp GreenIgnition Off Draw (IOD) Sense 2
9 40 Amp Green Battery Feed – Power Seats (for
versions/markets, where provided)
Integrated Power Module
208

CavityCartridge Fuse Mini Fuse Description
10 — 20 Amp YellowInstrument Panel/Power Locks/
Interior Lights
11 — 15 Amp Lt Blue Selectable Power Outlet (Inside Center
Arm Rest)
12 — 20 Amp Yellow—
13 — 20 Amp YellowIgnition/Cigar Lighter
14 — 10 Amp RedInstrument Panel
15 40 Amp Green —Radiator Fan Relay
16 — 15 Amp Lt. Blue Sunroof (for versions/markets, where
provided)
17 — 10 Amp RedWireless Control Module (WCM)/
Clock/Steering Control Module (SCM)
18 40 Amp Green —Auto Shutdown (ASD) Relay
19 — 20 Amp YellowAudio Amplifier (for versions/markets,
where provided)
20 — 15 Amp Lt. Blue Radio
21 — 10 Amp RedSiren (for versions/markets, where
provided)
209

CAUTION!
 When installing the IntegratedPower Module cover, it is impor-
tant to ensure the cover is prop-
erly positioned and fully latched.
Failure to do so may allow water
to get into the Integrated Power
Module, and possibly result in an
electrical system failure.
 When replacing a blown fuse, it is important to use only a fuse hav-
ing the correct amperage rating.
The use of a fuse with a rating
other than indicated may result in
a dangerous electrical system
overload. If a properly rated fuse
continues to blow, it indicates a
problem in the circuit that must
be corrected. VEHICLE STORAGE
If you will not be using your vehicle
for more than 21 days, you may want
to take steps to preserve your battery.
 Disengage the mini-fuse in the
Power Distribution Center labeled
IOD (Ignition Off-Draw).
 Or disconnect the negative cable from the battery. Refer to “Prepa-
ration for Jump Start” in “Jump-
Starting” to identify the location of
the negative post.
 Anytime you store your vehicle, or keep it out of service (i.e., vacation)
for two weeks or more, run the air
conditioning system at idle for
about five minutes in the fresh air
and high blower setting. This will
ensure adequate system lubrication
to minimize the possibility of com-
pressor damage when the system is
started again. REPLACEMENT BULBS
All the inside bulbs are brass or glass
wedge base. Aluminum base bulbs are
not approved and should not be used
for replacement.
LIGHT BULBS –
Interior Bulb No.
Front Courtesy/Reading
Lamp . . . . . . . . . . . . . 578/W5W
Center Courtesy/Reading
Lamp . . . . . . . . . . . . . 578/W5W
Glove Box Lamp . . . . . . . . . 194
Shift Indicator
Lamp . . . . . . . . . . . IKLE14140
Rear Compartment (Trunk)
Lamp . . . . . . . . . . . . . . . . . . 579
NOTE: For lighted switches, see
your authorized dealer for re-
placement.
212

LIGHT BULBS –
ExteriorBulb No.
Bi-Halogen Headlamp . . . HIR2
Front Turn Signal
Lamp . . . . . . . . . . . . 3157NAK
Front Park Lamp . . . . . . . LED (Serviced at Authorized Dealer)
Side Repeater Lamp . . . WY5W
Front Fog Lamp . . . . . . . . H11
Center High Mounted
Stop (CHMSL) Lamp . . . . LED (Serviced at Authorized Dealer)
Rear Tail/Stop Lamp . . . . . LED (Serviced at Authorized Dealer)
Rear Turn Signal
Lamp . . . . . . . . . . . . . . . W16W
Rear Fog Lamp . . . . . . . . . LED (Serviced at Authorized Dealer)
Backup Lamp . . . . . . . . W16W
License Lamp . . . . . . . . . W5W BULB REPLACEMENT
HEADLAMP
CAUTION!
Where possible, it is advisable to
have bulbs changed at a LANCIA
Dealership. Proper operation and
orientation of the external lights are
essential for driving safety and
complying with the law.
1. Raise and prop open the hood.
Locate the connector behind the
headlamp.
NOTE: It may be necessary to re-
move the air cleaner filter housing
and position the totally integrated
power module aside prior to re-
placing the low beam headlamp on
the driver's side of the vehicle.
2. Reach into engine compartment
and from behind the lamp assembly
and grasp the connector. 3. Rotate bulb and connector one-
quarter turn and pull outward from
assembly.
CAUTION!
Do not touch the new bulb with
your fingers. Oil contamination will
severely shorten bulb life.
213

