2011 HONDA ODYSSEY stop start

Push the lever under the steering
column all the way down.Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up, down, in,
and out.
Make any steering wheel
adjustments bef ore you start driving.
Move the steering wheel up or
down, and in or out, so it points
toward your chest, not toward
your f ace. Make sure you can see
the instrument panel gauges and
indicators.3.
4.
1.
2.
Steering Wheel A djustments
Instruments and Controls
143
LEVER
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.
10/07/17 09:52:56 31TK8600_148
2011 Odyssey

µ
When you push the main switch in,
the indicator comes on and the
passengers’ windows cannot be
raised or lowered. Use the main
switchwhenyouhavechildreninthe
vehicle so they do not injure
themselves by operating the
windows unintentionally. To cancel
this feature, push on the switch
again. The switch will pop out and
the indicator will go of f .
The windows and the main switch
feature will operate for up to 10
minutes after you turn off the
ignition switch. Opening either f ront
door cancels this f unction. If either f ront
window senses any obstacle while it
is closing automatically, it will
reverse direction and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.
The driver’s window auto
reverse f unction is disabled when
you continuously pull up the switch. You can open all of the windows and
the moonroof (if equipped) f rom the
outside with the remote transmitter.
Press the UNLOCK button once
to unlock the driver’s door.
Press the UNLOCK button a
second time, and hold it. The
passenger’s doors and the tailgate
unlock, and all f our windows and
moonroof start to open. To stop
the windows and moonroof ,
release the button.
1.
2.
On all models except LX
Power Windows
AUTO REVERSE
Opening the Windows and
Moonroof with the Remote
Transmitter
Instruments and Controls
193
NOTE:
10/07/17 10:00:11 31TK8600_198
2011 Odyssey

To open the moonroof f ully, pull
back the moonroof switch f irmly.
The moonroof opens all the way. To
stop the moonroof f rom opening
f ully, push the switch brief ly. Turn the ignition switch to the ON
(II) position bef ore operating the
moonroof switch on the ceiling
console.
Turnthekeyclockwiseagain,and
hold it. All f our windows and the
moonroof start to open. To stop
the windows and the moonroof ,
release the key.
To close:
Insert the key in the driver’s door
lock.
Turn the key counterclockwise,
then release it.
To open the windows and the
moonroof f urther, turn and hold
the key again (within 10 seconds
of step 2). Turn the key counterclockwise
again, and hold it. All four
windows and the moonroof start to
close. To stop the windows and
the moonroof , release the key.
To close the windows and the
moonroof f urther, turn and hold
the key again (within 10 seconds
of step 2).
If the windows and the
moonroof stop bef ore the desired
position, repeat steps 2 and 3. 1.
2.
3.
4.
3.
4.
CONT INUED
On EX-L and Touring modelsMoonroofPower Windows, Moonroof
Instruments and Controls
195
NOTE:
Open
Close Tilt
MOONROOF SWITCH
10/07/17 10:00:28 31TK8600_200
2011 Odyssey

µ
µ µ
Each preset button can
store one f requency on AM and two
f requencies on FM.
Select the desired band, AM or
FM. You can store one f requency
on FM1, and one f requency on
FM2witheachpresetbutton.
Usethetune,skip,scan,orRDS
function to tune the radio to a
desired station.
Pick a preset button, and hold it
until you hear a beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
signal, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again. If you are
traveling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
Push the SETUP button to display
the setup MENU. Turn the selector
knob to select Auto Select, then
press the selector knob. The display
changes to the auto select mode.
Select ‘‘PUSH TO START’’ or ‘‘ON,’’
then press the selector knob. You
will see Auto Select on the display,
and the system goes into the auto
select mode f or several seconds.
If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons as previously described.
1.
2.
3.
4. Preset
SCAN AUTO SELECT
Playing the FM/AM Radio (EX, EX-L models without navigation system)254
10/07/17 10:08:23 31TK8600_259
2011 Odyssey

InsertaCDthathasnotbeen
recorded in the CD Library, press
the SETUP button and turn the
selector knob to ‘‘CDL SETUP’’ or
‘‘CD Library Setup,’’ then press the
selector knob. Select ‘‘RECORD CD
NOW’’ and press the selector knob.
The display will change to the
albumlist. Select the desired slot and
press the same knob to start
recording.If you select a slot on the albumlist
that has been recorded, a
conf irmation message will appear.
Select ‘‘YES’’ to overwrite the old
album. Select ‘‘NO’’ to return to the
normal display.
If you press the EJECT button while
recording a CD, the recording is
stopped. When you insert the same
CD again, the ‘‘RESUME REC’’ or
‘‘Continue REC’’ message will appear.
Select ‘‘YES’’ to restart the recording
f eature f rom the point that the
previous recording was disabled.Playing CD L ibrary A udio (EX, EX-L models without navigation system)T o Record a CD Manually280U.S. EX models
U.S. EX models
U.S. EX models
EX-L and Canadian EX models EX-L and Canadian EX modelsEX-L and Canadian EX models
10/07/17 10:11:56 31TK8600_285
2011 Odyssey

