2013 Citroen C3 Instrument panel

Access
76


























Fuel tank
Low fuel level

When the fuel tank minimum level is
reached this warning lamp comes on on the instrument panel. When it first comes on there remains approximately5 litres
of fuel in the tank.
Filling
A label affixed to the inside of the flap remindsyou of the type of fuel to be used depending onyour engine.
Additions of fuel must be of at least 7 litres, in
order to be registered by the fuel gauge. To
fill the tank safely: )the engine must be switched off,)
open the fuel filler flap,
)
inser t the key in the cap, then turn it to the left,
)
remove the cap and hook it onto the clip located on the inside of the flap,)
fill the tank, but do not continue after the3rd cut- off of the pump; this could cause
malfunctions.
When
you have filled the tank: )
put the cap back in place, )
turn the key to the right, then remove itfrom the cap, )
close the flap.
You must refuel as soon as possible to avoid
running out of fuel.
If you run out of fuel (Diesel), refer also to the
"Checks" section. Fuel tank capacity: approximately
50 litres (petrol) or 46 litres (Diesel) or 37 litres (LPG); (Depending on version:
approximately 30 litres (petrol or Diesel)).
With Stop & Star t, never refuel with the system in STOP mode; you must switch off the ignition with the key.

The key cannot be removed from thelock until the cap is refitted. Opening the filler cap may create anoise caused by an inrush of air. This vacuum is entirely normal, resulting from the sealing of the fuel system.

5
Visibility
79














Lighting controls


Main lighting

The various front and rear lamps of the vehicle
are designed to adapt the driver's visibilityprogressively according to climatic conditions:


- sidelamps, to be seen,

- dipped beam headlamps to see without
dazzlin
g other drivers,

- main beam headlamps to see clearly when
the road is clear.



Additional lighting
Other lamps are installed to fulfil the
requirements of par ticular conditions of
visibility:


- a rear foglamp to be seen from afar,

- front fo
glamps for even better forward
vision.

Programming

Various automatic lighting control modes
are also available according to the following
options:


-
guide-me-home lighting,

- automatic illumination of headlamps.

Model without AUTO lighting


Model with AUTO li
ghting


Lighting off / daytime runninglamps.
Automatic illumination of headlamps.
Sidelamps only.
Di
pped or main beam headlamps.
B.
Stalk for switching the headlamp beam: pull the stalk to switch between dipped and main beam headlamps.
In the lamps off and sidelamps modes,
th
e driver can switch on the main beam
headlamps temporarily ("headlamp flash") by
maintaining a pull on the stalk.

Displays

Lighting of the corresponding indicator lamp on
the instrument panel confirms the switching onof the lighting selected.

Depending on version, the instrument panel
may have permanent back-lighting. Illuminationof the instrument panel is therefore not linked to
the exterior lighting.
Manual controls
The lighting is controlled directly by the driver
by means of the ring Aand the stalk B .
A. Main lighting mode selection ring: turn it
to position the s
ymbol required facing themark. S
ystem for selection and control of the various front and rear lamps providing the vehicle's lighting.

Visibility
82
Association with the automatic "Guide-me-home" lighting

Association with the automatic illumination of headlamps provides "guide-me-home" lighting
with the following additional options:


- selection of the lighting duration to 15, 30 or 60 seconds in the functions that can be set
in the vehicle configuration menu (except in
the case of the monochrome screen A, for
which the duration is set: 60 seconds),

- automatic activation of "guide-me-home"lighting when automatic illumination of headlamps is in operation.



Operating fault
In the event of a fault with the
sunshine sensor, the lighting
come on, this warning lamp is displayed in the
instrument panel and/or a message appears in
the screen, accompanied by an audible signal.
Contact a CITROËN dealer or a
qualified
workshop.
In fog or snow, the sunshine sensor may detect sufficient light. Therefore, thelighting will not come on automatically. Do not cover the sunshine sensor, coupled with the rain sensor andlocated in the centre of the windscreen behind the rear view mirror; the associated functions would no longer be controlled.

Automatic illumination of headlamps
Activation
)Turn ring to the "AUTO"
position. The automatic illumination of headlamps is accompanied by a message in the screen.

Deactivation
)Turn ring to a position other than "AUTO" . Deactivation is accompanied by a message in the screen.
The sidelamps and dipped beam headlamps
are switched on automatically, without any action on the par t of the driver, when a low level
of external light is detected or in certain cases
of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.

Visibility
86
Automatic rain sensitive
w
indscreen wipers
The windscreen wipers operate automatically,
without any action on the par t of the driver, if rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Activation
Switchin
g off
Operatin
g fault

If an automatic wiping fault occurs, the wipers
will operate in intermittent mode.
Have it checked by a CITROËN dealer or aqualified workshop.
Vertical windscreen wiper
position

This position allows the wiper blades to be lifted
for winter parking, cleaning or replacement
without damaging the bonnet.
In the minute following switching off of the ignition, any action on the wiper stalk positions
the wipers vertically.
To park the wipers after this has been done,switch on the ignition and operate the wiper stalk. This is controlled manuall
y by the driver bypushing stalk Ato the "AU TO "position.
This is controlled manually by the driver
by moving stalk Aupwards, returning it toposition "0"
. It is accompanied b
y the indicator lamp
in the instrument panel going off and a message in the multifunction screen.
It is accompanied by the illumination of this indicator lamp in the instrument panel anda message in the multifunction screen.
The automatic wiping must bereactivated if the ignition has been off for more than one minute, by pushing stalk A
downwards.
Do not cover the rain sensor, linked withthe sunshine sensor and located in thecentre of the windscreen behind therear view mirror. Switch off the automatic wiping whenusing an automatic car wash.
In winter, it is advisable to wait until thewindscreen is completely clear of icebefore activating the automatic wiping.

