2013 Citroen C3 PICASSO RHD instrument panel

Safety
118
Seat belt not fastened / unfastened warning lamp display
1. Front and/or rear seat belts not fastened / unfastened warning lamp. 2.
Front left seat belt warning lamp. 3.Front right seat belt warning lamp. 4.
Rear right seat belt warning lamp. 5.
Rear centre seat belt warning lamp.
6.Rear left seat belt warning lamp.


Rear seat belts

The rear seats are each fitted with a three-point
iner tia reel seat belt with force limiter (with the exception of the rear centre seat).

Locking
When the rear side side belts are not being used, you can lock them in place. To do so:)
Raise the grip Ato its maximum height.



Fastening
)
Pull the strap, then inser t the tongue in the buckle. )
Check that the seat belt is fastened correctly by pulling the strap.


Unfastening
)
Press the red button on the buckle. )
Guide the seat belt as it rolls up.

The correspondin
g warning lamp 2 or 3
comes
on in red on the seat belt and passenger's front airbag warning lamp display if the seat belt isnot fastened or is unfastened.



Seat belt unfastened warninglamp

This warning lamp comes on,either on the instrument panel or
on the seat belt and passenger's
front airbag warning lamp display, when one or more rear passengers unfasten their seat belt.
From approximatel
y 12 mph (20 km/h),
this warning lamp flashes for two minutes
accompanied by an audible signal of increasingvolume. Once these two minutes have elapsed,
this warning lamp remains on until the one or more rear passengers fasten their seat belt.

Safety
122

Operating fault

If this warning lamp comes on in the
instrument panel, accompanied by
an audible warnin
g and a message
in the multifunction screen, contact
a CITROËN dealer or a qualified
workshop to have the system checked. The airbags may no longer be deployed
in the event of a serious impact.

Reactivation

When you remove the rear wards-facing child
seat, turn switch 1to the "ON"
position toreactivate the airbag and so assure the safety
of your front passenger in the event of an
impact.
With the ignition on, this warning lampcomes on in the instrument panel
or in the seat belt and passenger's front airbag warning lamp displayfor approximately one minute, if thepassenger's front airbag is activated. According to version, this warning lamp comes on either in the
instrument panel or on the seat belt
and passen
ger's front airbag warninglamp display when the ignition is on
and until the airbag is reactivated. If this warnin
g lamp flashes, contact
a CITROËN dealer or a qualified
workshop. The passenger's front
airbag may no longer be deployed in
the event of a serious impact.
Deactivation
Only the passenger's front airbag can be deactivated:)with the ignition off, inser t the key in thefpassenger airbag deactivation switch 1 , )turn it to the "OFF"position,)then, remove the key keeping the switch in
this position.
To assure the safety of your child, it isimperative that the passenger's front
airbag is deactivated when you install a "rearwards-facing" child seat on thefront passenger seat. Other wise, the child would risk beingseriously injured or killed if the airbag were deployed.

If at least one of the two airbag
warning lamps come on continuously, do not install a child seat on the front passenger seat.
Have it checked by a CITROËN dealer or a qualified workshop.

8
Safety
123
Lateral airbags

Deployment

The lateral airbags are deployed unilaterally in
the event of a serious side impact applied to all
or par t of the side impact zone
B , perpendicular
to the longitudinal centreline of the vehicle on a horizontal plane and directed from the outside
towards the inside of the vehicle.
The lateral airbag inflates between the hip andshoulder of the front occupant of the vehicle
and the corresponding door trim panel.
Curtain airbags
System which protects the driver and passengers (with the exception of the rear centre passenger) in the event of a serious side impact in order to limit the risk of injury to the side of the head.
Each curtain airbag is built into the pillars and
the upper passenger compar tment area.

Operating fault
Deplo
yment

The cur tain airbag is deployed at the same
time as the corresponding lateral airbag in the event of a serious side impact applied to all or
part of the side impact zone B , perpendicular
to the longitudinal centreline of the vehicle on a
horizontal plane and directed from the outside
towards the inside of the vehicle.
The cur tain airbag inflates between the front or
rear occupant of the vehicle and the windows.
Impact detection zones
A. Front impact zone.B.
Side impact zone.

If this warning lamp comes on in the
instrument panel, accompanied by anaudible signal and a message in the
screen, contact a CITROËN dealer
or a qualified workshop to have the
system checked. The airbags may nolonger be deployed in the event of a
serious impact.
In the event of a minor impact or bump on the side of the vehicle or if the vehicle rolls over, the airbag may not be
deployed.
In the event of a rear or front collision, the airbag is not deployed.

System which protects the driver and frontpassenger in the event of a serious side impact
in order to limit the risk of in
jury to the chest,
between the hip and the shoulder.
Each lateral airba
g is fitted in the seat backrestframe, door side.

Driving
126











Gear effi ciency indicator *
Operation
The system inter venes only when driving economically.Depending on the driving situation and your
vehicle's equipment, the system may advise you to skip one or more gears. You can follow this instruction without engaging the
intermediate gears.
The gear engagement recommendations mustnot be considered compulsory. In fact, the configuration of the road, the amount of trafficand safety remain determining factors whenchoosing the best gear. Therefore, the driver remains responsible for deciding whether or not
to follow the advice given by the system.
This function cannot be deactivated.
Example:


- You are in third
gear.
The information appears in the instrument panel in the form of an arrow accompanied bythe suggested gear.
* Accordin
g to engine.
- You press the accelerator pedal
moderatel
y.

