2013 Citroen C3 PICASSO ESP

Practical information
162

List of operations
)Put the wheel in place on the hub. )Screw in the bolts by hand as far aspossible.)Pre-tighten the security bolt (if your vehiclehas them) using the wheelbrace 1fitted
with the security socket 4 . )Pre-tighten the other bolts using the
wheelbrace 1only.

Refitting a wheel
After changing a wheel
To store the punctured wheel in the boot correctly, first remove the central cover. When using the "space-saver" typespare wheel, do not exceed 50 mph(80 km/h). Have the tightening of the bolts and thepressure of the spare wheel checked by a CITROËN dealer or a qualified workshop without delay. Have the punctured wheel repaired andreplace it on the vehicle as soon aspossible.

Practical information
170

Changing foglamp / reversing lamp bulbs
)
open the boot, )
press on the tabs using 2 screwdrivers, )
disconnect the lamp unit connector,
)
turn the bulb holder by a quar ter turn, )
remove the bulb and replace it.
To r efit, carry out these operations in reverseorder.


Changing the third brake lampbulbs (4 x W 5 W bulbs)
)
open the boot,)
remove the two plugs located on the bootinner panel,
)
press on the body of the lamp with
2 screwdrivers to remove it from itshousing, ) turn the corresponding bulb-holder a quarter turn,)
pull the bulb and replace it.
To r e f i t , c a r ry out these operations in reverseorder.


Changing the number plate lamp
bulbs (W5W)
)insert a thin screwdriver into one of the lens' exterior holes, )push it outwards to unclip.
)remove the lens. )pull the bulb and replace it.
To r efit, carry out these operations in reverse order.

11
Practical information
173




















Changing a fuse

The extraction tweezer and the spare fusestorage compar tment are installed on the backof the dashboard fusebox cover.
For access to them:)unclip the cover by pulling on the side,)remove the cover completely,)remove the tweezer.
Changing a fuse
Before changing a fuse, the cause of the failure
must be identified and rectified. ) Identify the faulty fuse by checking thecondition of its filament.
)
Use the special tweezer to extract the fuse
from its housing.) Always replace the faulty fuse with a fuse
of the same rating. ) Check that the number marked on thefusebox, the rating marked on the fuse and
the following tables all agree. GoodFailed
CITROËN will not accept responsibility for the cost incurred in repairing your vehicle or for rectifying malfunctions resulting from the installation of accessories not supplied and not recommended by CITROËN andnot installed in accordance with itsinstructions, in par ticular when the combined consumption of all of the additional equipment connectedexceeds 10 milliamperes.


Installing electricalaccessories
Your vehicle's electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories on your vehicle, contact a CITROËN dealer or aqualified workshop.


Access to tools

Practical information
176
Engine compartment fuses
The fusebox is placed in the engine compartment near the battery (left-hand side).

Access to fuses
)
Unclip the cover.)
Change the fuse (see correspondingparagraph).)
When you have finished, close the cover carefully to ensure the correct sealing of
the fusebox.


All work on these fuses, located on
the battery, must be carried out bya CITROËN dealer or a qualified workshop.

11
Practical information
177
Fuse table
Fuse N°RatingFunctions
F
120 AEngine control unit supply, cooling fan unit control,multifunction engine control main relay.
F
215 AHorn.
F
310 AFront / rear wash-wipe.
F4 20
ADaytime running lamps.
F
515 ADiesel heater (Diesel engine), fuel pump(petrol engine)
F
610 A ABS/ESP control unit, ABS/ESP cut-off relay,secondary stop switch.
F7
10 AElectric power steering.
F
825 AStarter motor control.
F9
10 ASwitching and protection unit (Diesel).
F10
30 ADiesel engine injection pump valve, injectors and ignition coils (petrol engine) .
F1140 A Air conditioning fan.

Practical information
178
Fuse N°RatingFunctions
F1230 A Windscreen wipers slow / fast speed.
F13
40 A Built-in systems inter face supply (ignition positive).
F14
30 A Valvetronic supply (petrol).
F1
510 A Right-hand main beam headlamp.
F1
610 A
Left-hand main beam headlamp.
F17 15 A
Left-hand dipped beam headlamp.
F18 15 A
Ri
ght-hand dipped beam headlamp.
F1
915 A Multifunction engine management supply (petrol engine),
air cooling electrovalves (Diesel).
F20 10 A Multi
function engine management supply (petrol engine),
Turbo pressure regulation electrovalve (Diesel), engine coolantlevel sensor (Diesel).
F2
15 A Fan assembly control supply, APC, ABS ESP relays.

11
Practical information
179

Table of maxi-fuses
Fuse N°RatingFunctions
MF1*60 ACooling fan assembly.
MF2*30 A ABS / ESP control unit.
MF3 * 30 A ABS / ESP control unit.
MF4 * 60 ABuilt-in Systems Interface (BSI) supply.
MF5 * 60 ABuilt-in Systems Interface (BSI) supply.
MF6 *-Not used.
MF7 *-Passenger compartment fusebox.
MF8 *
-Not used.

*

The maxi-fuses provide additional protection for the electrical systems. All work on the maxi-fusesmust be carried out by a CITROËN dealer or a qualified workshop.

Practical information
182








Energy economy mode

These functions are reactivated automaticallythe next time the vehicle is driven. )In order to resume the use of these
functions immediately, star t the engine and
let it run for a few minutes.
The time available to you will then be double
the period for which the engine is left running. However, this period will always be betweenfive and thir ty minutes.

Switching to economy mode
Once this period has elapsed, a message
appears on the multifunction screen indicating
that the vehicle has switched to economy mode
and the active functions are put on standby.
A flat battery prevents the engine from starting (refer to the corresponding paragraph).
If the telephone is being used at the same time on the eMyWay audionavigation system, it will be interrupted after 10 minutes. S
ystem which manages the period of use of certain functions to conserve a sufficient level
of charge in the battery.
After the engine has stopped, you can still use functions such as the audioequipment, windscreen wipers, dipped
beam headlamps, cour tesy lamps, etc. for a maximum combined period of thirty minutes.
This period may be greatly reduced if the
battery is not fully charged.