2012 RENAULT WIND Owners Manual

fuses ..................................................... (up to the end of the DU)
5.19
ENG_UD24358_4
Fusibles (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
clip 3
Remove the fuse using tweezers 3, lo-
cated on the back of cover 1 or in glove
box 2.
To remove the fuse from the tweezers,
slide the fuse to the side.
Fuses
Check the fuse in question
and replace it, if neces-
sary, by a fuse of the same
rating.
If a fuse is fitted where the rating is
too high, it may cause the electrical
circuit to overheat (risk of fire) in the
event of an item of equipment using
an excessive amount of current.
Fuses (1/3)
3
To comply with local legislation, or
as a precaution, you can obtain an
emergency kit containing a set of
spare bulbs and fuses from an ap -
proved dealer.
Fuse box
If electrical equipment does not work,
check the condition of the fuses.
Depending on the vehicle, remove
flap 1 or the flap located in storage
compartment 2.
To identify the fuses, refer to the fuse
allocation label (shown on the following
pages).
It is not advisable to use the free fuse
locations.
1
2

5.20
ENG_UD24358_4
Fusibles (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
Jaune NoirNoir texte
allocation of fuses (dePendIng On tHe eQuIPment LeVeL)
Fuses (2/3)
numbers allocation numbersallocation numbersallocation
1 and 2 Windscreen wiper. 11Direction indicator lights/
Diagnostic socket. 19Location reserved for
additional equipment.
3 Power-assisted steering. 12Power supply/Instrument
panel. 20
Front and rear fog lights.
4 Location reserved for
additional equipment. 13
Dipped beam headlights.
21Main beam headlights/
Horn.
14 Central door locking
5 Brake light/Speed limiter. 15Side lights.
22Location reserved for
additional equipment.
6 Reversing lights/door mirror
control/alarm siren. 16Location reserved for
additional equipment.
7 Air bag.
17Heated rear screen/Heated
door mirrors. 23
Electric windows.
24 Location reserved for
additional equipment.
8 Passenger compartment
electrical unit/transponder.
9 Injection/fuel pump. 18Interior lighting/courtesy
light/automatic climate
control. 25
Dipped beam headlights/
rear fog light.
10 ABS/ASR/ESP 26Sunroof.

JauneNoirNoir texte
5.21
ENG_UD24358_4
Fusibles (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
Fuses (3/3)
allocation of fuses (dePendIng On tHe eQuIPment LeVeL)
numbers allocation numbersallocation numbersallocation
27 Location reserved for
additional equipment. 36Location reserved for
additional equipment. 43Left-hand side light/number
plate light.
28 Passenger compartment
ventilation. 37
Heated door mirrors.
44Location reserved for
additional equipment.
29 Radio/Passenger
compartment electrical unit. 38
Horn.
30 Accessories socket. 39Rear fog lights. 45Diode protection.
31 Location reserved for
additional equipment. 40Location reserved for
additional equipment. 46Location reserved for
additional equipment.
32 Right-hand main beam
headlight. 41
Heated seats.
47Location reserved for
additional equipment.
33
Left-hand main beam
headlight.
42Right-hand side light/
accessories socket/cruise
control/speed limiter
control/central door locking
control/hazard warning
lights control.
34
Right-hand dipped beam
headlight.
35 Left-hand dipped beam
headlight. 48
Radio.

batterytroubleshooting ............................... (up to the end of the DU)
5.22
ENG_UD11233_1
Batterie : dépannage (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
Jaune NoirNoir texte
Battery
Battery: troubleshooting (1/2)
to avoid all risk of sparks:
– Ensure that any electrical consumers
(courtesy lights, etc.) are switched
off before disconnecting or recon -
necting the battery.
– When charging, stop the charger
before connecting or disconnecting
the battery.
– Do not place metal objects on the
battery to avoid creating a short cir-
cuit between the terminals.
– Always wait at least one minute after
the engine has been switched off
before disconnecting a battery.
– Make sure that you reconnect the
battery terminals after refitting.
connecting a battery charger
the battery charger must be com -
patible with a battery with nominal
voltage of 12 volts.
Do not disconnect the battery when the
engine is running. Follow the instruc-
tions given by the manufacturer of
the battery charger you are using.
Special procedures may be
required to charge some
batteries. Contact your ap -
proved dealer.
Avoid all risk of sparks which may
cause an immediate explosion, and
charge the battery in a well-venti -
lated area. Risk of serious injury.
Handle the battery with care
as it contains sulphuric acid,
which must not come into
contact with eyes or skin. If
it does, wash the affected area with
plenty of cold water. If necessary,
consult a doctor.
Ensure that naked flames, red hot
objects and sparks do not come into
contact with the battery as there is a
risk of explosion.
The engine may be hot when car -
rying out operations in close prox -
imity. In addition, the engine cooling
fan can come on at any moment.
Risk of injury.