Turn the selector knob to select
‘‘CALIBRATION.’’While setting the compass, press
the RETURN button to go back to
the previous display. Pressing the
SETUP button will cancel the
compass setting mode.When the calibration is successf ully
completed, the CAL indicator goes
of f and the compass display will stop
blinking and show an actual heading.
The audio system is not related to
the compass system. Even if the
compasssystemiscalibrating,the
display returns to the normal display
which you last selected.
Drive the vehicle slowly in two
complete circles.
Press the selector knob to enter
your selection. The display shows
you ‘‘PUSH CAL START’’ or ‘‘Start
Calibration.’’ Press the selector knob. The
compass display is blinking and
the CAL indicator is shown.
3. 4. 5.
6.
Compass476U.S. EX models
EX-L and Canadian EX models
U.S. EX models
EX-L and Canadian EX models
10/07/19 15:54:33 31TK8600_481
2011 Odyssey

µµ
µµ
µ
CONT INUED
If you have done all of the above and
still cannot move the lever out of
Park, seeon
page .
To avoid transmission damage, come
to a complete stop bef ore shif ting
into Park. You must also press the
release button to shift into Park. The
shif t lever must be in Park bef ore
you can remove the key f rom the
ignition switch. Use neutral if you
need to restart a stalled engine, or if
it is necessary to stop brief ly with
the engine idling. Shif t to the Park
position if you need to leave your
vehicle for any reason. Press on the
brake pedal when you are moving
the shift lever from neutral to
another gear. Use this position f or
normal driving. The transmission
automatically selects a suitable gear
f or your speed and acceleration.
This position mechani-
cally locks the transmission. Use
Park whenever you are turning of f or
starting the engine. To shif t out of
Park, you must press on the brake
pedal and have your f oot of f the
accelerator pedal. Press the release
buttononthefrontof theshiftlever
to move it. Press the brake
pedal and the release button on the
frontoftheshiftlevertoshiftfrom
Park to reverse. To shif t f rom
reverse to neutral, come to a
completestop,andthenshift.Press
the release button bef ore shif ting
into reverse f rom neutral. To use D3, press the
D3buttonwhentheshiftleverisin
the ‘‘D’’ position. This position is simi-
lartoD,exceptonlythefirstthree
gears are selected instead of all f ive.
Use D3 when towing a trailer in hilly
terrain, or to provide engine braking
when going down a steep hill. D3 can
also keep the transmission f rom
cycling between third and f ourth
gears in stop-and-go driving.
565
Except Touring models
Automatic Transmission
Shif t L ock Release Neutral (N) Drive (D)
Park (P) Reverse (R)
Drive (D3)
Driving
563
10/07/17 10:50:12 31TK8600_568
2011 Odyssey

When the low tire pressure indicator
is on, one or more of your tires is
signif icantly underinf lated. You
should stop and check your tires as
soon as possible, and inf late them to
the proper pressure as indicated on
the vehicle’s tire inf ormation placard.
If you think you can saf ely drive a
short distance to a service station,
proceed slowly, and inf late the tire to
the recommended pressure shown
on the driver’s doorjamb.
If the tire is f lat, or if the tire
pressure is too low to continue
driving, replace the tire with the
compact spare tire (see page ).
If you cannot make the low tire
pressure indicator go out af ter
inflating the tires to the specified
values, have your dealer check the
system as soon as possible.Driving on a signif icantly under
inf lated tire causes the tire to
overheat and can lead to tire failure.
Underinf lation also reduces f uel
efficiency and tire tread life, and may
af f ect the vehicle’s handling and
stopping ability.
Becausetirepressurevariesby
temperature and other conditions,
the low tire pressure indicator may
come on unexpectedly.
Each tire has its own pressure
sensor (not including the spare tire).
If the air pressure of a tire becomes
signif icantly low while driving, the
sensor in that tire immediately sends
a signal that causes the low tire
pressure indicator to come on. Your vehicle is equipped with a tire
pressure monitoring system (TPMS)
that turns on every time you start the
engine and monitors the pressure in
your tires while driving.
655
Except Touring models
Low Tire Pressure
Indicator
Tire Pressure Monitoring System (TPMS)572
10/07/17 10:51:23 31TK8600_577
2011 Odyssey