2013 Citroen C3 PICASSO RHD instrument panel

3
Comfort
49
In order for these systems to be fully effective, follow the guidelines on operation andmaintenance below:)
If the interior temperature remains very high after the vehicle has been parked in
the sun for a considerable time, first ventilate the passenger compartment for a few minutes. Place the air flow control at a sufficient level to provide an adequate renewal of air in the passenger compartment.)
To obtain an even air distribution, take care not to obstruct the exterior air intake grilleslocated at the base of the windscreen, the nozzles, the vents and the air outlets, as well as the air extractor located in the passenger compar tment on both sides of the rear shelf. )
Do not cover the sunshine sensor, located on the dashboard (behind the instrument panel) ; this is used for regulation of the air conditioning system.)
Operate the air conditioning system for 5 to 10 minutes, once or twice a month to keep itin good working order. )
Ensure that the passenger compartment filter is in good condition and have the filter elements replaced regularly (refer to the "Checks" section). We recommend the use of a combined passenger compartment filter. Thanks to its second special active filter, it contributes to the purification of the air breathed by the occupants and the cleanliness of the passenger compartment (reduction of allergic symptoms, bad odours and greasy deposits).)
To ensure correct operation of the air conditioning system, you are also advised to haveit checked regularly.)
If the system does not produce cold air, do not use it and contact a CITROËN dealer or a qualified workshop.

The condensation created by the air conditioning results in a dischargeof water under the vehicle which is perfectly normal.
The air conditioning system does notcontain chlorine and does not present any danger to the ozone layer.

When towing the maximum load on a steep gradient in high temperatures, switching off theair conditioning saves engine power and so improves towing capacity.
Recommendations for ventilation and air conditioning

Access
70

Reinitialisation
Deactivating the rear window and door controls
)
For the safety of your children, press switch 5to prevent operation of the rear
windows irrespective of their position.
With the indicator lamp on, the rear controls aredeactivated.
With the indicator lamp off, the rear controls are
activated.
When the
function is activated,
this warning lamp lights up on the
instrument panel for a few seconds.
This control also deactivates the interior rear door controls (see "Child safety -Electric child lock" section).
In the event of contact during operationof the windows, you must reverse the movement of the window. To do this,press the switch concerned.
When the driver operates the passenger
electric window switches, they mustensure that no one is preventing correct closing of the windows.
The driver must ensure that the passengers use the electric windowscorrectly.
Be aware of children when operating the windows.
Safety anti-pinch
The one-touch electric windows are fitted with a safety anti-pinch function.When the window rises and meets an obstacle, it stops and partially lowers again.

In the event of unwanted opening of thewindow on closing (for example in the presence of frost): )press the switch until it opens completely, )then pull it immediately until itcloses,)continue to hold the switch for approximately one second after thewindow has closed.
The safety anti-pinch function is not active during these operations.

In the event of a malfunction you must reinitialise
the o
peration of the electric windows: )release the switch and pull it again until the
window closes completely, )hold the switch for approximately onesecond after closing,
)press the switch to lower the window automatically. The safety anti-pinch function is not active
during these operations. Always remove the key from the ignition when
leaving the vehicle, even for a shor t time.

Access
76


























Fuel tank
Low fuel level
Fillin
g

A label affixed to the inside of the flap reminds you of the type of fuel to be used depending on your engine.
Wh
en the low fuel level is reachedthis warning lamp comes on in the
instrument panel. When it first comes
on there remains approximately5 litresof fuel in the tank. To fill the tank safel
y: )the engine must be switched off,)
open the fuel filler flap,
)
inser t the key in the cap, then turn it to the left,
)
remove the cap and hook it onto the clip located on the inside of the flap,)
fill the tank, but do not continue after the3rd cut- off of the pump; this could cause
malfunctions.
When
you have filled the tank: )
put the cap back in place, )
turn the key to the right, then remove itfrom the cap,
)
close the flap.

Additions of fuel must be of at least5 litres to be registered by the fuelgauge.
The key cannot be removed from the lock until the cap is refitted.
Opening the filler cap may create anoise caused by an inrush of air. Thisvacuum is entirely normal and results from the sealing of the fuel system. With Stop & Star t, never refuel with the system in STOP mode; you must switchoff the ignition with the key. Fuel tank capacit
y: approximately 50 litres (petrol) or 48 litres (Diesel); (Depending
on version: approximately 30 litres(petrol or Diesel)). For the LPG version: approximately 33 litres.
You must refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer also to the
"Checks" section.

5
Visibility
79














Lighting controls System for selection and control of the various front and rear lamps providing the vehicle's lighting.


Main lighting

The various front and rear lamps of the vehicle
are designed to adapt the driver's visibilityprogressively according to climatic conditions:


- sidelamps, to be seen,

- dipped beam headlamps to see without
dazzlin
g other drivers,

- main beam headlamps to see clearly when
the road is clear.



Additional lighting
Other lamps are installed to fulfil the
requirements of par ticular conditions of
visibility:


- a rear foglamp to be seen from afar,

- front foglamps for even better forward
vision.

Programming

Various automatic lighting control modes
are also available according to the following
options:


-
guide-me-home lighting,

- automatic illumination of headlamps.

Model without AUTO lighting


Model with AUTO li
ghting

Automatic illumination of headlamps.


Manual controls

The lighting is controlled directly by the driver
by means of the ring A
and the stalk B
.
A.Main lighting mode selection ring: turn it
to position the symbol required facing themark.
Li
ghting off / daytime running lamps.
Sidelamps.
B
.Stalk for switching headlamps: pull the stalk
towards you to switch the lighting betweendipped and main beam headlamps.
In the lamps off and sidelamps modes, the driver can switch on the main beam headlamps temporarily ("headlamp flash") by maintaining a pull on the stalk.

