2011 AUDI A3 engine oil

_______________________________________________ F_u _s_ e_ s_ a_ n_ d_ b_u _ l_ b _ s __ _
Equipment No. II Equipment
Amps
Manual headlight beam adjustment, automatic Diagnostic connector, rain sensor, air condition-
headlight beam adjustment, AFS control mod-
16 ing (control module), tire pressure monitor dis-10
1 ule, engine components, light switch (switch 10 play (control module)
-lig hti ng/i llum i nation), diagnosis socket 1 7 Ant i-theft alarm warning system 5
Automatic transmission, control module for CAN 18 Diagnose Starter 5
data transfer (gateway), electro-mechanical
19 All Whee l Drive 10 steering, shift gate automatic transmission, 2 10 engine relay, fuel tank control unit, engine con-22 Blower fan 40
trol unit, brakes control (ABS), Electronic Stabili-23 Driver's side power window, front 30 zation Program (ESP), Anti-Slip Regulation (ASR)
3 Airbag 5 24 Power outlet front 20
Air-conditioning (pressure sensor, air quality sen-25 Rear window defogge r 30
sor), button for Electronic Stabilization Program 26 Power outlet in luggage compartment 20
(ESP), Anti-Slip Regulation (ASR), tire pressure 27 Fuel tank control module, fuel pump 15
monitor display, oil level sensor, back-up light
28 Power window, rear 30 4 switch, front seat heating, parking aid, seat-s
occupancy recognition (on USA vehicles), garage 33 Sliding/pop-up roof 20
door opener, automatic mirror dimming, head-
Lumbar support
10 light assistant, heated windshield washer noz-
zles, air conditioning (control module)
3 7 Hea ted seats, front 20
--
5 AFS headlights (left side) 5 38 Passenger side power window, front 30
AFS headlights (right side) 5 39 Specia l function interface 5
9
Navigat ion system, radio system 15 40 Starter 40
digital radio, cell phone, TV equipment 7,5 Rear window wiper 15
11
Automatic mirror dimming, headlight assistant 10 Body control module 20
12 Central locking (front doors) 10 47 Ce ll phone package (VDA interface) 5
13
Central locking (rear doors) 10
A uto m atic c ircu it bre ake rs :
14 Electronic Stabilization Program (ESP) (control 10 The electric power w indows and the electric seat adjusters are
module), shift gate automatic transmission protected with circuit b reakers which reset automatically after the
1 5 Inter ior lights, read ing lights 10 circuit overload has been corrected . ...
Safety first Vehicle care Do-it-yourself service Technical data

lffll.,___F_ u_ s_e _ s_ a_n_d _b_u _ l_ b_s _______________________________________________ _
(I) Tips
• Whenever replacing a fuse, always consult the sticker on the
i ns ide of the fuse panel cover. It contains the most up-to-date infor ­
mation regarding the fuse arrangement . If in doubt , ask your autho ­
rized Audi Service advisor.
• Some of the equipment items listed are optiona l or only available
on certain model configurations. •
Fuse location, left side of engine
compartment
Fig. 196 Engine
compart ment: fuse
assignment
Please check your car's fuse layout, there are two different layouts.
Check the fuse layout with the fuse panel cover removed~
page 281,
"Fuse cover in engine compartment ".
Some of the equipment items listed are optional or only available on
certain model configurations .
Please note that the preceding table was accurate at the time of
printing and is subject to change . In the event of discrepancies, the
label on the inside of the cover always takes precedence .
No. Equipment
Fl Terminal 30
F2 Engine components
F3 Batteryvoltage
F4 ESP valves, Anti-lock brake system (ABS) valves
FS Transmission control module
F6 Steering wheel electronics
FlO Engine control module, main relay
Fl2 Control module for CAN data transfer (gateway)
Fl3
FlS
Fl6 Engine
control module
Ignition coils, engine components (diesel engine)
Preheating control module/engine component,
tank diagnosis, oxygen sensor
Body control module (right)
F l7 Ho rn
Fl8 Audio amplifier
Fl9 Front
windshield wiper system
F20 Water pump, volume regulator valve
F21 Oxygen sensor, vacuum pump
F22 Clutch pedal switch, brake light switch F23 engine components, water pump
F24 Engine components, water pump
F25 Pump (ESP/ABS), ABS va
lve
F26 Body control module (left)
Amps
40
20
s
20/30 15
5
5/10
5
15/25/30
20
5/10 30 15
30
30
10/20
10/15
5
5/10/15 10
40 30

