2013 Citroen C4 PICASSO light

210
Visibility
To make your approach to the vehicle easier,
these illuminate:


- the zones facing the driver’s and
passenger’s doors,

- the zones forward of the door mirrors andrearward of the front doors.


Door mirror spotlamps


Switching on

The spotlamps come on automatically:


- when you unlock the vehicle,

- when you remove the electronic key from the reader,

- when you open a door,

- when you use the remote control to locate the
vehicle.




Switching off

They go off automatically after 30 seconds.

Exterior welcome lighting


Switching on
)
Press the open padlock on the
remote control or one of the front
door handles with Keyless Entry
and Star ting.
The dipped beam headlamps
and the sidelamps come on; your
vehicle is also unlocked.




Programming
Daytime running lamps
(LEDs)
They come on automatically when the engineis star ted, when the lighting control stalk is in position "0" or " AUTO".

In some weather conditions (e.g. low
temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.
The remote switching on o
f the lighting makesyour approach to the vehicle easier in poor
light. It is activated when the lighting control
is in the "AUTO" position and the level of light
detected by the sunshine sensor is low.



Switching off

The activation, deactivation and choice of
welcome lighting duration are done in the
" Driving assistance" menu then "Vehicle
settings". The exterior welcome li
ghting switches off
automatically after a set time, when the ignition
is switched on or on locking the vehicle.

212
Visibility








Cornering lighting
With dipped or main beams, this system makes use of the beam from a front foglamp to
illuminate the inside of a bend, when the vehicle speed is below 25 mph (approximately 40 km/h)(urban driving, winding road, intersections, parking manoeuvres...).w
ith cornering lighting
without cornering lighting

Switching on

This system starts:


- when the corresponding direction indicator
is switched on,
or

- from a cer tain angle of rotation of the steering wheel.


Switching off

The system does not operate:


- below a cer tain angle of rotation of thesteering wheel,

- above 25 mph (40 km/h),

- when reverse gear is engaged.

The cornering lighting can be activated or deactivated in the "Driving assistance menu"menu, then "Vehicle settings".

213
5
Visibility








Directional lighting
on, this system allows the light beams to better
follow the road.
The use of this system, coupled with the
xenon headlamps and the cornering lighting,considerably improves the quality of your lighting round bends.
w
ith directional lighting
without directional lighting

Operating fault

This system is inactive:


- when stationary or at low speeds,

- when reverse is engaged.

If a fault occurs, this warning lamp flashes
in the instrument panel, accompanied by
a message in the screen.
Contact a CITROËN dealer or a qualified
workshop.

The directional li
ghting can be activated or deactivated via the " Driving aids" menu, then
"Vehicle settings".

219
5
Visibility






Courtesy lamps
1.Front courtesy lamp2.Front map reading lamps 3.Rear cour tesy lamp4.Rear map reading lamp s
Front - rear courtesy lamps
)
With the ignition on, press thecorresponding switch.


Front - rear map reading
lamps
With the "permanent lighting" mode, the lightingtime varies according to the circumstances:


- with the ignition off, approximately ten minutes,

- in energy economy mode, approximatelythirty seconds,

- with the engine running, unlimited.


In this position, the courtesy lamp comes on gradually:
Permanentl
y off.

Permanent lighting. - when the vehicle is unlocked
,
- when the electronic key is removed from
the reader,
- when opening a door,
- when the remote control locking button is
activated, in order to locate your vehicle.
It switches o
ff gradually:
- when the vehicle is locked,
- when the i
gnition is switched on,
- 30 seconds after the last door is closed.


Take care to avoid leaving anything in contact with the courtesy lamps.

Dependin
g on
version, you canalso switch the courtesy lamp on or
off by pressing thisbutton.

220
Visibility














Panoramic sunroof
)Rotate the control Ato slide the roof blindto the desired position (positions 1
to 4 ).



Closing the roof blind
Anti-pinch
It is fitted with an electrically controlled blind.
Opening the roof blind
)
Rotate the control A
to position 0
to closethe roof blind.

The blind has an anti-
pinch function. At the end of its travel, when the blind encounters an obstacle on closing, it stops andmoves back slightly.
Following a fault or after a batterydisconnection during the movement of the blind
or after it has stopped, you must re-initialise the
anti-pinch function:)place the blind in the closed position,)press control knob Bfor approximatelytwo seconds.

221
5
Visibility








Interior mood lighting

The dimmed passenger compar tment lighting improves visibility in the vehicle when the light is poor.
The interior mood lighting can be activatedor deactivated via the "Driving assistance
"
menu, then " Vehicle settings ".

The soft li
ghting provided by the footwell lamps
improves visibility in the vehicle when the light
is poor. At night, the lighting of the dashboard, centre console, cour tesy lamp... come on
automatically when the sidelamps are switched
on.
The interior mood lighting switches off
automatically when the sidelamps are switched off.

Switching on






Foot well lighting


Activation

Its operation is identical to that of the cour tesy
lamps. The lamps come on when one of the doors is opened.

222
Safety











Direction indicators
)Left: lower the lighting stalk passing thepoint of resistance.)Right: raise the lighting stalk passing the point of resistance.
Three fl ashes of the directionindicators
)Press briefly upwards or downwards,
without going beyond the point of resistance; the direction indicators will flash 3 times.









Hazard warning lamps

A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.)
Press this button, the direction indicatorsflash.
They can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lampscome on automatically.
The
y switch off automatically the first time youaccelerate. )
You can also switch them off by pressing
the button.





Horn
Audible warning system to alert other road
users to an imminent danger.)Press the central part of the steering
wheel.

Use the horn moderately and only in the following circumstances:


- immediate danger,

- over taking a cyclist or pedestrian

- approaching a location lacking
visibility.

228
Safety
Intelligent traction control
s
ystem ("Snow motion")
When this warning lamp comes on,coupled with the STOPwarning lamp,
accompanied by an audible signal and a
message, it indicates that there is a fault
with the electronic brake force distribution(EBFD), which could cause loss of control of the vehicle when braking.

Operation
When this warning lamp comes on,
accompanied by an audible signaland a message, it indicates that there
is a fault with the ABS, which could cause loss of control of the vehicle
when braking.
Your vehicle has a system to help driving onsnow: intelligent traction control.This system detects situations of difficult surface adhesion that could make it difficult to move off or make progress on deep fresh snow
or compacted snow.
In these situations
, the intelligent traction control limits the amount of wheel slip to provide the best traction and trajectory controlfor your vehicle.
In extremely severe conditions (deep snow,mud, ...), when it proves impossible to move off,
it may be useful to temporarily deactivate theESP/ASR systems to allow the wheels to spin
freely and so allow movement of the vehicle.
The use o
f snow tyres is strongly recommended on sur faces offering low levels of adhesion.

Anti-lock braking system (ABS)
and electronic brake force
distribution
(EBFD)

When changing wheels (tyres and rims),make sure that these are approved for your vehicle.
Normal operation of the ABS may make itself felt by slight vibrations of the brake pedal.
In emergency braking, press very firmly without releasing the pressure.
You must stop as soon as it is safe to do so.
In both cases, contact a CITROËN dealer or a qualified workshop.