NOTE: Placing a small flat head
screwdriver or similar tool be-
tween the lamp outboard ball stud
and plastic grommet from inside
the trunk can help to disengage the
outboard edge of the tail lamp.
3. Grasp the tail lamp by both the
outboard and inboard sides, and pull
firmly to disengage the tail lamp from
the vehicle.
NOTE: It is normal to hear a
loud sound when the lower tail
lamp area unsnaps from the ve-
hicle mounting bracket during tail
lamp removal.4. Twist and remove socket from
lamp.
5. Remove bulb from socket and re-
place.
6. Reinstall the tail lamp, fasteners,
and trunk liner.
BACKUP LAMP
1. Remove four push pins from the
bottom of the lower valance (from left
to right: 1st, 3rd, 6th & 8th) and two
push pins from the rear of the bracket.
2. Remove bracket by pulling for-
ward of vehicle.
3. Remove socket from housing with
a counter-clockwise
¼ turn. 4. Remove bulb from socket by pull-
ing directly out (do not turn/twist)
and install replacement bulb.
5. Insert socket back into the housing
with a clockwise ¼ turn.
6. Return bracket into position.
7. Snap the six (6) push pins back
into place.
LICENSE PLATE LAMP
1. Using a small screwdriver, press
inward the locking tab on the side of
the lamp assembly and pull down on
the lamp assembly for removal.
2. Remove bulb socket by twisting
out of lamp assembly.
3. Pull bulb from socket, replace, and
reinstall the bulb socket into lamp
assembly.
4. Install lamp assembly to lightbar
ensuring the locking tab is secure.
215

MAINTENANCE
SCHEDULEThe Scheduled Maintenance services
listed in this manual must be done at the
times or mileages specified to protect
your vehicle warranty and ensure the
best vehicle performance and reliability.
More frequent maintenance may be
needed for vehicles in severe operating
conditions, such as dusty areas and very
short trip driving. Inspection and ser-
vice should also be done anytime a mal-
function is suspected.The oil change indicator system will
remind you that it is time to take your
vehicle in for scheduled maintenance.On Electronic Vehicle Information
Center (EVIC) equipped vehicles “Oil
Change Required” will be displayed
in the EVIC and a single chime will
sound, indicating that an oil change is
necessary.
NOTE:

The oil change indicator message
will not monitor the time since the
last oil change. Change your ve-
hicles oil if it has been 12 months
since your last oil change even if
the oil change indicator message
is NOT illuminated.
 Under no circumstances should
oil change intervals exceed
12,000 km or 12 months, which-
ever comes first.
Your authorized dealer will reset the
oil change indicator message after
completing the scheduled oil change.CAUTION!
Failure to perform the required
maintenance items may result in
damage to the vehicle.
Thousands Of Kilometers 24 48 72 96 120 144 168 192 Months 12 24 36 48 60 72 84 96
Inspect and replace PCV valve if necessary. 
Check battery charge status and possibly recharge.        
Check tire condition/wear and adjust pressure, if necessary.        
Check operation of lighting system (headlamps, direction
indicators, hazard warning lights, luggage compartment,
passenger compartment, glove compartment, instrument
panel warning lights, etc.).        
Check operation of windshield washer system and adjust jets if
necessary.        
222

Thousands Of Kilometers 24 48 72 96 120 144 168 192Months 12 24 36 48 60 72 84 96
Check windshield/rear window wiper blade position/wear.        
Check cleanliness of hood and tailgate locks and cleanliness
and lubrication of linkages.        
Visually inspect condition of: exterior bodywork, underbody
protection, pipes and hoses (exhaust - fuel system - brakes),
rubber elements (boots, sleeves, bushes, etc.).        
Check conditions and wear of front disc brake pads.        
Check conditions and wear of rear disc brake pads.        
Check and, if necessary, top up fluid levels (brakes, windshield
washer, battery, engine coolant, etc.).        
Visually inspect the condition of accessory drive belt/s. 
Check the handbrake lever stroke and adjust it, if necessary. 
Check exhaust gas emissions.        
Check engine management system operation (via diagnostic
socket).        
Change the automatic transmission fluid and filter. (*) 
Replace spark plugs. 
Replace air filter cartridge. 
Change engine oil and replace oil filter.**
Change brake fluid (or every 24 months). 
Replace pollen filter.        
(*) Change the automatic transmis-
sion fluid and filter(s) at 96 kkm or
48 months if using your vehicle for
any of the following: city driving, short (less than 7-8 km) and repeated
journeys, or frequent trailer or cara-
van towing.
** The engine oil and the oil filter
must be changed when the instrument
panel warning light comes on or in
any case every 12 months.
223

Periodic Checks
Every1,000 km or before long jour-
neys, check and, if necessary, restore:
 engine coolant;
 brake fluid;
 Power Steering Fluid;
 windshield washer fluid level;
 power steering fluid;
tire inflation pressure and condition; operation of lighting system (head- lights, direction indicators, hazard
warning lights, etc.);
 operation of windshield washer/ wiper system and positioning/wear
of windshield/rear window wiper
blades.
Every 3,000 km, check and top up, if
required, the engine oil level. Heavy-Duty Use Of The Car
If the car is used mainly under one of
the following conditions:
 towing a trailer or caravan;
 dusty roads;

short, repeated journeys (less than
7-8 km) at sub-zero outside
temperatures; engine often idling or driving long
distances at low speeds or long pe-
riods of idleness.
You should perform the following in-
spections more frequently than shown
on the Scheduled Servicing Plan:
 check front disc brake pad condi- tions and wear;
 check cleanliness of hood and trunk locks, cleanliness and lubrication of
linkage;  visually inspect conditions of: en-
gine, transmission, pipes and hoses
(exhaust - fuel system - brakes) and
rubber elements (boots - sleeves -
bushes - etc.);
 check battery charge and battery fluid level (electrolyte);
 visually inspect condition of the accessory drive belts;
 check and, if necessary, change engine oil and replace oil filter;
 check and, if necessary, replace pol- len filter;
 check and, if necessary, replace air cleaner.
224