2010 MITSUBISHI GRANDIS remote control

Keyless entry system*
E00300302115
Press
the remote control switch, and all doors and
the tailgate will be locked or unlocked as desired. It
is also possible to operate the outside rear-view mir-
rors. 1- LOCK switch
2-

UNLOCK switch
3- Indication lamp
To lock
Press the LOCK switch (1). All the doors and the
tailgate will be locked. If the interior lamp switch
is in the middle position (DOOR) at this time, the
room lamp & map lamps, the rear personal lamps,
and the turn-signal lamps will blink once.
To unlock
Press the UNLOCK switch (2). All the doors and
the tailgate will be unlocked. If the interior lamp
switch is in the middle position (DOOR) at this
time, the room lamp & map lamps and the rear per-
sonal lamps will come on for approximately 15 sec-
onds and the turn-signal lamps will blink twice. NOTE
l The

indication lamp (3) comes on each time
a switch is pressed.
l If the UNLOCK switch (2) is pressed and no
door or tailgate is opened within approximate-
ly 30 seconds: relocking will automatically
occur.
l It is possible to modify functions as follows:
For further information, please contact your
MITSUBISHI MOTORS Authorized Service
Point.
On a vehicle equipped with a Multi Display
Station (MDS), the functions can be adjusted
on the screen. Refer to the separate operation
manual for details.
• The time from pressing the UNLOCKswitch (2) to the moment of automatic
locking can be changed.
• The confirmation function (flashing of the turn-signal lamps) can be set to oper-
ate only when the doors and backdoor are
locked or only when the doors and back-
door are unlocked.
• The confirmation function (this indicates locking or unlocking of the doors and tail-
gate with the flash of the turn-signal
lamps) can be deactivated.
• The number of times the turn-signal lamps are flashed by the confirmation
function can be changed.
Operation of the outside rear-view mir-
rors
To fold
Within 30 seconds of locking the doors and tailgate
using the LOCK switch (1), press the LOCK
switch twice rapidly to fold the outside rear-view
mirrors. To extend
Within
30 seconds of unlocking the doors and tail-
gate using the UNLOCK switch (2), press the UN-
LOCK switch twice rapidly to return the outside
rear-view mirrors to their extended positions.
NOTE
l The keyless entry system does not operate in
the following conditions:
• The key is left in the key cylinder.
• The door or tailgate is open.
l The remote control switch will operate with-
in about 4 m from the vehicle. However, the
operating range of the remote control switch
may change if the vehicle is located near a
power station, or radio/TV broadcasting sta-
tion.
l If either of the following problems occurs,
the battery may be exhausted.
• The remote control switch is operated atthe correct distance from the vehicle, but
the doors and tailgate are not locked/un-
locked in response.
• The indication lamp (3) is dim or does not come on.

For further information, please contact
your MITSUBISHI MOTORS Author-
ized Service Point.
If you replace the battery yourself, refer
to “Procedure for replacing the remote
control switch battery” on page 1-05.
l If your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch. Locking and unlocking
1-04
1
Presented by http://mmc-manuals.ru/ \251

l
If you wish to add a remote control switch,
we recommend you to contact your
MITSUBISHI MOTORS Authorized Service
Point.
A maximum of 4 remote control switches are
available for your vehicle.
Procedure for replacing the remote
control switch battery E00309500086
1. Remove
the screw (A) from the remote con-
trol switch. 2. With
the MITSUBISHI mark facing you, in-
sert the cloth covered tip of a straight blade
(or minus) screwdriver into the notch in the remote control switch case and use it to open
the case.
NOTE
l Be

sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
switches may come out. 3. Remove
the remote control transmitter from
the remote control switch case. Then, open
the remote control transmitter using the meth-
od described in step 2. 4. Remove the old battery.
5. Install

a new battery with the + side (B) down.
Coin type battery
CR1616
- side
+ side 6. Close the remote control transmitter firmly.
7.

Place the remote control transmitter in the re-mote control switch case, then securely close
the remote control switch case.
8. Attach the screw (A) removed in step 1. Locking and unlocking
1-05 1
Presented by http://mmc-manuals.ru/ \251

9. Check the keyless entry system to see that it
works.
NOTE l You may purchase a replacement battery at
an electric appliance store.
l A MITSUBISHI MOTORS Authorized Serv-
ice Point can replace the battery for you if
you prefer. CAUTION
l
When
the remote control switch case is
opened, be careful to keep water, dust,
etc. out. Also, do not touch the internal
components. Doors
E00300401845 CAUTION
l
Make
sure the doors are closed: driving
with doors not completely closed is dan-
gerous.
l Never leave children in the vehicle unat-
tended.
l Be careful not to lock the doors while the
key is inside the vehicle.
NOTE l To

prevent the key from being locked inside
the vehicle, neither the lock knob on the driv-
er’s door nor the key can be used to lock the
driver’s door when it is open.
To lock or unlock with the key 1- Insert or remove the key
2-

Lock
3- Unlock To lock or unlock from inside the vehi-
cle
1- Lock
2-

Unlock
Pull the inside door handle towards you to open the
door.
NOTE l The driver’s door can be opened without us-
ing the lock knob by pulling on the inside
door handle.
All other doors and the tailgate are unlocked
at the same time. Locking and unlocking
1-06
1
Presented by http://mmc-manuals.ru/ \251

