2010 CITROEN C4 PICASSO Owners Manual

Downloaded from www.Manualslib.com manuals search engine XI
199
PRACTICAL INFORMATION


Access to the second dashboard
fusebox


After any operation on the fuses
in the fusebox, check that the
fusebox cover is refi tted correctly
for their protection.

Table of fuses



Fuse N°


Rating



Functions




F29


20 A

Heated seats


F30


-

Not used


F31


40 A

Trailer relay unit


F32


15 A

Rear 12 V socket


F33


5 A
Parking sensors, automatic wipers and lighting,
passenger’s electric seat, lane departure warning
system, Hi-Fi amplifi er


F34


5 A

Trailer


F35


-

Not used


F36


20 A

Hi-Fi amplifi er


F37


10 A

Air conditioning, lighting pack


F38


30 A

Driver’s electric seat


F39


5 A

Fuel fi ller fl ap


F40


30 A

Passenger’s electric seat, panoramic sunroof

Downloaded from www.Manualslib.com manuals search engine XI
200
PRACTICAL INFORMATION

Fuses in the engine
compartment

Access to the fuses


)
Detach and remove the cover.

After any operation, carefully refi t
the cover. If the cover is not cor-
rectly positioned or not properly
closed, this could cause serious
problems on your vehicle. For the
same reason, take care not to spill
any liquid in the fusebox.


All work on the maxi-fuses,
which are located in these
fuseboxes and which give
extra protection, must be carried
out by a CITROËN dealer or a
qualifi ed workshop.

Downloaded from www.Manualslib.com manuals search engine XI
201
PRACTICAL INFORMATION


Fuse N°



Rating



Functions




F1



20 A

Engine management


F2



15 A

Horn


F3



10 A

Screenwash pump


F4



20 A

Headlamp wash pump


F5



15 A

Engine components


F6



10 A

Xenon dual-function directional headlamps, automatic headlamp height adjustment,
clutch switch, protection switch box (BCP)


F7



10 A

Automatic gearbox, engine coolant level switch, power steering


F8



25 A

Starter motor


F9



10 A

Stop lamp switch


F10



30 A

Engine components


F11



40 A

Rear blower


F12



30 A

Screen wipe


F13



40 A

Built-in Systems Interface (BSI)


F14



30 A

Air pump, heat exchange saver


F15



10 A

Right-hand main beam


F16



10 A

Left-hand main beam


F17



15 A

Left-hand dipped beam


F18



15 A

Right-hand dipped beam


F19



15 A

Engine components


F20



10 A

Engine components


F21



5 A

Cooling fan relay
Table of fuses

Downloaded from www.Manualslib.com manuals search engine XI
202
PRACTICAL INFORMATION

Fuses on the battery


After any operation, carefully refi t
the cover. If the cover is not cor-
rectly positioned or not properly
closed, this could cause serious
problems on your vehicle. For the
same reason, take care not to spill
any liquid in the fusebox.



Table of fuses

Access to the fuses


)
Detach and remove the cover.
Fuses F1
to F6
are located on
the small board, clipped verti-
cally on the battery fusebox.
Fuses F7
to F12
are midi-
fuses. All work on these
fuses must be carried out
by a CITROËN dealer or a
qualifi ed workshop.


Fuse N°



Rating



Functions




F1



5 A

Automatic gearbox actuator


F2



5 A

Stop switch


F3



5 A

Battery charge estimation ECU


F4



20 A

ESP supply


F5



5 A

ESP supply


F6



20 A

ECU for 6-speed electronic gearbox/automatic gearbox

Downloaded from www.Manualslib.com manuals search engine XI
203
PRACTICAL INFORMATION
12 V BATTERY
Procedure for starting the engine
using another battery or for charging
your fl at battery.


The Stop & Start battery does not
have to be disconnected for charging.







The presence of this label, in
particular with the Stop & Start
system, indicates the use of
a 12 V lead-acid battery with
special technology and specifi cation;
the involvement of a CITROËN deal-
er or a qualifi ed workshop is essential
when replacing or disconnecting the
battery.

After refi tting the battery, the Stop &
Start system will only be active after
a continuous period of immobilisa-
tion of the vehicle, a period which
depends on the climatic conditions
and the state of charge of the bat-
tery (up to about 8 hours).

*

or position P
for an automatic gearbox.


Access to the battery

Before doing any work
Immobilise the vehicle: ap-
ply the parking brake, put
the gearbox in neutral * , then switch
off the ignition.
Check that all electrical equipment
is switched off.


Check that the battery posts and
terminals are clean. If they are cov-
ered with sulphate (white or green
deposit), disconnect them and
clean them.

Batteries contain harmful
substances such as sul-
phuric acid and lead. They
must be disposed of in accordance
with regulations and must not, in
any circumstances, be discarded
with household waste.
Take used cell batteries and vehi-
cle batteries to an authorised col-
lection point.
The battery is located under the
bonnet.
For access to the (+) terminal:


)
Release the bonnet using the
interior lever, then the exterior
safety catch,

)
raise the bonnet and secure it
with its stay,

)
lift the plastic cover for access to
the (+) terminal.

