2012 SSANGYONG KORANDO ignition

03-40
Door lock/unlock control by central door lock switch ▶
When pressing the central door lock/unlock switch, BCM sends the LOCK or UNLOCK signal
according to the previous condition of driver door lock switch for 0.5 seconds.
The central door dock switch is not available when the system is in theft deterrent mode.
When turning the ignition off, all doors are automatically unlocked if any of the door lock (knob)
switches is in LOCK position.
When pressing the central door lock switch with any door open, the system unlocks the doors
immediately after locking them. 1.
2.
3.
4.
Door lock/unlock control by REKES signal ▶
When receiving the door lock signal, BCM sends the LOCK signal for 0.5 seconds.
When receiving the door unlock signal, BCM sends the UNLOCK signal for 0.5 seconds. 1.
2.

03-438710-01
Auto door lock control ▶
Door lock output is activated when the vehicle speed is maintained above 30 km/h with IGN1 ON.
However, if all the doors are locked or fail, lock output is not activated.
If any of doors is not locked after Step (1), BCM activates the door lock output up to 5 times.
If the door is still unlocked, BCM considers the door as Fail.
If the failed door is changed from UNLOCK to LOCK, the fail record the side fascia panel.
If there is any failed door, the auto door lock function is not available.
(Even though the vehicle speed is increased over 30 km/h again after decreased below 30 km/h, BCM
does not send the auto door lock signal.)
When receiving the unlock signal for another door during Step (2), BCM sends the lock
signal for the door up to 5 times.
The unlock output is activated automatically when door lock output conditions are met by this function
or the IGN1 switch is turned to OFF from ON position (even though the lock output is not activated if
the vehicle speed is maintained above 30 km/h under lock condition). (If the LOCK condition is
established with the ignition switch ON, the system outputs UNLOCK signal unconditionally when
turning the ignition switch to OFF position.)
However, whether the door lock output condition is met or not is initialized when the IGN1 switch is
turned to OFF position.
When turning the ignition off, the fail record for a door will be initialized.
If any of door lock switches is in LOCK position when turning the ignition off, all doors are unlocked. 1.
2.
3.
4.
5.
6.
7.
8.
9.
(*1) Lock: All doors including tailgate are locked.
Unlock: All doors including tailgate are unlocked.

03-44
Auto door unlock (crash unlock) control ▶
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition key to
"ON" position.
After the 7 seconds, the air bag signal is activated. If the air bag signal is turned ON (crash) from OFF,
BCM sends the door unlock signal for 5 seconds after 0.04 seconds.
The unlock signal is sent for the remaining of the period even when turning OFF the ignition switch
while receiving the unlock signal due to the crash.
The room lamps come ON when receiving the crash signal. (except when the front room lamp switch
is in OFF position.)
The turn signal lamps also blink when receiving the crash signal.
This function is reset when disconnecting the battery. 1.
2.
3.
4.
5.
6.

03-458710-01
12) Panic Alarm
Panic alarm by REKES signal ▶
When receiving the panic signal with Power OFF, ACC and IGN ON, the horn and turn signal lamps
operate for T1 with the interval of 0.5s ON/0.5s OFF.
When receiving the door lock or panic signal during the panic operation, the panic alarm stops.
(other commands are overridden)
The theft deterrent functions are as below:
- The theft deterrent alarm stops when receiving the panic alarm during its operation.
- The panic alarm stops and then the theft deterrent alarm starts its operation when occurring the
theft deterrent alarm conditions during panic alarm.
This function should be available regardless of the key status.
This function should be activated only when the ignition key is inserted (EU region). 1.
2.
3.
4.
5.

03-478710-01
Coming home lighting control ▶
The low beam keeps on for 30 seconds when the ignition switch is turned to ON from OFF position
with the headlamp ON.
Coming home lighting OFF condition
This function can be activated or deactivated with the diagnostic device. (default setting: active) 1.
2.
3.3 minutes after all doors and tailgate are open and closed
(lighting goes off 30 seconds after without extension when the closed doors are open)
When receiving REKES and passenger door lock signals (close, open, close) twice during coming
home lighting operation
Lighting goes off during its operation when headlamp and AUTO light switch are turned to other
position than ON
Lighting goes off when ignition switch is turned to ON position -
-
-
-
13) Headlamp

