2013 Citroen C4 PICASSO glove box

10
Familiarisation
Interior
1.
Bonnet release lever.2.
Fusebox.3.
Steering wheel adjustment controls. 4.
Door mirror controls.Electric window controls.5.
Side adjustable air vents.Side window demisting vents.
6.Quar ter light demisting windows.
7
. Driver's airbag.
Horn. 8.Courtesy lamp and map reading lamps. 9. Panoramic glass roof panel blind control. 10.CITROËN Localised Emergency Call - CITROËN Localised Assistance Call(depending on country of sale).11.
Windscreen demisting/defrosting vent.12.Scented air freshener.13.Central adjustable air vents.14.Passenger's airbag. 15.
Glove box.16.
Central storage.
Audio sockets, 12V accessory socket (120 W max), 230V socket (120 W max).17.Storage below steering wheel (handbookpack). 18.Gear lever (manual gearbox). 19. Console (fixed/removable).
20.
Storage or rear multi-media.
Rear 12 V accessory socket (120 W max.).

117
3
Comfort
The recharge for the air freshener consists of a cartridge B
and its sealed container C.)Remove the protective film D
. )Place the head of the car tridge B
on thebutton A
of the air freshener. )Rotate it a quar ter turn to lock it on thebutton and remove the container.)Inser t the air freshener into its housing.
You can change car tridges at any time, keepingthe used cartridges in their original containers.


Replacing a cartridge
The air freshener button A
is independent of
the car tridge. Cartridges are supplied without
the air freshener button A
.
The button of the air freshener Acan only be
fitted to the centre of the dashboard with acartridge attached.
Therefore always keep the air freshener button A and one car tridge. Replacement car tridges are available,
depending on country, either on the Internet
site or from a CITROËN dealer or a
qualifiedworkshop.
Locations are provided in the glove box for
storing cartridges and containers.
Air freshener button

For safety, use only cartridges that areprovided for this purpose.
Retain the containers for storing used cartridges.
Do not recharge or dismantle the cartridges.
Keep them out of reach of children and animals. Avoid all contact with the skin and with the eyes.
In the event of ingestion, consult a doctor and show them the productpackaging or label.
Do not install or remove a car tridge while you are driving.

118
Comfort























Front fi ttings

Sun visor. 2.
Card holder.3.
Glove box.4.
Central storage. It contains the power and audio sockets. 5.
Raised console with closed storage, lowconsole or removable console.
6.Cup holder.
7. Door pockets. 8.Storage below the steering wheel. (Handbook pack).

119
3
Comfort











Sliding sun visor

Sliding blinds are provided for your protection
against bright sunlight. They can be adjusted manually.)Slide the blind to the desired position by pushing at A.
Sun visor rails











Glove box


Depending on equipment, it may contain a CD
player. ) To open the glove box, raise the handle.
It is illuminated when the lid is opened.
It is cooled by a manual directional ventilation
nozzle.
It is connected directly to your vehicle's air conditioning system and is supplied with cool
air whatever the temperature setting for the
passenger compartment.
The refrigeration of your glove box operates only with the engine running and the air conditioning on. Th
e blinds are extended on the sun visor rails.
Fold the visor downwards, to protect against dazzle to the face.
If dazzle is coming from the side windows,
detach the visor from its housing above the centre of the windscreen and pivot it to the side.
The visors are fitted with a locking system on
their central housing when the blind is reeled in.
To detach the visor or to reposition it, it must be
in a ver tical position.

Sliding blinds
Do not attach or suspend heavy objects on the slide rail of the sun blind.

236
Safety

Deactivation

Only the passenger's front airbag can bedeactivated. )With the ignition off
, inser t the key in thefpassenger airbag deactivation switch. )
Turn it to the "OFF"position. )
Remove the key keeping the switch in the
new position.
When the ignition is on, this warning lamp comes in the instrument panel. It stays on while the airbag isdeactivated.


To assure the safety of your child, the passenger's front airbag must bedeactivated when you install a "rear facing" child seat on the front passenger seat. Other wise, the child would risk being seriously injured or killed if the airbagwere deployed.