Dipped headlamps or main beam headlamps.


Displays

Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.

Visibility
82

Linked with the Guide-me-home
lighting
Association with the automatic illumination
of headlamps provides the guide-me-home lighting with the following additional options:


- automatic activation of guide-me-home lighting when automatic illumination of
headlamps is switched on (in the vehicle
parameters of the multifunction screen configuration menu),

- selection of the duration of maintaining of
the lighting for 15, 30 or 60 seconds in the
vehicle parameters of the multifunction
screen configuration menu (except for monochrome screen A where this is
preset).



Operating fault

In the event of a malfunction of the sunshine sensor, the lamps comeon, this warning lamp is displayed
in the instrument panel and/or a message appears
in the multifunction screen, accompanied by an audible signal.
Contact a CITROËN dealer or a qualified workshop.

In fog or snow, the sunshine sensor maydetect sufficient light. Therefore, the lamps will not come on automatically.
Do not cover the sunshine sensor,linked with the rain sensor and located in the centre of the windscreen behindthe rear view mirror; the associatedfunctions would no longer be controlled.

Automatic illumination of headlamps
The sidelamps and dipped beam headlamps areswitched on automatically, without any action on
the par t of the driver, when a low level of external
li
ght is detected or in certain cases of activation
of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.
Activation
)Turn ring Ato the A"AU TO "
position. The automatic
illumination of headlamps is accompanied by amessage in the multifunction screen.
Deactivation
)Turn ring A
to a position other
than "AUTO". Deactivation is accompanied
b
y a message in the multifunction screen.

Child safety
112





Electric child lock


Switching on
)
Press button A
.
The indicator lamp in button Acomes on, accompaniedAby a message in the multifunction screen.
This indicator lamp remains on until the childlock is switched off.


Switching off
)
Press button A
again.
The indicator lamp in button A
goes off,
accompanied by a message in the multifunction screen.
This indicator lamp remains off until the child
lock is switched on. Switchin
g the child lock on isconfirmed by the temporary
illumination of this warning lamp in
the translucent instrument panel.

Any other status of the indicator lampindicates a fault with the electric child lock. Have it checked by a CITROËN dealer or a qualified workshop.

This system is independent and in nocircumstances does it take the place of the central locking control. Check the status of the child lock eachtime you switch on the ignition.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of a serious impact, the electric child lock is switched off automatically to permit the exit of therear passengers.
Control system to prevent opening of the rear
doors using their interior controls and use of the rear electric windows.
The control is located on the driver's door,
with the electric window controls, or on the
dashboard switch panel, if
your vehicle is fitted
with m
anual rear windows.

Safety
116

Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft ground...), it may be advisable to deactivate the
ASR and ESP systems, so that the wheels can
move freely and regain grip.) Press the "ESP OFF"
button, located in
the centre of the dashboard.
If this warning lamp comes on
in the instrument panel and the
indicator lamp on the button comes
on
, this indicates that the ASR and
ESP systems are deactivated.

Reactivation

These systems are reactivated automatically each time the ignition is switched back on or
from 30 mph (50 km/h).) Press the "ESP OFF"
button again to
react
ivate them manually.

Operating fault

If this warning lamp comes on,
accompanied by an audible signal
and a messa
ge in the multifunction
screen, this indicates a malfunction
of these s
ystems.














Trajectory control systems
The anti-slip regulation (also known as Traction Control) optimises traction to prevent skidding
of the wheels, by acting on the brakes of the
driving wheels and on the engine.
The electronic stabilit
y programme acts on the
brake of one or more wheels and on the engine to
keep the vehicle on the trajectory required by the
driver, within the limits of the laws of physics.
Anti-slip regulation (ASR)
and electronic stability
programme (ESP)

This is indicated by flashing
of this warning lamp in the
instrument panel.

Activation
These systems are activated automatically each time the vehicle is started.
They come into operation in the event of a grip
or trajectory problem.
The ESP/ASR systems offer exceptionalsafety in normal driving, but this should not encourage the driver to take extra risks or drive at high speed.
The correct operation of thesesystems depends on obser vation of the manufacturer's recommendations regarding wheels (tyres and rims), braking components, electroniccomponents and assembly and repair procedures.
After an impact, have these systems checked by a CITROËN dealer or a qualified workshop.
Have it checked b
y a CITROËN dealer or a qualified workshop.

8
Safety
117

Seat belt not fastened / unfastened warning lamp Fastenin
g
) Pull the strap, then inser t the tongue in thebuckle. )
Check that the seat belt is fastened correctly by pulling the strap.



Height adjustment
)
To lower the attachment point, squeeze the control A
and slide it downwards.)
To raise the attachment point, slide thecontrol A
upwards.
When the ignition is switched on, this warning lamp comes on, either on theinstrument panel or on the seat belt andpassenger's front airbag warning lamp
display, if the driver and/or the frontpassenger has not fastened their seat belt.
Unfastening
) Press the red button on the buckle. )
Guide the seat belt as it rolls up.


Seat belts


Front seat belts


The front seat belts are fitted with apretensioning and force limiting system.
This s
ystem improves safety in the frontseats in the event of a front or side impact.
Depending on the severity of the impact, thepretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The
force limiter reduces the pressure of the seat belt on the chest of the occupant, so
improving their protection.
From approximately 12 mph (20 km/h) this warninglamp flashes for two minutes accompanied by an audible signal. Once these two minutes have
elapsed, this warning lamp remains on until the driver and/or the front passenger fastens their seat belt.