2012 DODGE CHARGER SRT tow

[x] Cancel search: tow

Page 422 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual NOTE:
•Refer to the “Vehicle Certification Label” affixed to the
rear of the driver’s door for your vehicle’s GVWR and
GAWRs.
•Refer to the “Tire Placard” for your vehicle’s proper
t

Page 423 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual WHAT TO DO IN EMERGENCIES
CONTENTS
Hazard Warning Flashers................ 422
If Your Engine Overheats................ 422
TIREFIT Kit......................... 423
▫TIREFIT Storage..............

Page 429 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual WARNING! (Continued)
•Do not use TIREFIT or drive the vehicle under the
following circumstances:
�If the puncture in the tire tread is approximately
1/4 in. (6 mm) or larger.
�If the tire has any si

Page 442 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual TOWING A DISABLED VEHICLE
Towing Condition Wheels OFF the Ground SRT8 MODELS
Flat Tow NONEIF Transmission is operable:
•Transmission inNEUTRAL
•30 mph (48 km/h)maxspeed
•15 mi (24 km)maxdistance

Page 443 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual CAUTION!
•Do not use sling type equipment when towing.
Damage to the fascia will occur.
•When securing the vehicle to a flatbed truck, do
not attach to the front or rear suspension compo-
nents. D

Page 444 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual If the transmission is not operable, or the vehicle must be
towed faster than 30 mph (48 km/h) or farther than
15 miles (24 km), tow with the rear wheels OFF the
ground (on a flatbed, or with the rear

Page 448 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated onboard
diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic

Page 458 of 546

DODGE CHARGER SRT 2012 7.G Owners Manual 1. Remove the access door in the cowl screen by pressing
the retaining clips.
2. Unsnap both ends and lift the filter access cover.3. Remove the used filter.
4. Install the new filter with arrows poin