Reactivation
When you remove the child seat, with theignition off, turn the switch to the f"ON"position to reactivate the airbag and so assure
the safety of your front passenger in the event
of an impact.
Front airbags
Deployment
The airbags are deployed, except the passenger's
front airbag if it is deactivated, in the event of aserious front impact to all or part of the front impact
zone A, in the longitudinal centreline of the vehicle
on a horizontal plane and directed from the front to
the rear of the vehicle.
The
front airbag inflates between the thorax andhead of the front occupant of the vehicle and the steering wheel, driver's side, and the dashboard,passenger's side to cushion their for ward movement.
System which protects the driver and frontpassenger in the event of a serious front impact
in order to limit the risk of injury to the head and
thorax.
The driver's airbag is fitted in the centre of the steering wheel; the front passenger's airbag is fitted in the dashboard above the glove box.
When the i
gnition is switched on,
this warning lamp comes on in the
instrument panel for approximately
one minute to signal that the front
airbag is activated.

268
Practical information














Changing a wheel
The tools are installed in the boot under the
floor.
Remove the boot carpet for access to them.
Access to the tools

List of tools *



Procedure for changing a faulty wheel for the spare wheel using the tools provided with the vehicle.

*
According to equipment.
All of these tools are specific to your
vehicle and can vary according to the level
of equipment. Do not use them for other
purposes. 1. Wheelbrace.
For removing the wheel trim and removingthe wheel bolts. 2.Chocks for immobilising the vehicle (except
versions with manual gearbox). 3.Jack with integral handle.
For raising the vehicle.4. Wheel bolt cover removal tool.
For removing the finishers on the heads of
the wheel bolts on alloy wheels.
5. Socket for the security bolts (located in the glove box).
For adapting the wheelbrace to the special
"security" bolts.

270
Practical information
*
Depending on version. The complete tooling
is with the spare wheel.











Changing a wheel Procedure for changing a wheel with a punctured tyre by the spare wheel using the tools provided with the vehicle.
Some of the tools are accessible from inside
th
e boot. The wheel chocks 2as well as thewheelbrace extension 6are stowed under theright hand boot sill.The wheelbrace 1
and the towing eye 7
arestowed under the left hand boot sill.The other tools, the jack 3
and the tool for removing the wheel bolt head finishers for alloy
wheels 4 , are stowed in a box attached to thespare wheel. The assembly is secured under
the vehicle in a carrier. See the "Access to thespare wheel" section).
Access to the vehicle's tools *
2.Wheel chocks for immobilising the vehicle
(except versions with manual gearbox).3.Jack with integral handle.
For raising the vehicle.4. Wheel bolt head cover removal tool.
For removing the wheel bolt head finishers
on alloy wheels.
5. Socket for the security bolts (stowed in the glove box).
For adapting the wheelbrace to the specialsecurity bolts.
6.Wheelbrace extension.
For unscrewing/tightening the spare wheelcarrier drive.
7. To w i ng eye.


Wheel with trim
When removing the wheel
, detach the trimfirst using the wheelbrace 1
pulling at the valvepassage hole.
When refitting the wheel
, refit the trimstarting by placing its notch facing the valve
and press around its edge with the palm of your hand.



List of tools *

All of these tools are specific to your vehicle
and can var
y according to equipment. Do not use them for other purposes. 1.Wheelbrace.
For removing the wheel trim and the wheelfixing bolts.

340
02


Volume adjustment (each source is
independent, including Traffi c announcements(TA) and navigation instructions).
Selectin
g the audio source (depending on version):
- "FM"
/ "AM" / "DAB" * radio wavebands.
- "USB" memor
y stick.
-
CD player (located in the glove box) *
.
- Jukebox
*
, after fi rst copying audio fi les to the internal memory of the touch screen tablet.
- Telephone connected by Bluetooth and Bluetooth audio streaming.
- Media pla
yer connected to the auxiliary socket (jack, cable not supplied).

The screen is of the "resistive" t
ype, it is necessary to press fi rmly, particularly for "fl ick" gestures (scrolling through a list, moving the map...).
A simple wipe will not be enough. pressing with more than one fi nger is not recognised.
The screen can be used when wearin
g gloves. This technology allows use at all temperatures.
FIRST STEPS

*
Depending on equipment. To clean the screen, use a so
ft non-abrasive cloth (spectacles cloth) without any additional product.
Do not use pointed ob
jects on the screen.
D
o not touch the screen with wet hands.
Following prolonged operation in
sunny conditions, the volume may be limited to protect the system. Thereturn to normal takes place when
the temperature in the passenger compartment drops.