2012 TOYOTA HIGHLANDER HYBRID air condition

503
4-3. Do-it-yourself maintenance
4
Maintenance and care
20 ST
10 A Starting system
21 IG2 30 A INJ, GAUGE NO.2, IGN
22 STRG LOCK 20 A Steering lock system
23 RADIO NO.1 20 A Audio system
24 ABS MAIN
NO.3 15 AElectronically controlled brake sys-
tem
25 AMP 15 A Audio system
26 HAZ 15 A Turn signal lights
27 CAPACITER 15 A Brake system
28 G/H 10 AGlass hatch, multiplex communica-
tion system, outer foot lights
29 CRT 10 ARear seat entertainment system,
audio system
30 ETCS 15 AMultiport fuel injection system/
sequential multiport fuel injection
system
31 AM2 7.5 A Multiplex communication system
32 ECU-B NO.2 7.5 A Air conditioning system
33 HV MAIN 10 A Hybrid system
34 DOME 10 AVanity lights, personal lights, inte-
rior light, gauges and meters, door
courtesy lights, engine switch light
35 ECU-B NO.1 10 A Steering sensor, gauges and
meters, main body ECU, wireless
remote control, smart key system,
power back door, on-board diagno-
sis system, multi-information dis-
play
36 EFI NO.1 10 AMultiport fuel injection system/
sequential multiport fuel injection
system, smart key system
FuseAmpereCircuit

504 4-3. Do-it-yourself maintenance
37 WIP-S10 A Air conditioning system
38 EFI NO.2 10 AMultiport fuel injection system/
sequential multiport fuel injection
system
39 EFI NO.3 10 AMultiport fuel injection system/
sequential multiport fuel injection
system
40 F/PMP 15 A Fuel pump
41 INJ 15 AStarting system, multiport fuel
injection system/sequential multi-
port fuel injection system
42 DEICER 15 A Windshield wiper de-icer
43 FILTER 10 A Condenser
44 RR DEF 10 A Rear window defogger
45 MIR HTR 10 A Outside rear view mirror defoggers
46 PWR OUTLET 20 A Power outlet
47 DOOR NO.1 25 A Multiplex communication system
48 H-LP RH HI 15 A Right-hand headlight (high beam)
49 H-LP LH HI 15 A Left-hand headlight (high beam)
50 H-LP RH LO 15 A Right-hand headlight (low beam)
51 H-LP LH LO 15 A Left-hand headlight (low beam)
52 HORN 10 A Horn
53 A/F 20 A Air fuel ratio sensor
54 S-HORN 7.5 AMultiport fuel injection system/
sequential multiport fuel injection
system
FuseAmpereCircuit

506 4-3. Do-it-yourself maintenance
■Under the instrument panel
Front side of the fuse block
Fuse block
FuseAmpereCircuit
1 P/SEAT 30 A Power seat
2 POWER 30 A Power windows
3 RR DOOR RH 25 A Power windows
4 RR DOOR LH 25 A Power windows
5 FR FOG 10 A Fog lights
6 OBD 7.5 A On-board diagnosis system
7 A/C W/PMP 7.5 A Air conditioning system
8 STOP 10 A Stop lights, electronically controlled
brake system
9 DOOR NO.2 25 A Power windows
10 AM1 7.5 A Starting system

507
4-3. Do-it-yourself maintenance
4
Maintenance and care
11 P/SEAT (PS) 30 A Power seat
12 A/C NO.1 10 A Air conditioning system
13 FUEL OPN 7.5 A Fuel filler door opener
14 S/ROOF 20 A Electric moon roof
15 TAIL 15 A Side marker lights, tail lights,
license plate lights, fog lights, trailer
lights
16 PANEL 7.5 A Glove box light, instrument panel
lights, switch illumination
17 ECU IG NO.1 10 A Multiplex communication system,
electric moon roof, electronically
controlled transmission system,
power back door, seat heaters, tire
pressure warning system, electric
power steering, auto anti-glare
inside rear view mirror, shift lock
system
18 ECU IG NO.2 7.5 A Brake system
19 A/C NO.2 10 A Air conditioning system, electric
cooling fan
20 WASH 20 A Windshield and rear window
washer
21 S-HTR 20 A Seat heaters
22 GAUGE NO.1 10 A Audio system, back-up lights,
emergency flashers, traction con-
trol system, windshield wiper
deicer, rear view monitor system,
power outlet, air conditioning sys-
tem
23 FR WIP 30 A Windshield wipers and washer
24 RR WIP 15 A Rear window wiper and washer
FuseAmpereCircuit