Downloaded from www.Manualslib.com manuals search engine XI
204
PRACTICAL INFORMATION

Disconnecting the (+)
terminal


)
Raise the lever D
fully to release
the clamp E
.


Do not force the lever as locking
will not be possible if the clamp is
not positioned correctly; start the
procedure again.



Reconnecting the (+) terminal



)
Position the open clamp E
of the
cable on the positive post (+) of
the battery.

)
Press down on the clamp to po-
sition it correctly on the battery
post.

)
Lock the clamp by lowering the
lever D
.


Starting using another
battery
If the battery in your vehicle is fl at,
the engine can be started using a
slave battery (external or in another
vehicle) and jump leads.

First ensure that the slave
battery has a nominal volt-
age of 12 V and a capac-
ity at least equal to that of the fl at
battery.
Do not try to start the engine by
connecting a battery charger.
Do not disconnect the (+) terminal
when the engine is running.

)
Connect the red lead to the (+)
terminal of the fl at battery A
,
then to the (+) terminal of the
slave battery B
.

)
Connect one end of the green or
black lead to the (-) terminal of
the slave battery B
(or the earth
point on the slave vehicle).

)
Connect the other end to the
earth point C
on the broken-
down vehicle.

)
Start the engine on the slave ve-
hicle and leave the engine run-
ning for a few minutes.

)
Operate the starter on the bro-
ken-down vehicle and leave the
engine running.
If the engine does not start
straight away, switch off the ig-
nition and wait a few moments
before trying again.

)
With the engine idling, discon-
nect the jump leads in reverse
order.

Downloaded from www.Manualslib.com manuals search engine XI
205
PRACTICAL INFORMATION

Before disconnecting


)
Go to the battery.

)
Check that all of the openings -
doors, boot... - are closed but not
locked.

)
Wait at least four minutes after
switching off the ignition.
Charging


)
Disconnect the (+) terminal.

)
Follow the instructions on use
provided by the manufacturer of
the charger.

)
Connect the red cable of the
charger to the (+) post of the bat-
tery, then the black cable to the
(-) terminal.

)
Once charging is complete, dis-
connect the charger cables in re-
verse order.
The charging operation
must be carried out in a
well ventilated area and
well away from naked fl ames and
sources of sparks, so as to avoid
any risk of explosion and fi re.
Do not try to charge a frozen bat-
tery; the battery must fi rst be
thawed out to avoid any risk of ex-
plosion. If the battery has frozen,
before charging, have it checked
by a CITROËN dealer or a quali-
fi ed workshop, who will ensure that
the internal components have not
been damaged and that the casing
is not cracked, which would intro-
duce the risk of a leak of toxic and
corrosive acid.



Charging the battery using
a battery charger
If the battery of your vehicle is fl at
or prior to taking the vehicle out of
service for an extended period, you
can charge the battery using a bat-
tery charger.
For information on the specifi cation
of battery chargers compatible with
your battery, refer to a CITROËN
dealer or a qualifi ed workshop.
It is recommended that the battery
be disconnected if the vehicle is not
be used for more than a month.
Reinitialisation after
reconnection

After any reconnection of the bat-
tery, switch on the ignition and wait
at least one minute before starting,
to allow time for the initialisation of
the electronic systems.
By referring to the corresponding
sections, you should set or initialise
the following systems yourself:


- the date and time,

- the anti-pinch on the driver's
electric window and the sunroof.

- the panoramic sunroof blind,

- the multifunction screen set-
tings,

- the audio system or navigation
system settings,
Check that there no error message
or warning lamp comes on after
switching on the ignition.
However, if minor problems persist
after carrying out these operations,
contact a CITROËN dealer or a
qualifi ed workshop.

Downloaded from www.Manualslib.com manuals search engine XI
206
PRACTICAL INFORMATION
ENERGY ECONOMY MODE
System which manages the duration
of use of certain functions to conserve
a suffi cient level of charge in the
battery.
After the engine has stopped, you can
still use functions such as the audio
and telematics system, windscreen
wipers, dipped beam headlamps,
courtesy lamps, etc. for a maximum
combined duration of thirty minutes.


Switching to economy mode

Once this period has elapsed, a
message appears on the multi-func-
tion screen indicating that the vehi-
cle has switched to economy mode
and the active functions are put on
standby.
If a telephone call is being made at
this time:


- it will be maintained for 10 minu-
tes with your Audio system or
MyWay hands-free system

- it will be maintained for 10 minu-
tes with the NaviDrive, then it will
transfer to your telephone de-
pending on its model.



Exiting economy mode

These functions are reactivated au-
tomatically next time the vehicle is
started.
To resume the use of these functions
immediately, start the engine and let
it run for at least 5 minutes.
A fl at battery prevents the
engine from starting (refer
to the corresponding para-
graph).
This period may be reduced con-
siderably if the battery is not fully
charged.