2012 HONDA CROSSTOUR Owners Manual

The airf low f rom the rear vents can
be adjusted when the AUTO mode is
selected or the f an mode is in theor position.
You can adjust the direction of the
airflowbymovingthetaboneach
vent up-and-down and side-to-side.
You can also open or close the vents
with the dial between them. Theclimatecontrolsystemhastwo
sensors: a sunlight sensor on top of
the dashboard, and a temperature
and humidity sensor next to the
steering column. Do not cover the
sensors or spill any liquid on them. Sunlight Sensor/
Temperature Sensor
Rear Ventilation
Climate Control System
133
SUNLIGHT SENSOR TEMPERATURE SENSOR
Open
DIAL
CloseTABS
REAR VENTS

Features

2012 Crosstour

An audio system is standard on all
models. Read the appropriate pages
(as shown below) to use your
vehicle’s audio system.
On models without navigation
system, see pages through .
On models with navigation system,
see pages through .137
230 178
179
Audio System
A udio system without navigation system
A udio syst em wit h navigat ion syst em
134
U.S. models are shown. Without XM Radio With XM Radio

Features

2012 Crosstour

Most audio system f unctions can be
controlled by standard buttons, bars,
and knobs. In addition, you can
access some f unctions by using the
selector knob on the audio system.The knob turns lef t and right. Use it
to scroll through lists, or to make
selections or adjustments to a list or
menu item on the display. When you
make a selection, push the center of
the selector (ENTER) to go to that
selection.
When the audio system is in XM
Radio mode or playing discs, pushing
the selector (ENTER) knob switches
the display between the normal
display and the extended display.
The extended display has three
segments to display the detailed
inf ormation.
Pressing the MENU button
again will also cancel the
menu display mode. To select any setting such as the
clock, sound adjustment, or the
compass, press the MENU button.
To use any audio system f unction,
the ignition switch must be in the
ACCESSORY (I) or ON (II) position.
You can select the item by turning
the selector knob. To go back to the
previous display, press the RETURN
button.
Selector K nob
Menu Display
Audio System(Models without navigation system)
135
SELECTOR
KNOBMENU
BUTTON
RETURN
BUTTON

Features

2012 Crosstour

Playing the FM/A M Radio(Models without navigation system)
Without XMRadio With XMRadio
136
SKIP BAR
SELECTOR
KNOB PRESET
BUTTONS
RETURN BUTTON A.SEL (AUTO
SELECT) BUTTONSCAN
BUTTON
MENU BUTTONSKIP BAR
SELECTOR
KNOB PRESET
BUTTONS
RETURN BUTTON
CATEGORY
BAR
A.SEL (AUTO
SELECT) BUTTON
TITLE
BUTTON
TITLE
BUTTON
MENU BUTTON
FM
BUTTON
SCAN
BUTTON
FOLDER BAR POWER/
VOLUME
KNOB
AM
BUTTON
POWER/
VOLUME
KNOB
AM
BUTTON
FM
BUTTON
U.S. models are shown.

Features

2012 Crosstour

µµ µ
The band and f requency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
On the AM band, AM noise
reduction turns on automatically. The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM or
FM button. Adjust the volume by
turning the power/volume knob. You can use any of f ive methods to
f ind radio stations on the selected
band: tune, skip, scan, the preset
buttons, and auto select.
The skip f unction searches
up and down f rom the current
f requency to f ind a station with a
strong signal. To activate it, press
and hold the or side of the
SKIP bar until you hear a beep, then
release it. On the FM band, you can also
use the features provided by the
radio data system (RDS). For
more information on the RDS,
see page .
Use the selector knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency. The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.
141
CONT INUED
To Select a Station
To Play the Radio
SK IP TUNESCAN
Playing the FM/A M Radio
(Models without navigation system)
137

Features

2012 Crosstour

µµEach preset button can
store one f requency on AM and two
f requencies on FM. If you are
traveling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if auto
select cannot f ind a strong station f or
that preset button.
If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons as previously described. ,pressthe
A. SEL (auto select) button. This
restores the presets you originally
set.
Press the A. SEL button. ‘‘A-SEL’’
f lashes in the display, and the system
goes into scan mode f or several
seconds. It stores the f requencies of
six AM and twelve FM stations in
the preset buttons. For inf ormation on FM/AM radio
frequencies and reception, see
.
Select the desired band, AM or
FM. FM1 and FM2 let you store
six stations each.
Usethetune,skip,scan,orRDS
function to tune the radio to a
desired station.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM. Pick a preset button, then press
and hold it until you hear a beep.
1.
2.
3.
4.To turn of f auto selectPreset
A UT O SEL ECT
Playing the FM/A M Radio(Models without navigation system)
138

page 231Features

2012 Crosstour

On the FM band, you can select a
favorite station and display the
program service name provided by
the radio data system (RDS).
The RDS inf ormation display
f unction shows the name of the RDS
station you are listening to. With the
audio system on and the FM band
selected, you can turn this f unction
on or of f .If the station you are listening to is
not an RDS station, the display
continues to show the f requency
with the RDS inf ormation display
f unction on.
When you turn of f this f unction by
pressing the TITLE button, the
display shows ‘‘RDS INFO OFF.’’
To switch the function between on
and off, press and release the TITLE
button. With the system on, you will
see the ‘‘RDS INFO ON’’ message on
the display. If the station you are
listening to is an RDS station, the
display shows the station name.
CONT INUED
Radio Data System (RDS)
RDS INFO Display
Playing the FM/A M Radio (Models without navigation system)
139
RDS INFO DISPLAY ON

Features

2012 Crosstour

ÛÝ
On the FM band selected, you can
select the program category
provided by the RDS. Press either
side ( or ) of the CATEGORY
bar (FOLDER bar on models without
XM Radio) to display and select an
RDS category. The principal RDS
categories are shown as follows:
Press either side of the CATEGORY
bar (FOLDER bar on models without
XM Radio) to select a RDS category.
The display shows the selected RDS
category name f or about 10 seconds.
You can use the search or scan
function to find radio stations in theselected RDS category. If you do
nothing while the RDS category
name is displayed, the selected
category is canceled.
TRAFFIC: Traffic information INFO: News, inf ormation, sports,
talk shows, f oreign language,
personality, public, college, and
weather JAZZ: Jazz CLASSIC: Classical music RELIGION: Programs concerned
with religion R & B: Rhythm and blues, and sof t
rhythm and blues OLDIES: Nostalgia music and oldies TOP 40: Top 40 hits
SOFT: Adult hits and sof t music COUNTRY: Country music
ROCK: Rock, classic rock and sof t
rock music ALL: All RDS category stations If the system does not find a station,
‘‘NOTHING’’ blinks f or about f ive
seconds, then the system goes back
to the last selected station. This f unction searches up and down
a f requency f or the strongest signal
f rom the f requencies that carry the
selected RDS category inf ormation.
This can help you to find a station in
your favorite category. To activate it,
press and release either side
( or ) of the SKIP bar. You
will see the selected RDS category
name blinking while searching it.
When the system finds a station, the
selected RDS category name will be
displayed again for about 5 seconds.
Playing the FM/A M Radio
(Models without navigation system)
Radio Data System (RDS) Category
RDS Program Search
140
RDS CATEGORY

Features

2012 Crosstour