03-50
Disarming by REKES remote control 2.
When unlocking the doors or turning the ignition switch to ON position.
When receiving the door unlock signal in theft deterrent mode, all doors are unlocked and the turn
signal lamps blink once (the horn does not sound).
When receiving the door unlock signal with the theft deterrent mode disarmed, the turn signal
lamps blink once (the horn does not sound). -
-
-
In theft deterrent mode
BCM observes the conditions below continuously: 3.
Battery connection (B+)
Front/rear door open
Tailgate open
4 doors lock/unlock
Engine hood open -
-
-
-
-
Activation of theft deterrent alarm 4.
When any of doors, tailgate or engine hood is open in theft deterrent mode
When unlocking the door lock switch in theft deterrent mode
When opening a door after completion of theft deterrent alarm (for 30 seconds)
Horn and the turn signal lamps operate for 30 seconds with the interval of 0.5s ON/0.5s OFF. -
-
-
-
Disarming conditions of theft deterrent mode 5.
When pressing any switch (lock, unlock, panic) on the remote control key during the theft deterrent
alarm, the alarm stops its operation.
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops its
operation.
(For vehicle with immobilizer system, the alarm stops after completion of authorization. For vehicle
without immobilizer system, the alarm stays ON for 30 seconds)
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops
and the theft deterrent mode is deactivated after 30 seconds (remaining time).
If there is not any disarming commend, the alarm stays ON for 30 seconds and the theft deterrent
mode continues. -
-
-
-
Operation when disarming 6.
The horn and the turn signal lamps stop their operation. -

03-52
Theft deterrent alarm control in BCM with SKM ▶
Entering into theft deterrent mode by smart key remote control 1.
When receiving the door lock signal from the smart key remote control with power OFF or ACC ON
and tailgate and engine hood closed, the doors are locked and the theft deterrent mode is
activated. At this time, the turn signal lamps blink twice and the exterior buzzer sounds once at
interval with 50 ms ON/50 ms OFF. (SKM turns off the vehicle and sends the signal, when ACC
ON)
The BCM unlock the doors immediately after locking them first without operating turn signal lamp
and exterior buzzer and the system does not enter into theft deterrent mode, if the door lock signal
is received from the smart key remote control when the driver door is unlocked and any of doors is
open.
The BCM locks all the doors and system does not enter into theft deterrent mode if all the doors are
closed when the door lock signal is received from the smart key remote control with the tailgate and
engine hood open. However, if the tailgate and engine hood is closed, the turn signal lamps blink
twice, exterior buzzer sounds once and theft deterrent mode is entered.
If all the doors, tailgate or engine hood is open or the ignition switch is not turned to ON position
within 30 seconds after receiving the door unlock signal from the smart key remote control, the
doors are locked, turn signal lamps blink twice, exterior buzzer sounds once and theft deterrent
mode is re-activated.
The theft deterrent mode can be activated only when the above conditions are satisfied, excepting
manual lock.
Ex) The theft deterrent mode cannot be activated when locking the doors with key hole on door. -
-
-
-
-

03-538710-01
Entering into theft deterrent mode by SKM passive entry 2.
When receiving the signal from the outside door handle switch with power OFF or ACC ON,
tailgate and engine hood closed and driver door unlocked, the doors are locked and the theft
deterrent mode is activated. At this time, the turn signal lamps blink twice and the exterior buzzer
sounds once at interval with 50 ms ON/50 ms OFF. (SKM turns off the vehicle and sends the
signal, when ACC ON)
The BCM unlock the doors immediately after locking them first without operating turn signal lamp
and exterior buzzer and the system does not enter into theft deterrent mode, if the door lock signal
is received from the outside door handle switch when the driver door is unlocked and any of doors
is open.
The BCM locks all the doors and system does not enter into theft deterrent mode if all the doors
are closed when the door lock signal is received from the outside door handle switch with the
tailgate and engine hood open. However, if the tailgate and engine hood is closed, the turn signal
lamps blink twice, exterior buzzer sounds once and theft deterrent mode is entered.
If all the doors, tailgate or engine hood is open or the ignition switch is not turned to ON position
within 30 seconds after receiving the door unlock signal from the outside door handle switch with
the driver door locked, the doors are locked, turn signal lamps blink twice, exterior buzzer sounds
once and theft deterrent mode is re-activated.
The theft deterrent mode can be activated only when the above conditions are satisfied, excepting
lock by smart key remote control signal.
Ex) The theft deterrent mode cannot be activated when locking the doors with key hole on door. -
-
-
-
-