534 5-2. Steps to take in an emergency
■Changing the engine oil (U.S.A. only)
Make sure to reset the oil change system. ( P. 448)
■
The tire pressure warning light ma y turn on due to natural causes
The tire pressure warning light may turn on due to natural causes such
as natural air leaks or tire inflation pressure changes caused by temper-
ature. In this case, adjusting the ti re inflation pressure will turn off the
warning light (after a few minutes).
■When a tire is replaced with a spare tire
The spare tire is also equipped with the tire pressure warning valve and
transmitter. The tire pressu re warning light will turn on if the tire inflation
pressure of the spare tire is low. If a tire goes flat, even though the flat
tire is replaced with the spare tire, the tire pressure warning light does
not turn off. Replace the spare tire with the repaired tire and adjust the
proper tire inflation pressure. The ti re pressure warning light will turn off
after a few minutes.
■If the tire pressure warning system is inoperative
The tire pressure warning system will be disabled in the following condi-
tions:
(When the condition becomes normal, the system will work properly.)
●If tires not equipped with tire pressure warning valves and transmit-
ters are used.
●If the ID code on the tire pressure warning valves and transmitters is
not registered in the tire pressure warning computer.
●If the tire inflation pressure is 73 psi (500 kPa, 5.1 kgf/cm2 or bar) or
higher.

562
5-2. Steps to take in an emergency
If your vehicle overheats
Correction procedures■ If the needle of the engine coolant temperature gauge enters
the red zone
Stop the vehicle in a safe place and turn off the air condition-
ing system.
Check to see if steam is coming out from the engine area.
If you see steam:
Stop the hybrid system. Carefully lift the hood after the
steam subsides and then restart the hybrid system.
If you do not see steam: Leave the hybrid system operating and carefully lift the
hood.
Check if the cooling fans are operating.
If the fans are operating: Wait until the engine coolant temperature gauge begins to
fall and then stop the hybrid system.
If the fans are not operating: Stop the hybrid system immediately and call your Toyota
dealer.
The following may indicate that your vehicle is overheating:
●The needle of the engine coolant temperature gauge enters the
red zone:
The engine may be overheating.
● “Hybrid System Overheat” is shown on the multi-information dis-
play:
The power control unit may be overheating.
Follow the correction procedure as described below.
STEP1
STEP2
STEP3

564 5-2. Steps to take in an emergency
■If “Hybrid System Overheat” is shown on the multi-informa-
tion display
Stop the vehicle in a safe place and turn off the air condition-
ing system.
Leave the hybrid system operating and carefully lift the hood.
Check if the cooling fans are operating.
If the fans are operating: Wait until “Hybrid System Overheat” disappears and then
stop the hybrid system.
If the message does not disapp ear, call your Toyota dealer.
If the fans are not operating: Stop the hybrid system immediately and call your Toyota
dealer.
After the hybrid system has
cooled down, check the power
control unit coolant level and
inspect the cooling system for
leaks.
If the engine compartment cover
needs to be removed. (P. 463)
Power control unit coolant res-
ervoir
Power control unit coolant
radiator
If necessary, add power control
unit coolant up to the “FULL”
line.
Water can be used in an emer-
gency if power control unit cool-
ant is unavailable. ( P. 577)
STEP1
STEP2
STEP3
STEP4
STEP5

593
6-1. Specifications
6
Vehicle specifications
Warning: The temperature grades for this tire are established for a
tire that is properly inflated and not overloaded.
Excessive speed, underinflation, or
excessive loading, either sepa-
rately or in combination, can caus e heat buildup and possible tire fail-
ure.
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation pres-
sure Tire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressure The maximum cold inflated
pressure to which a
tire may be inflated, s hown on the sidewall of
the tire
Recommended infla-
tion pressure Cold tire inflation pressure recommended by a
manufacturer
Accessory weight The combined weight (in excess of those stan-
dard items which may be replaced) of auto-
matic transmission, power steering, power
brakes, power windows, power seats, radio
and heater, to the extent that these items are
available as factory-installed equipment
(whether installed or not)
Curb weight The weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine
Maximum loaded vehi-
cle weight The sum of:
(a) Curb weight
(b) Accessory weight
(c) Vehicle capacity weight
(d) Production options weight