IJIIL--___:E:::..:.. m:..:..: e..:.r-=g ~ e:::..:.. n:..:c ::=y :.....: s..:.i..:.t ..:.u :..:a :... t.:.; i:..: o :... n:..:..: s ____________________________________________ _
Lifting the vehicle
Important safety precautions
Be aware of the following hazards before lifting the vehicle with a
workshop hoist or floor jack:
• The vehicle should never be lifted or jacked up from underneath
the engine oil pan, the transmission housing, the front or rear axle
or the body side members. This could lead to serious damage.
• Use lifting equipment with padded contact surfaces to avoid
damage to the underbody or chassis frame.
• Alternatively, cover the contact surfaces on workshop hoist or
floor jack with rubber pads before lifting.
• Before driving over a workshop hoist, check that the vehicle
weight does not exceed the permissible lifting capacity of the hoist.
• Before driving over a workshop hoist, ensure that there is suffi­
cient clearance between the hoist and low parts of the vehicle.
& WARNING
To reduce the risk of serious injury and vehicle damage:
• Always lift the vehicle only at the special workshop hoist and
floor jack lift points illustrated
~ fig. 203 and=> fig. 204.
• Failure to lift the vehicle at these points could cause the vehicle
to tilt or fall from a lift if there is a change in vehicle weight distri­
bution and balance. This might happen, for example, when heavy
components such as the engine block or transmission are removed.
• When removing such heavy components, anchor vehicle to
hoist or add corresponding weights to maintain the center of
gravity. Otherwise, the vehicle might tilt or slip off the hoist,
causing serious personal injury. •
Lifting with workshop hoist and with floor
jack
The vehicle may only be lifted at the lifting points illus­
trated.
-L==-=--=--=--=--=-----_-_- __,--~ cf..
,,
ex, m
Fig. 203 Front lifting
point
Fig. 204 Rear lifting
point
- Read and heed WARNING=> & in "Important safety
precautions".
- Locate lifting points=> fig. 203 => fig . 204 .
- Adjust lifting arms of workshop hoist or floor jack to
match vehicle lifting points.
- Insert a rubber pad between the floor jack/workshop hoist
and the lifting points. -.,,

_______________________________________________ E_ m_ e_r_, g::;._ e_n _ c""' y:.- s_ it_u_ a_t _ i_o _n_ s __ _
If you must lift your vehicle with a floor jack to work underneath,
be sure the vehicl e is safely supported on stand s intended for this
purpo se .
Front lifting point
The lifting point is located on the floor pan reinforcement about at
t he s ame leve l as the jack mo unting point~
page 292, fig. 2 03. Do
not lift the vehicle at th e vertical sill re inforcement.
Rear lifting point
The lifting po int is located on the ve rtical reinforcement of the lower
sill fo r the onboard ja ck ~
page 29 2, fig. 2 04.
Lifting with vehicle jack
Refe r to ~ page 2 76 .
0 Note
• Be aware of the following points before lifting the vehicle:
- The vehicle should never be lifted or jacked up from under ­
neath the engine oil pan , the tran smission housing , the front or
rear axle or the body side members. This could lead to serious
damage.
- To avoid damage to the underbody or chassis frame, a rubber
pad must be inse rted between the floor ja ck and the lift points.
- Before dr iving ov er a workshop hoist , check that the vehicle
weight does not exceed the permissible lifting capacity of the hoist.
- Before driving over a work shop hoi st, en sure that there is
sufficient clearance between the hoist and low parts of the
vehicle. •
Safety first Vehicle care Do-it-yourself service Technical data

_________________________________________________ D_a_ t_ a __ B'I
- Reserve (of total capacity)
Windshield washer fluid container
Engine oil with filter change
Safety first ga
l/liters
qu arts/liters
q uarts/liters 1.8 / 7 .0
3.1 / 3 .0
4. 8 I 4.6
Do-it,yourself service
•
Technical data

