2011 FORD KUGA Drive shaft

[x] Cancel search: Drive shaft

Page 1286 of 2057

FORD KUGA 2011 1.G Workshop Manual Drive Pinion Seal
Special Tool(s)303-293
Remover, Crankshaft Seal
21143
Special Tool(s)308-643
Installer, Input Shaft Seal
E65343
Removal
1.Refer to: Health and Safety Precautions (100-00
General Info

Page 1287 of 2057

FORD KUGA 2011 1.G Workshop Manual Active On-Demand Coupling — Vehicles With: 5-Speed AutomaticTransaxle - AW55 AWD/6-Speed Automatic Transaxle -
6DCT450
Special Tool(s) / General Equipment
205-072
Universal Flange Holding
Wrench
150

Page 1296 of 2057

FORD KUGA 2011 1.G Workshop Manual SECTION 205-04 Front Drive Halfshafts
VEHICLE APPLICATION:2008.50 Kuga
PA G E
CONTENTS
SPECIFICATIONS
205-04-2
Specifications ........................................................................\

Page 1297 of 2057

FORD KUGA 2011 1.G Workshop Manual Lubricants, Fluids, Sealers and Adhesives
Specifications
WSS-M1C 259-A1
Outer Constant Velocity Joint
Grease
Specifications
WSS-M1C 259-A1
Inner Constant Velocity Joint Grease
Capacity
Driveshaft Join

Page 1298 of 2057

FORD KUGA 2011 1.G Workshop Manual Front Drive Halfshafts
Inspection and Verification
NOTE:New front wheel drive halfshafts should not
be installed unless disassembly and inspection
reveals unusual wear.
1. Inspect front wheel drivesha

Page 1299 of 2057

FORD KUGA 2011 1.G Workshop Manual Action
Possible Sources
Symptom
• CHECK ride height, VERIFYcorrect spring rate and CHECK
items under Halfshaft Joint
Pullout. REPAIR or INSTALL
new as necessary.
• Excessively high CV joint oper-

Page 1300 of 2057

FORD KUGA 2011 1.G Workshop Manual Front Halfshaft LH(14 320 0)
Special Tool(s) / General Equipment204-159
Lever, Wheel Knuckle
14039
204-602
Installer, Halfshaft
E62067
204-605
Separator, Lower Arm Ball
Joint
E63772
204-609
Protection

Page 1301 of 2057

FORD KUGA 2011 1.G Workshop Manual 2.Refer to: Lifting(100-02 Jacking and Lifting,
Description and Operation).
Refer to: Wheel and Tire (204-04 Wheels and
Tires, Removal and Installation).
3. NOTE: This step is only necessary when
inst