2010 MITSUBISHI GRANDIS isofix

Instructions:
l For
small infants, an infant carrier should be
used. For small children whose height when
seated allows the shoulder belt to lie in con-
tact with the face or the throat, a child seat
should be used.
l The child restraint system should be appropri-
ate for your child’s weight and height and
properly fit in the vehicle. For a higher de-
gree of safety: THE CHILD RESTRAINT
SYSTEM SHOULD BE INSTALLED IN
THE REAR SEAT. WARNING
l When
installing a child restraint system,
refer to the instructions provided by the
manufacturer of the restraint system. Fail-
ure to do so can result in severe or fatal
injury to your child.
l After installation, push and pull the child
restraint system back and forth, and side
to side, to see that it is properly secured.
If the child restraint system is not instal-
led securely, it may cause injury to the
child or other occupants in the case of ac-
cident or sudden stops.
l When the child restraint system is not in
use, keep your child or infant seat se-
cured with the seat belt or remove it from
the vehicle in order to prevent injury to
your child.
NOTE l Before

purchasing a child restraint system,
try installing it in the rear seat to make sure there is a good fit. Because of the location of
the

seat belt buckles and the shape of the seat
cushion, it may be difficult to securely install
some manufacturer’s child restraint systems.
If the child restraint system can be pulled for-
ward or to either side easily on the seat cush-
ion after the seat belt has been tightened,
choose another manufacturer’s child restraint
system.

Depending on the seating position in the ve-
hicle and the child restraint system that you
have, the child restraint can be attached us-
ing one of the following 2 locations: • To the lower anchorage in the rear seat,ONLY if the child restraint has ISOFIX
mountings (See page 2-27).
• To the seat belt (See page 2-28).
Older children E00406700192
Children who have outgrown the child restraint sys-
tem should be seated in the rear seat and wear com-
bination lap shoulder belt.
The lap portion of the belt should be snug and posi-
tioned

low on the abdomen so that it is below the
top of the hip-bone. Otherwise, the belt could in-
trude into the child’s abdomen during an accident
and cause injury. WARNING
l Children
who are not buckled up can be
thrown out of the vehicle in an accident.
l Children who are not buckled up can
strike other people in the vehicle in an ac-
cident. WARNING
l A
child should never be left unattended
in your vehicle. When you leave the vehi-
cle, take the child with you. Seat and seat belts
2-23 2
Presented by http://mmc-manuals.ru/ \251

NOTE
l The suitability table above applies to retention of child restraints using seat belts.
l When MITSUBISHI MOTORS
genuine part No. MZ313045 is used on the intermediate outboard seat, it can also be retained by means of ISOFIX child
restraint mountings.
l There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0- Up to 10 kg (0-9 months)”.

MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.
7 - person seat Mass group Seating position
Front passenger
Rear outboard Intermediate Outboard
Intermediate Cen-
tre Activated airbag
Deactivated airbag*
1 Left side Right side
0 - Up to 10 kg
(0-9 months) X XUUU X
0+ - Up to 13 kg (0-2 years) XL*2
U, L*2
U, L*2
U, L*2
L*2
I - 9 to 18 kg (9 months - 4 years) L*
3
L*3
U, L*3
U, L*3
U, L*3
L*3
II & III - 15 to 36 kg (4-12 years) L*4
L*4
U, L*4
U, L*4
U, L*4
X*
1
: With front passenger’s airbag deactivated by means of front passenger’s airbag
ON-OFF switch.
Key of letters to be inserted in the table above: l U- Suitable for “universal” category restraints approved for use in this mass group.
l UF- Suitable for forward-facing “universal” category restraints approved for use in this mass group.
l L- Suitable for particular child restraints (

MITSUBISHI MOTORS genuine parts).
l B- Built-in restraint approved for this mass group.
l X- Seat position not suitable for children in this mass group. Seat and seat belts
2-25 2
Presented by http://mmc-manuals.ru/ \251

L (Genuine part information)
Genuine parts No. ECE No.
* 2
MZ312807 E1-04301146
* 3 MZ312745
E1-04301136
MZ313045 E1-04301133
* 4
MZ312808 E1-04301148NOTE
l The suitability table above applies to retention of child restraints using seat belts.
l When MITSUBISHI MOTORS
genuine part No. MZ313045 is used on the intermediate outboard seat, it can also be retained by means of ISOFIX child
restraint mountings.
l There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0- Up to 10 kg (0-9 months)”.

MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point. Seat and seat belts
2-26
2
Presented by http://mmc-manuals.ru/ \251

Installing a child restraint system to
the lower anchorage (ISOFIX child re-
straint mountings)
E00408900042
Your
vehicle’s second seat is fitted with lower an-
chorages for attaching a child restraint system with
ISOFIX mountings.
6-person seat
7-person seat Child restraint system with ISOFIX
mountings
E00409000532
The child restraint system is designed only for
seats

that incorporate lower anchorages. Retain the
child restraint system using the lower anchorages.
It is not necessary to retain the child restraint sys-
tem using the vehicle’s seat belts. Only a
MITSUBISHI MOTORS genuine child restraint
system can be used.
Genuine parts No.: MZ313045
ECE No.: E1-04301133
A: Child restraint system connectors
WARNING
l If
a child restraint system other than a
MITSUBISHI MOTORS genuine one is
used, it may not be properly retained and
the child could be seriously injured as a
result. Use only a MITSUBISHI
MOTORS genuine child restraint system. To install WARNING
l If
there is any foreign material in or
around the connectors, remove it before
installing the child restraint system. Also,
make sure the seat belt is away from, not
looped through or otherwise interfering
with, the child restraint system. If foreign
matter is not removed and/or the seat
belt interferes with the child restraint sys-
tem, the child restraint system will not be
secured properly and could move for-
ward in the event of sudden braking or a
collision, seriously injuring the child and
possibly other vehicle occupants.
l Use the top tether strap when fitting a
child restraint system with ISOFIX
mountings.
Otherwise, the child could be seriously in-
jured in the event of hard braking or a col-
lision.
l When the vehicle is moving do not adjust
the seat where the child restraint system
is installed.
1. Slide
the second seats to the fully backward position. (Refer to “To adjust forward or back-
ward” on page 2-07.) Seat and seat belts
2-27 2
Presented by http://mmc-manuals.ru/ \251