___ D_ a_t _a _____________________________________________________ _
Applies to vehicles : w ith 2 .0 lite r TD! 4-cyl. clean d iesel eng ine,
140 hp, 2.0 TOI liter 4-cyl. turbo clean diesel engine
Engine data
Maximum output SAE net
Max imum torque SAE net
No. of cylinders
Displacement
Stroke
Bore
Compression ratio
Fuel
Dimensions (approx.)
Length (with license plate bracket)
Width (across mirrors)
He ight (unladen, incl. roof rails)
Turning circle diameter (curb to curb)
Capacities (approx.)
Fuel tank
- Total capac ity
- Reserve (of total capacity)
Windshield washer fluid container
Engine oil
with filter ch ange hp@rpm
lb-ft@
rpm
CID (cm
3
)
in (mm)
in (mm) 140@4200
236@ 1750 - 2500
4
120.1 (1968)
3.76 (95.5)
3 .19 (81.0)
16 .5: 1
ULSD Diesel No . 2 Further details~ page 220, "Diesel fuel"
in (mm)
in (mm)
in (mm)
ft. (m)
168 .9 (4292)
78.5 (1995)
56.0 (1423)
35.1 (10 .7)
gal/liters
gal/liters
quarts/liters
quar ts/li ters 14
.63 / 55.0
1.8 / 7.0
3.1/3.0
4 .2
I 4.0 •

___ C_ o_n_ s _ u_m_ e_ r_ I_ n_ f_o _r_ m_ a_ t_io _ n _____________________________________________ _
Under difficult operating conditions, for example at extreme ly low
outs ide temperatu res, in very d usty reg ions, whe n tow ing a trailer
very frequently, etc ., some service work s ho ul d be performed
between the intervals specified . This app lies part icu larly to:
• oil changes, and
• cleaning or rep lacing the air fi lter .
For the sake of the environment
By regular ly maintai ning you r vehicle, yo u he lp make sure that emis­
sion sta nda rds are ma inta ined, t hus m inimi zin g adve rse effects on
the environment .•
Important considerations for you and your
vehicle
T he increasing use of e lec tronics, sophisticated fuel in jection and
em ission control systems, a nd the generally increasing tec hnical
complexity of to day's automobi les, have stea dily reduced the scope
o f ma inte nance a nd repai rs wh ich can be ca rried out by veh icle
owners.
Also , safety and environmental concerns p lace very strict
limits o n the na ture of repa irs and adjustments to engi ne and trans­
mission parts which an owner can perform.
M ainte nance, adjustments and repairs us ually re quire spe cial tools,
testing devices and other equipme nt available to spec ially trained
workshop pe rsonnel in order to assure p roper per formance, reli ­
ability and safety of the vehicle and its many systems .
Improper maintenance, ad justments and repairs can impa ir the oper­
ation and reliability of you r ve hicl e and even void you r vehicle
warranty. Therefore, proof of servicing in accordance with the ma in­
t enance schedule may be a c ondi tion for upholding a possib le
warranty claim made w ith in the warra nty period.
Above all, operat iona l sa fety can be a dve rsely af fec ted, crea ting
unnecessary risks for you and your passenge rs . If
in doubt about any serv ic ing, have it done by your authorized Audi
de aler or any o ther p rope rly equippe d and qua lifi ed workshop. We
strongly u rge you to give yo ur aut horized Audi dealer the opportunity
to pe rform all scheduled ma intenance an d necessary repairs . Yo ur
dealer has t he facilit ies, original parts a nd trai ned spec ia lists to keep
your vehicle runni ng proper ly.
Performing Limited maintenance yourself
Th e follow ing pages describe a lim ite d nu mber of proce dures which
can be performed on your vehicle w ith ord inary tools, sho uld the need
arise and traine d personne l be unavailable. Before pe rforming any of
these p rocedures, always tho rough ly read all of the applicable tex t
and caref ully follow the instructions g iven. A lways rigorous ly observe
t he
WARNINGS prov ided.
B efore you check anything in the engine compartment , always read
and heed all WARNINGS=>
& and=> & in "Wor king in t he engine
compartment" on
page 226 .
& WARNING
• Serious personal injury may occur as a result of improperly
performed maintenan ce, adju stments or repairs .
• Always be extremely careful when working on the vehicle.
Alway s follow commonly ac cepted safety practice s and general
common sense. Never risk personal injury.
• Do not attempt any of the maintenance, check s or repairs
described on the following pages if you are not fully familiar with
the se or other procedure s with respect to the vehicle, or are uncer­
tain how to proceed.
• Do not do any work without the prop er tools and equipment.
Have the necessa ry work done by your autho rized Audi dealer or
another properly equipped and qualified workshop .
• The engine compartment of any motor vehicle is a potentially
hazardous area . Never reach into the area around or touch the
radiator fan. It is temperature controlled and can switch on
suddenly -even when the engine is off and the ignition key ha s .,_