2012 Alfa Romeo Giulietta buttons

65
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
AUTOMATIC DUAL ZONE CLIMATE CONTROL SYSTEM(for versions/markets, where provided)
A0K0056mfig. 39
CONTROLS fig. 39
A driver’s side temperature adjustment knob
B internal air recirculation on/off button
C climate control compressor on/off button
D heated rear windscreen on/off button
E climate control system on/off button
F fan speed knob
G fan speed indicator LED;H air distribution selection buttons
I MAX-DEF function button (fast front window defrosting/ demist-
ing), heated rear windscreen and heated exterior mirrors (for
versions/markets where provided);
L Passenger’s side temperature adjustment knob
M MONO function button (set temperature alignment) driver/
passenger side
N AUTO function activation button (automatic operation)

67
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
ADJUSTING THE AIR TEMPERATURE
Turn A or L knob to right or left to adjust the air temperature: A
knob for the front left-hand area, L knob for the front right-hand
area of the passenger compartment. The set temperatures are
shown on the display.
Press the MONO button to align the air temperature between the
two zones.
Turn L knob to go back to the separate management of air tem-
peratures in the two zones.
Turn the knobs fully clockwise or anti-clockwise to engage respec-
tively HI (maximum heating) or LO (maximum cooling). To de-
activate these functions, rotate the temperature knob to the de-
sired temperature.
SWITCHING THE CLIMATE CONTROL SYSTEM ON
The system can be turned on in different ways: you are recom-
mended to press the AUTO button and turn the knobs to set the re-
quired temperatures.
In this way the system operates completely automatically to ad-
just the temperature, quantity and distribution of the air introduced
into the passenger compartment. It also manages the air recircu-
lation system and the enablement of the air conditioning com-
pressor.
During fully automatic system operation, you can change at any
time the set temperatures, air distribution and fan speed by using
the relevant buttons or knobs: the system will automatically change
its settings to adjust to the new requirements.
During fully automatic operation (AUTO), the word AUTO will dis-
appear if the air distribution and/or flow rate and/or engagement
of the compressor and/or recirculation settings are changed.
In this way the climate control system will continue to automati-
cally manage all functions except for those that have been manu-
ally adjusted. There is only one fan speed in all the areas of the
passenger compartment.

68
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
In AUTO mode, the climate control system automatically manage
air distribution settings; the LED on H buttons are off.
When set manually, the set distribution is shown by the LEDs on
the selected buttons.
In combined function mode the relevant function is enabled si-
multaneously with those already set by pressing the correspond-
ing button. If a button whose function is active yet is pressed, the
operation is cancelled and the corresponding LED goes off. To re-
store automatic control of the air distribution after a manual se-
lection, press the AUTO button.SETTING THE AIR DISTRIBUTION
Press H (//) buttons to manually select one of the sev-
en possible air distribution settings:
Air flow to the windscreen and front side window vents to
demist/defrost them.
Air flow from central and side dashboard vents to ventilate
the chest and the face during the hot season.
Air flow to the front and rear footwell vents. This air distribu-
tion setting heats the passenger compartment most quickly,
giving a prompt sensation of warmth.

Air flow distribution between footwell vents (hotter air) and
centre and side dashboard vents (cooler air). This distribution
setting is useful in spring and autumn on a sunny day.

Air flow distributed between foot well vents and windscreen
and front side window defrosting/demisting vents. This distri-
bution setting allows to warm up the passenger compartment
and prevents the windows from misting up.

Air flow distribution between windscreen demisting/defrosting
vents and side and central dashboard vents. This setting allows
air to be sent to the windscreen in conditions of strong sunlight.


Air flow distribution to all vents in the car.