- The s
ystem may suggest that you engage a
higher gear, if appropriate.

In the case of driving which makespar ticular demands on the performance of the engine (firm pressure on theaccelerator pedal, for example, whenover taking...), the system will notrecommend a gear change.
The system never suggests:


- engaging first gear,

- engaging reverse gear,

- engaging a lower gear. S
ystem which reduces fuel consumption by advising the driver to change up on vehicles
fitted with a manual gearbox.

Driving
128
Display in the instrument panel
Gear lever positions
N. Neutral R. Reverse1, 2, 3, 4, 5, 6. Gears in manual mode. AUTO.
This comes on when the automatedmode is selected. It switches off on changing to manual mode.


Moving off
)
Select position N.)
Press the brake pedal down fully.
)
Start the engine.
Nappears in the instrument panel screen.
)
Select automated mode (position A
) or Amanual mode (position M ) or reverse(position R
).R)
Release the parking brake.)
Progressively take your foot off the brake
pedal.
) Accelerate away.
AUT
Oand 1 , 1 or Rappear in the instrument
panel screen.

Automated mode
)Select position A.
AUTOand the gear engaged appear
in the instrument panel screen.
The
gearbox operates in auto-active mode,
without any action on the par t of the driver. Itcontinuously selects the most suitable gear for:


- optimisation of fuel consumption,

- the style of driving,

- the profile of the road.

- the vehicle load.

For o
ptimum acceleration, for example
when over taking another vehicle, press the
accelerator pedal
firmly past the point of
resistance.
You must press the brake pedal whenstarting the engine.


Never select neutral N
when driving.
N
flashes in the instrument panel, accompanied by an audible signal and a message in the multifunction screen, if the gear lever is not in position Non starting.
A message is displayed in the screen, if the brake pedal is not pressed on starting the engine.


You can change mode at any time bymoving the gear lever from A
to Mor the other way round.

9
Driving
129
) Select position M.
To engage reverse gear R
, the vehicle must be
immobilised with your foot on the brake pedal.
) Select position R.

At very low speed, if reverse gear is requested,
this will only be acted on when the vehicle is
immobilised.
At high speed, if reverse gear is requested,
the N indicator flashes and the gearbox goes into neutral. To engage a gear again, put thegear lever in position A
or M.


Te m p o r a ry control of gear changing

You can temporarily take over control of gear changing using the "+"and "-"
steering mounted paddles: if the engine speed allows,
the request to change gear is acted on.
This function allows you to anticipate cer tain situations such as over taking a vehicle or the
approach to a corner.

After a few moments without any action on
the control paddles, the gearbox resumes
automatic control of the gears. The
gears engaged appear in
succession in the instrument panelscreen.
The
gear change requests are only acted on if
the engine speed permits.It is not necessary to release the accelerator
during gear changes.
When brakin
g or slowing down, the gearbox changes down automatically to allow the
vehicle to accelerate in the correct gear. On sharp acceleration, the gearbox will notchange up unless the driver acts on the gear lever or the steering mounted paddles.
Never select neutral Nwhile the vehicle is moving.
You can change mode at any time, bemoving the gear lever from M to A
or the other way round.

Engagement of reverse gear isaccompanied by an audible signal.
Manual mode
Reverse

9
Driving
131





Hill start assist
(with the 6-speed
electronic gearbox
system)
System which holds your vehicle temporarily (approximately 2 seconds) when star ting on a slope, the time it takes to move your foot from
the brake pedal to the accelerator pedal.
This function is onl
y active when:


- the vehicle is completely stationary, with your foot on the brake pedal,

- certain conditions on a slope are met,

- with the driver’s door closed.
The hill start assist function cannot bedeactivated.On an ascendin
g slope, with the vehicle
stationar y, the vehicle is held momentarily
when
you release the brake pedal:- provided you are in automated mode(position A) or in manual mode (position AM )
on an electronic gearbox.On a descendin
g slope, with the vehicle
stationar y and reverse gear engaged, the
vehicle is held momentarily when you
release the brake pedal.

Operating fault

If a malfunction of the system occurs, these
warning lamps come on. Contact a CITROËN
dealer or a qualified workshop to have the system checked.
Do not leave the vehicle while it is being held in the hill star t assist phase. If you need to leave the vehicle withthe engine running, manually applythe parking brake then ensure that the parking brake warning lamp is on (not flashing) in the instrument panel.
Operation

Driving
132








Stop & Start The Stop & Star t system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restar ts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
- with the 6-speed electronic
gearbox
system, at speeds below 5 mph (8 km/h),
when you press the brake pedal or put thegear lever in position N.
A time counter calculates thesum of the periods in STOP
mode during a journey. It rests
itself to zero every time the
ignition is switched on with thekey.

Special cases: STOP mode not available
STOP mode is not invoked when:


- the driver's door is open,

- the driver's seat belt is not fastened,

- the vehicle has not exceeded 6 mph(10 km/h) since the last engine start usingthe key,

- the engine is needed to maintain acomfortable temperature in the passenger compartment,

- demisting is active,

- some special conditions (battery charge,
engine temperature, braking assistance,ambient temperature...) where the engine isneeded to assure control of a system.

The "ECO"warning lamp flashes for
a few seconds then goes off.
This operation is per fectly normal.
Never refuel with the engine in STOPmode; you must switch off the ignition with the key.
For your comfor t, during parkingmanoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...