2010 Seat Alhambra light

Unlocking and locking 90
Interior monitoring system and anti-tow system*
The interior monitoring system triggers the alarm if the vehicle is locked and
movement is detected inside the vehicle. The anti-tow system triggers the alarm if the vehicle is locked when the system detects the vehicle is being
raised.
Switching on the interior monitoring and the anti-tow systems
Close the storage compartment Ÿfig. 52 on the roof console otherwise
the interior of monitoring function (arrow) may not work without restrictions.
Use the key to lock the vehicle. If the antitheft alarm is turned on, the interior
monitoring and the anti-tow systems are also activated.
Switching off the interior monitoring and the anti-tow systems
To turn off the system, the reading light on the button Ÿfig. 51 must be lit.
To turn on the reading light, remove the key from the ignition or open a door.
xPush the button. A yellow warning lamp will light up in the button
until the vehicle is locked.
xLock all doors and tailgate.
xUse the key to lock the vehicle. The interior monitor and / or anti-towing
alarm are switched off until the next time the vehicle is locked.
To turn off the interior monitoring and anti-tow systems before unlocking the
vehicle, for example in the following situations:
xWhen leaving animals inside the vehicle ’ Ÿpage 83.
xWhen the vehicle must be loaded.
xWhen the vehicle is being transported, for example, by ferry.
xWhen the vehicle must be towed with the axle raised.
Risk of false alarms
The interior monitoring system only operates correctly if the vehicle is
completely closed. Observe legal requirements. The alarm may be acciden-
tally triggered in the following cases:
xWhen a window is completely or partially open.
xIf the sunglasses storage compartment in the roof console is open.
xWhen the panorama sliding sunroof is completely or partially open.
Fig. 51 Driver's seat:
button for switching off
the interior monitoring
system and the anti-tow
system.
Fig. 52 On the roof
console: interior moni-
toring sensors.
A1
d OFF

Unlocking and locking 92
Doors
Introduction
Additional information and warnings:
xVehicle key set Ÿpage 78
xCentral locking and locking system Ÿpage 83
xEmergency locking and unlocking Ÿpage 348
WARNING
If a door is not correctly closed, it could open unexpectedly when driving
and cause serious injuries.
xAlways stop immediately and close the door.
xWhen closing, ensure that the door has closed correctly. A closed door
should be flush with the corresponding parts of the bodywork.
xOpen and close doors only when nobody is in the way of the door.
WARNING
A door held open by its retainer could be blown closed by the wind or close
if the vehicle is on a hill causing injury.
xWhen opening and closing doors, always use the door handle.
Warning indicator
Several warning and control lamps should light up for a few seconds when
the ignition is switched. This signals that the lamp is working properly. They
will switch off after a few seconds.
If a door is open or incorrectly closed, the indicator
 or o on the instrument
panel will light.
Depending on the vehicle equipment, a symbol may be displayed on the
instrument panel screen instead of the warning lamp. The indication is also
visible when the ignition is switched off. The indication disappears around 15
seconds after the vehicle has been locked.
Sliding doors
Introduction
Additional information:
xVehicle key set Ÿpage 78
xCentral locking and locking system Ÿpage 83
xEmergency locking and unlocking Ÿpage 348
lights upPossible causeSolution
oAt least one vehicle door is
open or not correctly shut.› Stop driving immediately!
Open the corresponding door
and close it immediately.

