2011 CADILLAC ESCALADE ESV Owners Manual

Black plate (3,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
In Brief 1-3A. Air Vents on page 8 ‑ 8 .
B. Turn and Lane ‐ Change Lever.
See Turn and Lane-Change
Signals on page 6 ‑ 9 .
Windshield Wiper/Washer on
page 5 ‑ 5 .
C. Instrument Cluster on
page 5 ‑ 12 .
D. Hazard Warning Flashers on
page 6 ‑ 8 .
E. Shift Lever. See Automatic
Transmission on page 9 ‑ 40 .
Driver Shift Control (DSC). See
Manual Mode on page 9 ‑ 43 .
F. Tow/Haul Mode on page 9 ‑ 43 .
G. Driver Information Center (DIC)
Buttons. See Driver Information
Center (DIC) on page 5 ‑ 26 . H. Clock on page 5 ‑ 8 .
I. Infotainment on page 7 ‑ 2 .
J. StabiliTrak ®
System on
page 9 ‑ 47 .
Rear Park Aid Disable Button.
See Ultrasonic Parking Assist
on page 9 ‑ 54 .
K. Steering Wheel Adjustment on
page 5 ‑ 2 .
L. Exterior Lamp Controls on
page 6 ‑ 1 .
M. Dome Lamp Override. See
Dome Lamps on page 6 ‑ 10 .
Instrument Panel Illumination
Control on page 6 ‑ 10 .
Fog Lamps on page 6 ‑ 9 .
N. Data Link Connector (DLC)
(Out of View). See Malfunction
Indicator Lamp on page 5 ‑ 18 . O. Automatic Transfer Case
Control (Hybrid only). See the
hybrid supplement for more
information.
P. Cruise Control on page 9 ‑ 51 .
Heated Steering Wheel on
page 5 ‑ 5 (If Equipped).
Q. Horn on page 5 ‑ 5 .
R. Steering Wheel Controls on
page 5 ‑ 3 .
S. Dual Automatic Climate Control
System on page 8 ‑ 1 .
T. Pedal Adjust Button. See
Adjustable Throttle and Brake
Pedal on page 9 ‑ 31 .
Power Assist Steps on
page 2 ‑ 13 (If Equipped).
U. Glove Box on page 4 ‑ 1 .

Black plate (4,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
1-4 In Brief
Initial Drive
Information This section provides a brief
overview about some of the
important features that may or may
not be on your specific vehicle.
For more detailed information, refer
to each of the features which can be
found later in this owner manual.
Remote Keyless Entry
(RKE) System The RKE transmitter is used to
remotely lock and unlock the doors
from up to 60 m (195 ft) away from
the vehicle. Press
K to unlock the driver door.
Press
K again within 3 seconds to
unlock all remaining doors.
Press
Q to lock all doors.
Lock and unlock feedback can be
personalized. See Vehicle
Personalization on page 5 ‑ 40 . Press and hold
& to open or
close the liftgate.
Press and hold
m to open the
liftglass.
Press
L and release to locate the
vehicle.
Press
L and hold for
three seconds to sound the panic
alarm.
Press
L again to cancel the panic
alarm.
See Keys on page 2 ‑ 2 and Remote
Keyless Entry (RKE) System
Operation on page 2 ‑ 3 .

Black plate (5,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
In Brief 1-5
Remote Vehicle Start With this feature the engine can be
started from outside of the vehicle.
Starting the Vehicle 1. Aim the RKE transmitter at the
vehicle.
2. Press
Q .
3. Immediately after completing
Step 2, press and hold
/ until
the turn signal lamps flash.
When the vehicle starts, the parking
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system may come on. The engine will continue to run for
10 minutes. Repeat the steps for a
10-minute time extension. Remote
start can be extended only once.
Canceling a Remote Start To cancel a remote start: .
Aim the RKE transmitter at the
vehicle and press and hold
/until the parking lamps turn off. .
Turn on the hazard warning
flashers. .
Turn the ignition on and then
back off.
See Remote Vehicle Start on
page 2 ‑ 5 . Door Locks There are several ways to lock and
unlock the vehicle.
From outside, use the Remote
Keyless Entry (RKE) transmitter or
the key in the driver door. From
inside, use the power door locks or
the manual door locks. To lock or
unlock the door with the manual
locks, push down or pull up on the
manual lock knob.
Power Door Locks If available, these switches are on
the front doors.
K : Press to unlock the doors.
Q : Press to lock the doors.
See Door Locks on page 2 ‑ 7 .

Black plate (6,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
1-6 In Brief
Liftgate Power Liftgate
Press
K on the Remote Keyless
Entry (RKE) transmitter or use the
power door lock switches to unlock
the liftgate.
There are several ways to open and
close the power liftgate: .
Press and hold
& on the RKE
transmitter until the liftgate starts
moving. .
Press
& on the overhead
console inside the vehicle. .
Press the touchpad switch (B) on
the outside liftgate handle
to open. .
Press the
l button next to the
liftgate latch to close.
To disable the power liftgate
function, press OFF on the
overhead console.
Liftglass
There are two ways to unlatch the
liftglass: .
Press the button on the
underside of the license plate
applique (A). .
Press
m on the RKE
transmitter.
See Liftgate (Manual) on page 2 ‑ 9
or Liftgate (Power) on page 2 ‑ 10 .Windows
The power window switches are
located on the driver door. In
addition, each passenger door has
a switch for its own window.
Press the switch to lower the
window. Pull the switch up to
raise it.
For more information, see: .
Windows on page 2 ‑ 19 . .
Power Windows on page 2 ‑ 20 .

