Page 69 of 722

For more inf ormation, see page.
You will also see a ‘‘CHECK
EMISSION SYSTEM’’ message on
the multi-information display (see
page ). The engine can be severely
damaged if this indicator f lashes
or stays on when the engine is
running. For more inf ormation,
see page .
You will also see a ‘‘CHECK
ENGINE OIL LEVEL’’ message
on the multi-information display
(see page ).
This indicator has two f unctions:
This indicator also comes on when
the battery needs to be replaced
along with a ‘‘REPLACE
BATTERY’’ message on the multi-
inf ormation display or a
‘‘CHANGE BATT’’ message on
the inf ormation display, depending
on models. For more inf ormation,
see page . If it comes on when the engine is
running, the battery is not being
charged, and you will see a
‘‘CHECK CHARGING SYSTEM’’
message on the multi-inf ormation
display or a ‘‘CHECK CHARGE
SYSTEM’’ message on the
inf ormation display, depending on
models.
1.
2.
91
91
671
670669On Touring models
On Touring modelsInstrument Panel Indicators
Malf unction Indicator
LampCharging System
IndicatorL ow Oil Pressure
Indicator
66
10/07/17 09:43:09 31TK8600_071
2011 Odyssey
Page 84 of 722

µµµµ
µµ µ
µ µ
µ
Select the outside temperature
display by pressing and releasing the
select/reset knob. Press and hold
the same knob f or a f ew seconds to
enter this setting, then turn it to
adjust the temperature. The
f ollowing sequence will appear f or
each:0,1,2,3,4,5, 5, 4, 3, 2,
1,0(U.S.)or0,1,2,3, 3, 2,
1, 0 (Canada). IGN ON (II) Immediately turn of f
all electrical devices (interior lights,
air conditioning, audio, heated seats,
etc.). Try not to operate other
electrically operated controls such as
the power windows. Driving the
vehicle will recharge the battery. If
the message continues to display
while driving, see your dealer.
IGN ACCESSORY (I) or LOCK (0)
Follow the message and turn of f
all electrical devices. Driving the
vehicle will recharge the battery,
however the vehicle may not start. If
it does not start, see jump starting
(see page ), or contact your
dealer.
When the temperature reaches the
desired value, release the select/
reset knob. You should see the new
outside temperature displayed.
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace. Whenthebattery’sstateof chargeis
low, the vehicle’s battery
management system triggers a
‘‘BATT LOW’’ message if the
ignition switch is on or of f .
Depending on how low the battery’s
state of charge dropped and how
long it remained low, these
messages may occur f requently. It
may take a number of trips to
sufficiently recharge the battery and
the messages to no longer appear.
665
Gauges
Battery Charge Low
Instruments and Controls
81
10/07/17 09:45:25 31TK8600_086
2011 Odyssey
Page 90 of 722

µµ
Whenthebattery’sstateof chargeis
low, the vehicle’s battery
management system triggers one of
the f ollowing ‘‘BATTERY CHARGE
LOW’’ messages if the ignition
switch is on or of f .
Depending on how low the battery’s
state of charge dropped and how
long it remained low, these
messages may occur f requently. It
may take a number of trips to
sufficiently recharge the battery and
the messages to no longer appear.
IGN ON (II) Immediately turn of f
all electrical devices (interior lights,
air conditioning, audio, heated seats,
etc.). Try not to operate other
electrically operated controls such as
the power windows. Driving the
vehicle will recharge the battery. If
the message continues to display
while driving, see your dealer.IGN ACCESSORY (I) or LOCK (0)
Follow the message and turn of f
all electrical devices. Driving the
vehicle will recharge the battery,
however the vehicle may not start. If
it does not start, see jump starting
(see page ), or contact your
dealer. 665
Multi-Inf ormation Display
Battery Charge Low
Instruments and Controls
87
10/07/17 09:46:07 31TK8600_092
2011 Odyssey
Page 148 of 722