70
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
It is advisable not to use the air recirculation func-
tion when the outside temperature is low to pre-
vent the windows from rapidly misting up.
Turning the AQS (Air Quality System)
function on
The AQS function automatically activates internal air recirculation
when the outside air is polluted (e.g. in traffic queues and tunnels).
IMPORTANT With the AQS function active, after the internal air
recirculation system has been running for a certain time, the cli-
mate control system enables the intake of outside air for approx-
imately 1 minute. This takes place regardless of the pollution lev-
el of the outside air.
IMPORTANT The air recirculation system makes it possible to reach
the required heating/cooling conditions faster. It is, however, in-
advisable to use it on rainy/cold days as it would considerably in-
crease the possibility of the windows misting up inside (especially
if the climate control system is off). When the outside tempera-
ture is low, recirculation is forced off (air drawn from the outside)
to prevent the windows misting up.
In automatic operation inside air recirculation will be controlled auto-
matically by the system according to outside environmental condi-
tions.
AIR RECIRCULATION AND AQS
(Air Quality System) FUNCTION
The air recirculation is managed according to the following oper-
ating logics:
❍automatic engagement: A word on B button on;
❍forced engagement (air recirculation always on): LED on v
A button on and A word off;
❍forced disengagement (air recirculation always off, air taken
from the outside): the LED on
vA buttons will switch off
and the A word on B button will switch off.
Forced on/off mode can be selected by pressing button
vA..
When
g(E button off ) is pressed, the climate control system
automatically activates air recirculation (the LED on
vA but-
ton should be on). Press
vA button to turn external air recir-
culation on (LED on button lit) and vice versa.
AQS (Air Quality System) function cannot be operated when
g
button is pressed (LED on button off).

71
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
CLIMATE CONTROL SYSTEM COMPRESSOR
Press C to turn the compressor on/off (the LED on the button will
light up when the compressor is on). The system remembers that
the compressor has been switched off, even after the engine has
stopped.
When the compressor is switched off the system deactivates air re-
circulation to prevent the windows from misting up and deactivates
the AQS function. In this case, although the system is capable of
maintaining the required temperature, the AUTO LED will go out.
The temperatures will flash for a few seconds if the required tem-
perature cannot be maintained.
To restore automatic control for switching on the climate control
compressor, press C button again or press the AUTO button.
With compressor off:
❍if the outside temperature is higher than the set one, the sys-
tem will not be able to satisfy the request. The temperature
value will then flash on the display for a few seconds;
❍the fan speed can be manually reset.
When the compressor is on and the engine is running, manual ven-
tilation cannot drop under the maximum speed (only one LED on).
IMPORTANT With the climate control compressor off, it is not pos-
sible to admit air into the passenger compartment with a tempera-
ture below the outside temperature; moreover, under certain envi-
ronmental conditions the windows could mist up very quickly since
the air cannot be dehumidified.
RAPID WINDOW DEMISTING/DEFROSTING
(MAX-DEF function)
Press-to turn windscreen and side window demisting/defrosting
function on (LED on button lit). The climate control system carries
out the following operations:
❍switches on the climate control compressor when climatic con-
ditions allow;
❍turns air recirculation off;
❍sets maximum air temperature (HI) in both zones;
❍sets proper fan speed according to the engine coolant tem-
perature;
❍directs air flow to the windscreen and front side windows vents;
❍the heated rear windscreen is turned on
❍shows fan speed (LED G lit).
IMPORTANT The MAX-DEF function will remain on for approximately
3 minutes from when the engine coolant reaches adequate tem-
perature.
The LED on the AUTO button will go out when the function is on.
With the function activated the only possible manual adjustments
are adjusting the fan speed and the turning the heated rear wind-
screen off. By pressing B, C,
-or AUTO buttons, the climate
control system will turn the MAX-DEF off.