JauneNoirNoir texte
5.23
ENG_UD11233_1
Batterie : dépannage (E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
Attach positive lead A to mounting 1
attached to (+) terminal 2 then to
(+) terminal 3 of the battery supplying
the current.
Attach the negative lead B to the
(– ) terminal 4 of the battery supplying
the current, then to the (–) terminal 5
of the discharged battery.
Start the engine. As soon as it is run -
ning, disconnect leads A and B in the
reverse order ( 5 - 4 - 3 - 2 ).
starting the vehicle using the
battery from another vehicle
If you have to use the battery from an-
other vehicle to start, obtain suitable
jump leads (with a large cross section)
from an approved dealer or, if you al -
ready have jump leads, ensure that
they are in perfect condition.
the two batteries must have an iden-
tical nominal voltage of 12 volts. The
battery supplying the current should
have a capacity (amp-hours, Ah) which
is at least the same as that of the dis-
charged battery.
Ensure that there is no risk of contact
between the two vehicles (risk of short
circuiting when the positive terminals
are connected) and that the discharged
battery is properly connected. Switch
off your vehicle ignition.
Start the engine of the vehicle supply -
ing the current and run it at a moderate
speed.
Battery: troubleshooting (2/2)
Check that there is no con-
tact between leads A and B
and that the positive lead A
is not touching any metal
parts on the vehicle supplying the
current.
Risk of injury and/or damage to the
vehicle.
25
1
25
3
4
a
B

batteries ................................................................. (current page)
5.24
ENG_UD13476_1
télécommande à radiofréquence : piles (E33 - X33 - Renault)\
ENG_NU_865-6_E33_Renault_5
n ote: It is not advisable to touch the
electrical circuit in the key cover when
replacing the battery.
Key, radio frequency remote control: battery
Key, radIO FreQuency remOte cOntrOL: battery
Key, remote controls
special feature of key A
Remove screw 3.
replacing the battery
Open the case at slot 1 using a coin,
and replace battery 2 , observing the
polarity shown on the back of the cover.
Do not dispose of your used
batteries in the countryside.
Give them to an organisa -
tion that collects and recy -
cles used batteries.Batteries can be obtained from your
approved Dealer.
These batteries should have a serv-
ice life of approximately two years.
3
When refitting, ensure that the cover
is correctly clipped on and the screw
tightened.
1
2
3
2
a
1

accessories...........................................(up to the end of the DU)
5.25
ENG_UD12965_3
Accessoires (S65 - X84 - B84 - C84 - E84 - L84 - K84 - J84 - X85 - B85 \
- C85 - S85 - X91 - B91 - K91 - D91 - B65 - C65 - K85 - X95 - B95 - D95 \
- J95 - R95 - X33 - X38 -
ENG_NU_865-6_E33_Renault_5
Accessories
accessOrIes
use of transmission/
receiving devices
(telephones, cB
equipment etc.).
Telephones and CB equipment with
integrated aerials may cause inter -
ference to the original electronic
systems fitted to the vehicle: it is ad-
visable only to use equipment with
an external aerial.
Furthermore, we remind you of
the need to comply with the legis-
lation in force concerning the use
of such equipment.
electrical and electronic
accessories
– C o n n e c t a c c e s s o r i e s
with a maximum power of
120 Watts only.
Fire hazard.
– No work may be carried out on
the vehicle’s electrical or radio
circuits, except by approved
Dealers: an incorrectly con -
nected system may result in
damage being caused to the
electrical equipment and/or the
components connected to it;
– if the vehicle is fitted with any
aftermarket electrical equip -
ment, make sure that the unit
is correctly protected by a fuse.
Establish the rating and position
of this fuse.
Before fitting an electrical or
electronic device (particu -
larly for transmitters/receiv-
ers: frequency bandwidth,
power level, position of the aerial
etc.), ensure that it is compatible
with your vehicle.
Contact an approved dealer for this
information.
Fitting after-market
accessories
If you wish to install acces-
sories on the vehicle: con -
sult an approved dealer.
Also, to ensure the correct opera -
tion of your vehicle, and to avoid
any risk to your safety, we recom -
mend that you use only specific ac-
cessories, designed for your vehi -
cle, which are the only accessories
for which the manufacturer will pro-
vide a warranty.
If you are using an anti-theft
device, only attach it to the
brake pedal.

wiper blades ......................................... (up to the end of the DU)
wipers blades ............................................. (up to the end of the DU)
5.26
ENG_UD21917_3
Balais d’essuie-vitres (X95 - E95 - E33 - X33 - Renault)
ENG_NU_865-6_E33_Renault_5
Wipers (replacing blades)
WIndscreen WIPer BLades
Check the condition of the wiper
blades. You are responsible for their
service life:
– clean the blades and the wind -
screen regularly with soapy
water;
– do not use them when the wind-
screen is dry;
– free them from the windscreen
when they have not been used
for a long time.
replacing windscreen wiper
blades 1
– Lift the windscreen wiper arm 3 as
far as it will go (the arm does not lift
up completely);
– press button 2 and slide the wiper
blade sideways to release hook 4 on
the wiper arm.
– In frosty weather, make
sure that the wiper blades
are not stuck by ice (to
avoid the risk of the motor
overheating).
– Check the condition of the wiper
blades.
Replace the wiper blades as soon
as they begin to lose efficiency
(approximately once a year).
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window.
3
1
2
4
refitting a windscreen wiper
blade
To refit the wiper blade, proceed in re-
verse order to removal.
Make sure that the blade is correctly
locked in position.