These keys contain electronic
circuits that are activated by the
immobilizer system. They will not
work to start the engine if the
circuits are damaged.Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The valet key does not contain a
battery. Do not try to take it apart. The immobilizer system protects
your vehicle f rom thef t. If an
improperly coded key (or other
device) is used, the engine’s f uel
system is disabled.
When you turn the ignition switch to
the ON (II) position, the immobilizer
system indicator should come on
brief ly, then go of f . If the indicator
starts to blink, it means the system
does not recognize the coding of the
key. Turn the ignition switch to the
LOCK (0) position, remove the key,
reinsert it, and turn the ignition
switch to the ON (II) position again.
CONT INUED
Keys and Locks, Immobilizer System
Immobilizer System
Instruments and Controls
145
10/07/17 09:53:10 31TK8600_150
2011 Odyssey
Page 152 of 722
´
If it takes several pushes on the
button to lock or unlock the doors
and the tailgate, replace the battery
as soon as possible.
Battery type: CR1616
To replace the battery: Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver. Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover. Separate the transmitter by prying
its middle seam with your
f ingernail.Be caref ul when removing
this screw as the head of the screw
can strip out. Remove the old battery, and insert
a new battery into the back of the
cover with the side f acing down.
An improperly disposed of battery
can hurt the environment.
Always conf irm local regulations
for battery disposal.
Install the parts in reverse order.
3. 4.
1. 2. 5.
CONT INUED
Replacing the Transmitter Battery
Remote Transmitter
Instruments and Controls
149
NOTE:
SCREWBATTERY
TAB
10/07/17 09:53:44 31TK8600_154
2011 Odyssey
Page 156 of 722
Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover.
To replace the battery:
Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Separate the transmitter by prying
its middle seam with your
f ingernail. Be caref ul when removing
this screw as the head of the screw
can strip out.
Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
Battery type: CR2025 If it takes several pushes on the
button to lock or unlock the doors
and the tailgate, replace the battery
as soon as possible. 3.
1.
2.
CONT INUED
Remote Transmitter
Remote Transmitter Care
Replacing the Transmitter Battery
Instruments and Controls
153
NOTE:
SCREW BATTERY
TAB
10/07/17 09:54:20 31TK8600_158
2011 Odyssey
Page 157 of 722

´
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment. This device complies with Industry
Canada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Remove the old battery, and insert
a new battery into the back of the
cover with the side f acing down.
Install the parts in reverse order. An improperly disposed of battery
can hurt the environment.
Always conf irm local regulations
for battery disposal.
4.
5.
Remote Transmitter154
10/07/17 09:54:26 31TK8600_159
2011 Odyssey
Page 164 of 722

Unlocks the driver’s door or all doorsand tailgate when the ignition switch ismoved out of the ON (II) position.
Make sure the shif t lever is in the
Park (P) position.
Turn the ignition switch to the ON
(II) position, and make sure to
close the driver’s door. Push and hold the brake pedal,
then move the shift lever out of
the Park (P) position.
Pushandholdtherearof the
master door lock switch on the
driver’s door. You will hear a click.
Continue to hold the switch:
Until you hear another click
(af ter about 5 seconds) to
activate the driver’s door unlock
feature.
Or, until you hear two more
clicks (af ter about 10 seconds)
to activate all doors and tailgate
unlock f eature. Release the switch, and within 20
seconds, turn the ignition switch
to the ACCESSORY (I) position.
Move the shift lever to the Park
(P) position.
Turn the ignition switch to the
LOCK (0) position.
Even if your vehicle’s battery is
removed or goes dead, the system
keeps the auto door lock/unlock
setting which you selected.
4.
5.
1.
2. 3.
6.
Door L ocks
T o program t he Ignit ion Swit chUnlock mode:
Instruments and Controls
161
10/07/17 09:55:31 31TK8600_166
2011 Odyssey