Unlocking and locking97
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Ta i l g a t e
Introduction
Additional information and warnings:
xCentral locking Ÿpage 83
xTransporting Ÿpage 13
xEmergency locking and unlocking Ÿpage 348
WARNING
Careless and unsuitable locking, opening and closing of the tailgate can
cause accidents and serious injury.
xOpen and close the tailgate only when nobody is in the way.
xDo not close the tailgate by pushing it down with your hand on the rear
window. The rear window could break and cause injury.
xEnsure the tailgate is locked after closing, otherwise, it may open unex-
pectedly while driving. A closed tailgate should be flush with the corre-
sponding parts of the bodywork.
xAlways keep the tailgate closed while driving to avoid toxic gases
entering the passenger compartment.
xDo not open the tailgate when there is a load carrier installed. Likewise,
the tailgate cannot be opened when a load is attached to it, for example
bicycles. An open tailgate could close itself if there is an additional weight
on it. If necessary, press down on the tailgate and remove the load.
xClose and lock both the tailgate and all the other doors when you are
not using the vehicle. Ensure that nobody remains inside the vehicle.
xNever allow children to play inside or around the vehicle without super-
vision, especially if the tailgate is open. Children could enter the luggage
compartment, close the tailgate and become trapped. Depending on the
time of the year, temperatures inside a locked and closed vehicle can be extremely high or extremely low resulting in serious injuries and illness or
even death, particularly for young children.
xNever leave children or disabled people alone in the vehicle. If the
vehicle key or the central locking button is used, they may be locked in the
vehicle.
Caution
Before opening the tailgate, ensure that there is sufficient free space to open
and close it, for example if you are towing a trailer or in a garage.
Warning indicator
Several warning and control lamps should light up for a few seconds when
the ignition is switched. This signals that the lamp is working properly. They
will switch off after a few seconds.
A warning appears on the instrument panel
˜ if the tailgate is open or not
properly closed.
Depending on the vehicle equipment, a symbol may be displayed on the
instrument panel screen instead of the warning lamp. The indication is also
visible when the ignition is switched off. The indication disappears around 15
seconds after the vehicle has been locked.
lights upPossible causeSolution
˜The tailgate is open or not
correctly shut.› Stop driving immediately!
Open the tailgate and close it
again.
WARNING (continued)

Unlocking and locking 100
Opening the tailgate electronically
Opening the tailgate
xPress and hold the button on the vehicle key until the tailgate opens
automatically.
xALTERNATIVELY: Press and hold the button on the centre console for
approximately 1 second Ÿpage 98, fig. 56.
xALTERNATIVELY: Press the Ÿpage 98, fig. 57 tailgate button (arrow).
In case of difficulty or obstruction, automatic opening of the tailgate is inter-
rupted.
Electronically opening the tailgate does not work when a trailer is electrically
connected and hitched to a factory fitted trailer hitch Ÿpage 260.
The tailgate can be opened manually by applying more force.
Closing the tailgate
xPress and hold the button on the vehicle key for approximately 1
second.
xALTERNATIVELY: Press and hold the button on the centre console for
approximately 1 second Ÿpage 98, fig. 56.
xALTERNATIVELY: Press the Ÿpage 98, fig. 57 tailgate button (arrow).
xPress the button on the open tailgate Ÿfig. 59 Ÿ.
xManually push the tailgate down to close it.
The tailgate will move down to the closed position to close and lock itself
automatically using the power-close feature Ÿ.
In case of difficulty or obstruction, automatic closing of the tailgate is inter-
rupted and it will open slightly.
Check why the tailgate could not close.
Attempt to close it once more.
Interrupting the opening and closing process
Tailgate opening and closing can be stopped by pressing one of the
buttons. Each time one of the buttons is pressed, the tailgate moves to
its initial position.
Then, it can be opened or closed by hand. To do this, apply a little more force.
Memorising the opening angle
The tailgate must be at least half open to memorise an opening angle.
xStop automatic opening in the opening position required Ÿpage 100.
xHold down the button Ÿfig. 59 with the tailgate open for at least three
seconds. The opening angle is memorised.
Memorisation is confirmed by blinking of the hazard lights and a sound
signal.
To be opened completely, the opening angle must be memorised once more.
xRelease the tailgate and open it to the memorised height.
xPush the tailgate all the way up. To do this, apply a little more force.
Fig. 59 Button with tail-
gate open.
˜
˜
˜
˜
˜
˜˜

Unlocking and locking103
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Opening and closing the electric windows
Buttons on the driver door
Legend for the fig. 60:
For the front electric windows.
For the sliding door electric windows.
To lock the sliding doors and their windows.Opening and closing the windows
After turning off the ignition, the windows can be opened and closed for a
short time using the buttons on the door as long as the driver's door or
passenger side door is not open. When the key is removed from the ignition
and the driver's door is open, all of the electric windows can be opened or
closed using the corresponding button on the driver's door. After a few
seconds, the convenience opening or closing function will begin
Ÿpage 104.
Electric windows: functions
One-touch opening and closing
The one-touch automatic opening and closing is used to open or close the
windows completely. It will not be necessary to hold the button of the corre-
sponding electric window.
For the one-touch closing function: pull up on the button for the window to
the second position.
For the one-touch opening function: Push down the button for the window to
the second position.
Fig. 60 In the driver door:
Buttons for front and rear
electric windows and
child safety lock.
A1
A2
A3
FunctionNecessary operations
Opening:Press button .
Closing:Push the button .
To stop the one
touch function:Press or pull on the corresponding window button.
Press the button for the electronic child safety
lock to deactivate the controls for the windows on the
sliding doors and to lock these doors Ÿpage 92. The
button will light up.


