2010 JAGUAR XFR torque

7. Torque: 25 Nm 8. Torque: 12 Nm 9. CAUTIONS:


If a new cylinder head has been installed then new
tappets must be installed.


If the cylinder head is being removed without a new
component being installed, the tappets must be installed in
their original positions.
Lubricate the valve tappets with clean engine oil.

Torque: 20 Nm
















Torque: 20 Nm

15.
















16.
17. CAUTION: Install the new seals.

Torque: 10 Nm








































NOTE: Clamp the hose to minimize coolant loss.

18.























19.
20. NOTE: Clamp the hose to minimize coolant loss.

























CAUTION: Install a new seal.
Torque: 12 Nm www.JagDocs.com

Torque: 25 Nm













23.
Refer to: Exhaust Manifold (303-01A, Removal and Installation).

24. Refer to: Camshaft RH (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).

25. Refer to: Supercharger (303-12D Intake Air Distribution and Filtering - V8 S/C 5.0L Petrol, Removal and Installation).

26. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

Engine - V8 S/C 5.0L Petrol - Engine Mount LH
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details.

All vehicles Published: 11-May-2011

1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).


2. WARNING: Do not work on or under a vehicle supported only by a jack.
Always support the vehicle on safety stands.
Raise and support the vehicle.

3. Refer to: Air Conditioning (A/C) Compressor - V8 5.0L Petrol/V8 S/C 5.0L Petrol (412-03 Air Conditioning, Removal and Installation).

4. CAUTION: Support the engine on a jack. The angle may need to be
adjusted during this procedure.
Support the engine with the lifting equipment.

Left-hand drive vehicles

5.














6. NOTE: Note the fitted position.
Torque: 35 Nm Right-hand side shown, left-hand side similar.

Support and release the power steering rack.


















Torque: 63 Nm Remove and discard the nut.
















Torque: 48 Nm Raise the engine.

Installation
10.

NOTE: Do not disassemble further if the component is
removed for access only.
Torque: 48 Nm Remove and discard the nut.

1. To install, reverse the removal procedure.