Black plate (7,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
In Brief 1-7
Seat Adjustment
To adjust the seat: .
Move the seat forward or
rearward by sliding the control
forward or rearward. .
Raise or lower the front or rear
part of the seat cushion by
moving the front or rear of the
control up or down. .
Raise or lower the entire seat by
moving the entire control up
or down. See Power Seat Adjustment on
page 3 ‑ 3 for more information.
Lumbar Adjustment
To adjust the lumbar support: .
Press and hold the front or rear
of the control to increase or
decrease lumbar support. .
Press and hold the top or bottom
of the control to raise or lower
the height of the support.
See Lumbar Adjustment on
page 3 ‑ 6 for more information. Reclining Seatbacks
To adjust the seatback: .
Tilt the top of the control
rearward to recline. .
Tilt the top of the control forward
to raise.
See Reclining Seatbacks on
page 3 ‑ 6 for more information.

Black plate (8,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
1-8 In Brief
Memory Features
The controls on the driver door are
used to program and recall memory
settings for the driver seat, outside
mirrors, power steering column, and
the adjustable throttle and brake
pedals. Storing Memory Positions
To save into memory:
1. Adjust the driver seat, including
the seatback recliner and
lumbar, both outside mirrors,
power steering column, and the
throttle and brake pedals.
See Power Mirrors on page 2 ‑ 16
and Adjustable Throttle and
Brake Pedal on page 9 ‑ 31 for
more information.
Not all mirrors and adjustable
throttles and brake pedals will
have the ability to save and
recall their positions.
2. Press and hold “ 1 ” until
two beeps sound.
3. Repeat for a second driver
position using “ 2. ”
To recall, press and release “ 1 ” or
“ 2. ” The vehicle must be in P (Park).
A single beep will sound. The seat, outside mirrors, steering column,
and adjustable throttle and brake
pedals will move to the positions
previously stored for the identified
driver.
See “ Memory Features ” under
Power Seat Adjustment on page 3 ‑ 3
and Vehicle Personalization on
page 5 ‑ 40 for more information.
Easy Exit Positions
This feature can move the driver
seat rearward and the power
steering column up and forward to
allow extra room to exit the vehicle.
B : Press to recall the easy exit
positions. The vehicle must be in
P (Park).
See “ Memory Features ” under
Power Seat Adjustment on page 3 ‑ 3
and Vehicle Personalization on
page 5 ‑ 40 for more information.

Black plate (9,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
In Brief 1-9
Second Row Seats On vehicles with a 60/40 split bench
or buckets seats, the seatbacks can
be folded for additional cargo space,
or the seats can be folded and
tumbled for easy entry/exit to the
third row seats, if equipped. On
vehicles with bucket seats, the
seatbacks also recline.
See Second Row Seats on
page 3 ‑ 10 for more information.
Third Row Seats On vehicles with third row seats, the
seatbacks can be folded, and the
entire seat can be tumbled or
removed from the vehicle.
For detailed instructions, see Third
Row Seats on page 3 ‑ 14 . Heated and Ventilated
Seats
The buttons are on the climate
control panel.
{ : Press to cool the entire seat.
+ : Press to heat the
seatback only.
z : Press to heat the seat and
seatback.
Press the desired button once for
the highest setting. With each press
of the button, the seat will change to
the next lower setting, and then to
the off setting. Indicator bars next to
the symbol on the climate control display show the selected setting:
three for high, two for medium, and
one for low.
See Heated and Ventilated Front
Seats on page 3 ‑ 8 .
Heated Rear Seats
The buttons are on the Rear Sear
Audio (RSA) panel on the rear of the
center console.
Press
M or
L to heat the left
outboard or right outboard seat
cushion and to cycle through the
temperature settings.
See Heated Rear Seats on
page 3 ‑ 9 .

Black plate (10,1)Cadillac Escalade/Escalade ESV Owner Manual - 2011
1-10 In Brief
Head Restraint
Adjustment Do not drive until the head restraints
for all occupants are installed and
adjusted properly.
To achieve a comfortable seating
position, change the seatback
recline angle as little as necessary
while keeping the seat and the head
restraint height in the proper
position.
For more information see Head
Restraints on page 3 ‑ 2 and Power
Seat Adjustment on page 3 ‑ 3 .Safety Belts
Refer to the following sections for
important information on how to use
safety belts properly. .
Safety Belts on page 3 ‑ 18 ..
How to Wear Safety Belts
Properly on page 3 ‑ 22 . .
Lap-Shoulder Belt on page 3 ‑ 27 ..
Lower Anchors and Tethers for
Children (LATCH System) on
page 3 ‑ 59 . Sensing System for
Passenger Airbag The passenger sensing system,
if equipped, will turn off the right
front passenger frontal airbag
under certain conditions. The driver
airbags, seat ‐ mounted side impact
airbags and roof ‐ rail airbags are not
affected by this.
If the vehicle has one of the
indicators pictured in the following
illustrations, then the vehicle has a
passenger sensing system for the
right front passenger position.
The passenger airbag status
indicator, if equipped, will be
visible on the overhead console
when the vehicle is started.