98
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
ELECTRIC WINDOWS
The window winders work with the ignition key at MAR and for
approximately three minutes after turning the key to STOP or ex-
tracting it and opening one of the front doors.
The control buttons are located in the door panels (the driver’s door
panel can be used to operate all the windows).
An anti-pinch device is operated when the front and rear windows
are wound up.
CONTROLS fig. 68
Front door driver’s side
A. opening/closing left hand front window; “continuous auto-
matic” operation during window opening/closing stage;
B. opening/closing right hand front window; “continuous auto-
matic” operation during window opening/closing stage;
C. enabling/disabling of rear door electric window controls;
D. opening/closing left hand rear window (for versions/markets,
where provided); “continuous automatic” operation during win-
dow opening/closing stage;
E. opening/closing right hand rear window (for versions/markets,
where provided); “continuous automatic” operation during win-
dow opening/closing stage;
Press the buttons to open/close the required window. When one
of the two buttons is pressed briefly, the window moves in stages;
if the button is held down, “continuous automatic” operation is ac-
tivated both for closing and opening. If the button is pressed again
the window will stop in its current position. Holding the button
pressed for a few seconds, the window automatically raises or low-
ers (only with key on MAR).
Front door passenger’s side/rear doors
(for versions/markets, where provided)
On the passenger side front door control panel, and on some ver-
sions also on the rear doors, buttons F-fig. 68 are provided to con-
trol the relevant windows
fig. 68A0K0067m

104
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Folding back the seats
Proceed as follows:
❍raise the head restraints to the maximum height, press both
buttons A and B -fig. 74 to the side of the two supports, then
remove the head restraints by sliding them upwards;
❍move the seat belts making sure that they are correctly ex-
tended and not twisted;
❍lift the lever A-fig. 75 to fold the left or right portion of the back-
rest and then accompany the backrest and the cushion (a red
strip B will appear when the lever A if lifted) .
fig. 74A0K0065mfig. 75A0K0110m
Repositioning the rear seat
Move the seat belts making sure that they are correctly extended
and not twisted.
Lift up the backrest and push it back until a click is heard for the
engagement mechanism. Make sure that the red strip on levers
A-fig. 75. is no longer visible; if it is, this indicates that the back-
rest has not engaged. Reposition the head restraints into their hous-
ings.

S S
O O
U U
N N
D D
S S
Y Y
S S
T T
E E
M M(where provided)
RADIO (TUNER)....................... 269
Introduction ................................. 269
Selecting a frequency band ............ 269
Preset buttons .............................. 269
Storing the last station listened to ... 269
Automatic tuning .......................... 270
Manual tuning ............................. 270
AutoSTore function ........................ 270
Emergency alarm reception ............ 271
EON function............................... 271
Stereo stations ............................. 271
CD PLAYER .............................. 272
Introduction ................................. 272
Selecting the CD player ................ 272
Loading/ejecting a CD .................. 272
Display readings........................... 273
Track selection .............................. 273
Fast forward/fast rewind ............... 273
Pause function............................. 273CD MP3 PLAYER...................... 274
Introduction ................................. 274
MP3 mode .................................. 274
Selecting MP3 sessions
on hybrid discs............................. 275
Display readings........................... 275
Select next/previous folder ........... 275
Structure of the folders .................. 275
AUX (only with Blue&Me™)
(for versions/markets,
where provided)............................ 276
Introduction ................................. 276
AUX mode ................................... 276
TROUBLESHOOTING............... 277
General ....................................... 277
CD player .................................... 277
MP3 File reading .......................... 277 PRESENTATION........................ 248
Tips ............................................ 248
Technical specifications .................. 250
QUICK REFERENCE GUIDE...... 251
Steering wheel controls ................ 254
General information ...................... 256
FUNCTIONS AND
ADJUSTMENTS....................... 257
Switching the sound system ........... 257
Switching the sound system ........... 257
Selecting radio functions ................ 257
Selecting CD function ..................... 257
Audio source memory function ........ 257
Volume adjustment ....................... 257
Mute/Pause function.................... 258
Audio adjustments ........................ 258
Tone adjustment ........................... 259
Balance adjustment...................... 259
Fader adjustment......................... 259
Loudness function......................... 260
Menu .......................................... 261
Telephone setup ........................... 267
Anti-theft protection ....................... 267
SOUND SYSTEM
247