To retain the effectiveness of the "flat-blade" wiper blades, it is advisable to:


- handle them with care,

- clean them regularly using soapywater,

- not use them to hold a sheet of cardboard against the windscreen,

- replace them at the first signs of wear.

Visibility
88








Interior mood lighting


Switching on

At night, the illumination of the central
dashboard storage compar tment comes
on automatically when the sidelamps are switched on.
On cer tain versions, three lamps located in the
suppor t between the roof and the automatic
da
y/night interior mirror come on as well.


Switching off

The interior mood lighting switches off
automatically when the sidelamps areswitched off.
It can be switched off manually using the
instrument panel lighting rheostat button.
) With the lighting on, press several times on
the left hand button of the instrument panel
to pro
gressively reduce the dashboard lighting level.) Press again to reduce the lighting level
to the minimum and switch off the interior
mood lighting.
This comes on automatically when the boot is
opened and goes off automatically when the boot is closed.




Boot lamp
The dimmed passenger compar tment lighting improves visibility in the vehicle when the light
is poor.
The lighting time varies according tothe circumstances:

- when the ignition is off, approximately ten minutes,

- in energy economy mode,approximately thirty seconds,

- when the engine is running, no limit.

Safety
108














Trajectory control systems
Anti-slip regulation (ASR)
and electronic stability
programme (ESP)
The anti-slip regulation (also known as Traction Control) optimises traction to prevent skidding
of the wheels, by acting on the brakes of the
driving wheels and on the engine.
The electronic stability programme acts on the
brake of one or more wheels and on the engine to
keep the vehicle on the trajectory required by the
driver, within the limits of the laws of physics.
Activation
These systems are activated automatically each time the vehicle is started.
They come into operation in the event of a grip
or trajectory problem.
This is indicated b
y flashing of this
warning lamp in the instrument panel.


Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft ground...), if you are unable to make progress,
it may be advisable to temporarily deactivate
these systems, so that the wheels can spin freely and allow the vehicle to move. ) Press the "ESP OFF"
button, located near
the steering wheel.
If this warning lamp comes on in the instrument panel and the indicator lamp in the button comes on, thisindicates that these systems are deactivated. It is recommended that the systems be reactivated as soon as possible.

Reactivation
These systems are reactivated automatically each time the ignition is switched back on or from 30 mph (50 km/h).)
Press the "ESP OFF"
button again to
reactivate them manually.

Operating fault

If this warning lamp comes on,
accompanied by an audible signal
and a message in the screen, this
indicates a
fault with these systems.
Have it checked by a CITROËN
dealer or a qualified workshop.
The trajectory control systems offer increased safety in normal driving, butthis should not encourage the driver to take extra risks or drive at high speed.
The correct functioning of these systems is assured provided thatmanufacturer's recommendations areobserved on:


- wheels (tyres and rims),

- braking components,

- electronic components,

- assembly and repair procedures.
After an impact, have these systems checked by a CITROËN dealer or a qualified workshop.

8
Safety
109
Seat belts
Fastening
)
Pull the strap, then inser t the tongue in thebuckle. )
Check that the seat belt is fastened correctly by pulling the strap.



Unfastening
)Press the red button on the buckle.)Guide the seat belt as it is reeled in.

Seat belt not fastened / unfastened warning lamp

When the ignition is switched on, this
warning lamp comes on in the instrument
panel, if the driver and/or the front
passen
ger has not fastened their seat belt.

Rear seat belts

The rear seats are each fitted with a three-point
inertia reel seat belt.
Fastening
)
Pull the strap, then inser t the tongue in the buckle.)
Check that the seat belt is fastenedcorrectly by pulling the strap.


Unfastening
)
Press the red button on the buckle.)
Guide the seat belt as it is reeled in.


Th
e front seat belts are fitted with apretensioning and force limiting system.
This s
ystem improves safety in the frontseats in the event of a front or side impact.
Depending on the severity of the impact, thepretensioning system instantly tightens the seat
belts against the body of the occupants.
The pretensioning seat belts are active when
the ignition is on.
The
force limiter reduces the pressure of the seat belt on the chest of the occupant, so
improving their protection.
From approximatel
y 12 mph (20 km/h)this warning lamp flashes for two minutes accompanied by an audible signal of increasing
volume. Once these two minutes have elapsed,
this warning lamp remains on until the driver and/
or the front passenger fastens their seat belt.

Safety
112
Only the passenger's front airbag can be
deactivated:)with the ignition off, inser t the key in thefpassenger airbag deactivation switch, )turn it to the "OFF"position,)then, remove the key keeping the switch in
the new position.
This warnin
g lamp comes on in the
instrument panel when the ignition is
on and until the airbag is re-activated.

Reactivation

When you remove a child seat that has been
fitted "rear wards facing", turn switch to the
"ON"
position to re-activate the airbag and so
assure the safety of your front passenger in theevent of an impact.


Operating fault

If this warning lamp comes on in the
instrument panel, accompanied by
an audible warnin
g and a message
in the multifunction screen, contact a
CITROËN dealer or qualified workshop
to have the system checked. The
airbags may no longer be deployed in
the event of a serious impact.
I
f this warning lamp flashes, contact
a CITROËN dealer or a qualified workshop. The passenger's front
airbag may no longer be deployed in
the event of a serious impact.
If at least one of the two airbag warning lamps come on continuously, do not install a child seat on the front
passenger seat.
Have it checked by a CITROËN dealer or a qualified workshop.

To assure the safety of your child,the passenger's front airbag must be deactivated when you install a "rear facing" child seat on the front passenger seat. Other wise, the child would risk beingseriously injured or killed if the airbag were deployed.
Deactivation