The mirrors can be extended and retracted for 30
seconds
after the ignition switch is turned to the
“LOCK” position.
Either the mirror switch in the cabin or the remote
controller of the keyless entry system (if so equip-
ped) can be used.
For information on the keyless entry system, refer
to page 1-04.
NOTE
l It is also possible to fold and return the mir-
rors by hand.
l When freezing has occurred and mirrors fail
to operate as intended, please refrain from re-
peated pushing of the retractor switch as this
action can result in burn-out of the mirror mo-
tor circuits.
Automatic extension of mirrors
If the engine is stopped and started with the mirrors
retracted, the mirrors automatically extend for safe-
ty when the vehicle speed reaches 30 km/h
(19 mph).
NOTE l If the mirrors are retracted manually or using
the mirror switch after the engine is started,
they do not extend automatically. Use the mir-
ror switch to extend the mirrors, or turn the
ignition switch to the “LOCK” position to ac-
tivate the automatic extension function. Heated mirror*
E00601200442
When
the rear window demister switch is pressed,
the outside rear-view mirrors are demisted or de-
frosted. Current will flow through the heater ele-
ment inside the mirrors, thus clearing away frost or
condensation.
The indication lamp (C) will illuminate while the
demister is on. The heater will be turned off auto-
matically in about 20 minutes. Ignition switch
E00601401731 LOCK
The

engine is stopped and the steering wheel
locked. The key can be inserted and removed only
when the switch is in this position.
ACC
The engine is stopped, but the electrical devices
such as the radio and cigarette lighter can be operat-
ed.
ON
The engine is running, and all the vehicle’s electri-
cal devices can be operated.
START
The starter motor operates. After the engine has star-
ted, release the key and it will automatically return
to the “ON” position. Starting and driving
4-08
4 M/T
A/T
Presented by http://mmc-manuals.ru/ \251

Interior lamp switch
E00717300263
The
interior lamp switch can be used to turn the
room & map lamps and rear personal lamps on and
off. 1 ( ) -
The room lamp & map lamps and
rear

personal lamps are off regard-
less of opening and closing of the
doors and tailgate.
NOTE l When

the room lamp & map lamp switch is
in the “ON” position, the interior lamp
switch cannot be used to turn off the room
lamp & map lamps. 2 (DOOR) - The room lamp & map lamps and
rear
personal lamps go on when a
door or the tailgate is opened. When
all doors and tailgate are closed, the
room lamp & map lamps and rear per-
sonal lamps are illuminated and dim-
med gradually for 15 seconds and
then go out.
However, the lamp goes out immedi-
ately without being dimmed in the
following cases:
l The doors and tailgate are
closed and the ignition switch
is turned to the “ON” position.
l All doors and tailgate are
locked using the key mecha-
nism of the driver’s door, the
lock knob of the driver’s door,
or the remote control switch of
the keyless entry system (if so
equipped).
NOTE l On

vehicles with keyless entry system, if the
ignition key is removed with the doors and
tailgate closed, the room lamp & map lamps
and rear personal lamps are dimmed gradual-
ly for 15 seconds and then go out.
The dimming period is also adjustable.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
On a vehicle equipped with a Multi Display
Station (MDS), the functions can be adjusted
on the screen. Refer to the separate operation
manual for details. l
When
the room lamp & map lamp switch is
in the “ON” position, closing the doors and
tailgate does not cause the room lamp & map
lamps to go off.
3 ( ) -
The room lamp & map lamps and
rear personal lamps are on regardless
of opening and closing of the doors
and tailgate.
Room lamp & map lamps E00717400020
With the doors and tailgate closed and the interior
lamp

switch in the “DOOR” position, pressing the
lens (A) makes the room lamp & map lamps come
on and pressing the lens again makes them go off.
If any of the doors or the tailgate is opened, the
room lamp & map lamps come on. When it is sub-
sequently closed, the lamps gradually dim for 15
seconds and then go off. For pleasant driving
5-36
5
Presented by http://mmc-manuals.ru/ \251

NOTE
l Even
with the interior lamp switch in the
“ ”
position, it is possible to turn on the
room lamp & map lamps by pressing the lens
(A).
l With a door or the tailgate open or the interi-
or lamp switch in the “ ”
position, the
room lamp & map lamps remain on even
when the lens (A) is pressed.
Rear personal lamps E00712600333
With the doors and tailgate closed and the interior
lamp

switch in the “DOOR” position, pressing the
lens (A) makes the lamp come on and pressing the
lens again makes it go off.
If any of the doors or the tailgate is opened, the
lamps come on. When it is subsequently closed, the
lamps gradually dim for 15 seconds and then go off. *: Front of the vehicle NOTE
l When

the interior lamp switch is in the “ ”
position,

the lamp remains off even when the
lens (A) is pressed and any of the doors or
the tailgate is opened.
Luggage compartment lamp E00712700031 1- The lamp goes off.
2- The

lamp illuminates when the tailgate is
opened, and goes out when the tailgate is
closed. Door lamps
E00717500021
Each

door lamp illuminates when the relevant door
is opened and goes off when the door is closed. Lamps (room lamps, etc.) auto-cutout
function (Vehicles with keyless entry
system)
E00712900961
If any of the interior lamps are left switched on
with

the ignition switch in any position other than
“ON” or “ACC”, it goes off automatically after ap-
proximately 30 minutes.
The lamp comes on again if the ignition switch is
turned to the “ON” or “ACC” position, any door or
tailgate is opened and closed, or the keyless entry
remote control is operated. For pleasant driving
5-37 5
Presented by http://mmc-manuals.ru/ \251