2013 Citroen C4 PICASSO ignition

79
2
Access
For all work on the alarm system,contact a CITROËN dealer or a qualified workshop.





Alarm System which protects and provides a deterrent against theft and break-ins. It provides the following types of monitoring:


- Exterior perimeter

The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...




- Interior volumetric

The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
Self-protection function
The system checks for the
disconnection of any of its components. The alarm is triggered if the battery,the button or the wires of the siren aredisconnected or damaged.


Locking the vehicle with full
alarm system

Activation


If an opening (door, boot, bonnet...) is not closed fully, the vehicle is not locked but theexterior perimeter monitoring will be activated
after a delay of 45 seconds, at the same time
as the interior volumetric monitoring.
)Lock the vehicle using the remote control.
)Switch off the ignition and get out of the vehicle.
or )
Lock the vehicle using the "Keyless Entry
and Starting" system.


The monitorin
g system is active: the indicator
lamp in the button flashes once per second and
th
e the direction indicators come on for about
2 seconds.
After an instruction to lock the vehicle lockedusing the remote control or the Keyless Entry
and Starting system, the exterior perimeter
monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring
after 45 seconds.

80
OFF
Access

Locking the vehicle
with exterior
perimeter
monitoring only
Deactivate the interior volumetric monitoringto avoid unwanted triggering of the alarm incertain cases such as:


- leaving a window par tially open,

- washing your vehicle,

- changing a wheel,


Deactivation of the volumetric monitoring
)
Switch of the ignition and within
ten seconds press this button until its indicator lamp is on fixed.
)Get out of the vehicle. )Immediately lock the vehicle using theremote control or the "Keyless Entry and Starting" system.
Only the exterior perimeter protection system is
active: the indicator lamp in the button flashes
once per second.
To be e
ffective, this deactivation must be doneevery time the ignition is switched off.
In the case of automatic locking of the vehicle (which occurs after a period of 30 seconds if a door or the boot is notopened), the monitoring system is not reactivated automatically. To reactivate it, it is necessary to unlock the vehicleand lock it again, using the remote control or the "Keyless Entry and Starting" system.

Deactivation
)Press one of the unlocking buttons on theremote control:
short press
long press
or )Unlock the vehicle using the "Keyless Entryand Starting" system.
The monitoring system is deactivated: the
indicator lamp in the button is off and the
direction indicators flash for about 2 seconds.

81
2
Access

Reactivation of the interior volumetric monitoring
)Deactivate the exterior perimeter monitoring by unlocking the vehicle usingthe remote control or the Keyless Entry andStarting system.
The indicator lamp in the button goes off.
)Reactivate the full alarm system by locking
the vehicle using the remote control or the
"Keyless Entry and Star ting" system.
The indicator lamp in the button flashes once
per second again.
Tr iggering of the alarm
This is indicated by sounding of the siren and flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.When the vehicle is unlocked using the remotecontrol or the Keyless Entry and Startingsystem, rapid flashing of the indicator lampin the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops immediately.
Failure of the remote control
To deactivate the monitoring functions:
) Unlock the vehicle using the key (integral
with the remote control) in the driver's door lock. ) Open the door; the alarm is triggered. )
Switch on the ignition; the alarm stops. The
indicator lamp in the button goes off.




Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key (integral with the remote control) in thedriver's door lock.




Operating fault


When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault in the system.
Have it checked by a CITROËN dealer or a qualified workshop.



Automatic activation *



2 minutes after the last door or the boot is closed, the system is activated automatically. )
To avoid triggering the alarm on enteringthe vehicle, first press the unlocking button on the remote control or unlock the vehicleusing the Keyless Entry and Starting system.

* Accordin
g to country.

82
Access





Electric windows

To open or close the window, press or pull the
switch gently. The window stops as soon as the switch is released.


Safety anti-pinch

When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening of the
window on closing, press the switch until the
window opens completely, then pull the switchimmediately until the window closes. Continue
to hold the switch for approximately one secondafter the window has closed.
The safety anti-pinch function is not active
during this operation.
1.Left hand front electric window.2.Right hand front electric window.3.Right hand rear electric window.4.Left hand rear electric window.5.Deactivating the electric window
switches located at the rear seats
.