r
r

Unlocking and locking 110
Programming the garage door remote control
Functions from up to 3 different remote controls for different products can be
transferred to the buttons on the sunshade ( for example, the electric system
for a gateway or a garage door, a house alarm or a lighting system).Before programming
xBefore programming the garage remote control, always read the instruc-
tion manual from the product manufacturer.
xAlways stop your vehicle safe distance from the system.
xWhen programming, turn on the ignition but do not start the engine.
Before programming the unit for the first time:
xPress the buttons and until the indicator above the button begins
to blink.
xRelease both buttons. This erases the factory settings. There is no need to
do this again to program the remaining buttons.
xHowever, if you hold in the buttons for more time, the factory settings will
be re-established.
Programming
xBefore programming, carry out the initial steps Ÿpage 110.
xPut your system's remote control, for example the remote to operate the
garage door, within 30 cm of the sunshade button Ÿfig. 64. If this is too far
away, you may have to repeat the procedure.
xNow, simultaneously hold in the button on your system's remote control
and the button , or until the indicator above the button blinks, first
slowly then more quickly Ÿfig. 65.
xRelease both buttons. The function from your system's remote control is
transferred to the corresponding button.
To transfer other functions to other buttons of the garage door remote control,
repeat the procedure described above with the button to be programmed.
Synchronising a remote control with a variable code
xBefore programming, carry out the initial steps Ÿpage 110.
xProgram the remote control Ÿpage 110.
Fig. 64 Radio frequency
remote control and control
buttons on the sunshade.
Fig. 65 To program: Press
the buttons on the garage
door control and the
remote control simultane-
ously.
132
1232

Lights and visibility113
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Lights and visibility
Lights
Introduction
The legal requirements regarding the use of vehicle lights in each country
must be observed.
The driver is personally responsible for the correct use and adjustment of the
lights in all situations.
Additional information and warnings:
xSEAT information system Ÿpage 70
xChanging bulbs Ÿpage 360
WARNING
If the headlights are set too high and the main beam is not used correctly,
there is a risk of dazzling or distracting other road users. This could result
in serious accident.
xAlways make sure that the headlamps are correctly adjusted.
xNever use the main beam or flashed headlamps as this could dazzle
other drivers.

Lights and visibility 114
Warning lamps
Several warning and control lamps should light up for a few seconds when
the ignition is switched. This signals that the lamp is working properly. They
will switch off after a few seconds.
WARNING
If the warning lamps and messages are ignored, the vehicle may stall in
traffic, or may cause accidents and severe injuries.
xNever ignore the warning lamps or text messages.
xStop the vehicle safely as soon as possible.
xPark the vehicle at a suitable distance away from the traffic ensuring
that the exhaust system is not in contact with inflammable material, for
example, dry grass, fuel, oil, etc.
xA faulty vehicle represents a risk of accident for the driver and for other
road users. If necessary, switch on the hazard warning lamps and put out
the warning triangle to advise other drivers.
Caution
Failure to heed the warning lamps and text messages when they appear may
result in faults in the vehicle.
lights upPossible causeSolution

Driving light totally or partially
faulty.
Replace the corresponding
bulb Ÿpage 360.
If all the bulbs are OK, the vehi-
cle should be taken to a spe-
cialised workshop if necessary.
Fault in adaptive light.Ÿpage 118.

Rear fog light switched on.
Ÿpage 116.
Fog lights switched on

Left or right turn signal.
The warning lamp flashes twice
as fast when a vehicle or trailer
turn signal is faulty.If necessary, check the vehicle
and trailer lighting.
Headlight on or flasher on.Ÿpage 115.
+Headlight adjustment (Light
Assist) on.Ÿpage 117.
flashesPossible causeSolution
Fault in the adaptive light sys-
tem.Contact a specialist workshop
Ÿpage 117.