Automatic operation

To open or close the window, press or pull
switch fully: the window opens or closescompletely when the switch is released. Pressing the switch again stops the movementof the window.

The electric window switches remain
operational for approximately 45 seconds after
switching off the ignition.
Once this time has elapsed, the electric
windows will not operate. To reactivate them,
switch the i
gnition on again.

87
3
Comfort
System which registers the electrical settings of the driver's seat and door mirrors. It enables you to store and recall two positions using the buttons on the side of the driver's seat.
Storing driving positions
Storing a position
Usin
g buttons M / 1 / 2
) Switch on the ignition. )
Adjust your seat and the door mirrors. )
Press button M
, then press button 1or 2
within four seconds.
An audible signal indicates that the position
has been stored.
Storing a new position cancels the previousposition.

Recalling a stored position

I
gnition on or engine running
)
Press button 1or 2to recall the corresponding position.
An audible signal confirms that adjustment
is complete.
You can interrupt the current movement b
ypressing button M, 1
or 2
or by using one of theseat controls.
A stored position cannot be recalled while driving.
Recalling stored positions is deactivated
45 seconds after switching off the ignition.

101
3
Comfort





Mirrors
Adjustment
)
Move control A
to the right or to the left to select the corresponding mirror. )
Move control B
in all four directions to
adjust.
) Return control Ato the central position. Each fitted with an ad
justable mirror glass providing the lateral rear ward vision necessaryfor overtaking or parking. They can also be folded for parking in confined spaces.


Demisting - Defrosting


Door mirrors
Demisting-defrosting of the door
mirrors operates with the enginerunning, by switching on the heated rear screen (refer to the "Rear screen
demist-defrost" section).
The objects observed are, in reality,
closer than they appear. Take this into account in order to correctly judge the distance of vehicles approaching from behind.




Folding
)
From outside: lock the vehicle using the electronic key or the Keyless Entry and Starting system. )
From inside: with the ignition on, pull thecontrol Ain the central position rearwards.
If the mirrors are folded using control A,they will not unfold when the vehicle isunlocked. Pull again on control A.
The folding and unfolding of the door mirrors using the remote control can be deactivated by a CITROËN dealer or aqualified workshop.
)
From outside: unlock the vehicle using the electronic key or the Keyless Entry and Starting system. )
From inside: with the ignition on, pull thecontrol Ain the central position rearwards.
Unfolding
If necessary, it is possible to fold the mirrors manually.

109
3
Comfort




















Dual-zone digital air conditioning

This air conditioning system operates with the engine running, but the ventilation and its controls
are available with the ignition on.
Operation of the air conditioning and regulation of temperature, air flow and air distribution in the passenger compartment are automatic.
Press the button for the " Air conditioning" menu to display the controls for the air conditioningsystem.


Temperature adjustment
1.
Automatic mode. 2.Driver's side temperature adjustment.3.Passenger's side temperature adjustment. The driver and
front passenger can each set
t
he temperature.
)Press one of these buttons
to increase the value.
)Press one of these buttons
to decrease the value.

The value indicated corresponds to a level of
comfor t and not to a precise temperature.
It is recommended that
you avoid a left /right setting difference of more than 3.
Dependin
g on the colour scheme chosen, the system controls page is displayed differently:
4.
Air conditioning On / Off.
5. Air distribution adjustment.6.
Air flow adjustment. 7.
Air intake / air recirculation.

114
Comfort
Front Demist - Defrost

)
Press this button to demist or defrost the windscreen and side
windows as quickly as possible.
The indicator lamp in the button
comes on.
With Stop & Star t, when demisting hasbeen activated, the STOP mode is notavailable. The s
ystem automatically manages the air
conditioning, air flow and air intake, and provides optimum distribution towards the
windscreen and side windows. )To switch it off press this button, the
indicator lamp goes off.


Ventilation with ignition on
function
With the ignition on, you can use the
ventilation system and have access to the " Airconditioning " menu to adjust the air flow and air distribution in the passenger compartment.
This function is available for a few minutes,
dependin
g on the state of charge of the battery
of your vehicle.
Thi
s function does not activate the air conditioning.
You can make use of the residual heat in theengine to warm the passenger compar tment
using the temperature setting buttons.