2010 CITROEN C4 PICASSO Owners Manual

Downloaded from www.Manualslib.com manuals search engine IV
87
ACCESS

Reinitialisation
If a window does not rise automati-
cally, its operation must be reini-
tialised:


)
pull the control until the window
stops,

)
release the control and pull it
again until the window closes
fully,

)
continue to hold the control for
approximately one second after
the window has closed,

)
press the control to lower the
window automatically to the low
position,

)
when the window has reached
the low position, press the con-
trol again for approximately
one second.

The safety anti-pinch function
is not operational during these
operations.




Deactivation of the rear
electric window and door
controls


)
For the safety of your children,
press control 5
to deactivate the
rear electric window controls re-
gardless of their position. Always remove the key from the
ignition when leaving the vehicle,
even for a short time.
If an obstacle is encountered during
operation of the electric windows,
you must reverse the movement of
the window. To do this, press the
control concerned.
When the driver operates the con-
trols for the passengers' electric
windows, they must ensure that no
one is preventing correct closing of
the windows.
The driver must ensure that the
passengers use the electric win-
dows correctly.
Be aware of children when operat-
ing the windows.
This warning lamp comes
on temporarily on the instru-
ment panel on deactivation
and each time the ignition is
switched on.
This control also deactivates the
interior controls for the rear doors
(refer to the section "Child safety -
Electric child lock").

Downloaded from www.Manualslib.com manuals search engine IV
88
ACCESS
DOORS

Opening


From outside
When the selective unlocking is
activated, the fi rst press of the
remote control unlocking button
permits unlocking of the driver's
door only.

)
Pull the interior control lever of
a front door; this unlocks the ve-
hicle completely.


With the selective unlocking acti-
vated:


- the driver's door control unlocks
the driver's door only,

- the other door controls unlock
the other doors and the boot.
The interior door controls do not
operate when the vehicle is dead-
locked.












Manual central locking
control
System for locking or unlocking the
vehicle - the doors and boot - from
the driving position.

Locking


)
Press this button to lock the ve-
hicle.
The red indicator lamp on the button
comes on.
If one of the doors is open, the cen-
tral locking does not take place.
If the boot or the rear screen is
open, central locking from the in-
side is active for the doors, to allow
long objects to be carried.

)
After unlocking the vehicle com-
pletely using the remote control
or the key, pull the door handle.



From inside

Downloaded from www.Manualslib.com manuals search engine IV
89
ACCESS

Unlocking


)
Press this button again to unlock
the vehicle.
The red indicator lamp on the button
goes off.
If the vehicle is locked or dead-
locked from the outside, the red in-
dicator lamp fl ashes and button A

is inactive.


)
In this case, use the remote
control or the key to unlock the
vehicle.












Automatic central locking

This system automatically locks the
doors, boot and rear screen while
driving.
You can activate or deactivate this
function.

Locking
When the speed exceeds 6 mph
(10 km/h), the doors, the boot and
the rear screen lock automatically.
Unlocking


)
Above 6 mph (10 km/h), press
this button to unlock the doors,
the boot and the rear screen
temporarily.


Ignition on:

Deactivation


)
Press this button again for more
than two seconds.
A confi rmation message appears in
the multifunction screen.








Emergency control

System which locks or unlocks the
doors mechanically in the event of
a malfunction of the battery or of the
central locking.
Locking the driver's door


)
Insert the key in the lock, then
turn it to the right.


Unlocking the driver's door


)
Insert the key in the lock, then
turn it to the left.


Locking the front and rear
passenger doors


)
Insert the key in the lock, located
on the edge of the door, then turn
it one eighth of a turn
.


Unlocking the front and rear
passenger doors


)
Pull the interior door opening
control.

If one of the doors or the boot or
rear screen is open, the automat-
ic central locking does not take
place. Activation


)
Press this button for more than
two seconds.
A confi rmation message appears in
the multifunction screen. In the event of a fault with the cen-
tral locking, you must disconnect
the battery to lock the boot and so
ensure the complete locking of the
vehicle.

Downloaded from www.Manualslib.com manuals search engine IV
90
ACCESS
BOOT


)
After unlocking the vehicle com-
pletely using the remote control
or the key, with the rear screen
closed, pull on the lever 1
and
raise the tailgate.



)
Lower the tailgate using one of
the two handholds 3
, located on
the interior trim.

- when the engine is
running
, this warning
lamp comes on, accom-
panied by a message in
the multifunction screen
for a few seconds,

- when the vehicle is moving

(speed above 6 mph (10 km/h)),
this warning lamp comes on, ac-
companied by an audible signal
and a message in the multifunc-
tion screen for a few seconds.
If the tailgate is not closed correctly:
REAR SCREEN

This opening gives easy access
to the boot, even if you are parked
close to a wall or another vehicle.

Closing



)
Lower the rear screen guiding
it with the wiper arm until it is
closed.
If the rear screen is not closed cor-
rectly:


- when the engine is
running
, this warning
lamp comes on, accom-
panied by a message in
the multifunction screen
for a few seconds,

- when the vehicle is moving

(speed above 6 mph (10 km/h)),
this warning lamp comes on, ac-
companied by an audible signal
and a message in the multifunc-
tion screen for a few seconds.
The boot and the rear screen
cannot both be open at the same
time. When the rear screen is open,
you can access the boot by rais-
ing the rear shelf using its tab
(C4 Picasso).


)
After unlocking the vehicle com-
pletely using the remote control
or the key, with the boot closed,
press the control 2
and raise the
rear screen using the base 4
of
the wiper arm.
)
Past the balancing point, allow
the tailgate to lower and close
itself (do not assist it or slow it
down).


Opening

Opening

Closing

Downloaded from www.Manualslib.com manuals search engine IV
91
ACCESS






Emergency boot release

System for mechanical unlocking of
the boot in the event of a battery or
central locking malfunction.

Unlocking


)
Fold back the rear seats to gain
access to the lock from inside
the boot.

)
Insert a small screwdriver into
hole A
of the lock to unlock the
tailgate.

)
Push the white part, located in-
side the lock, to the left to unlock
the boot.


PANORAMIC SUNROOF

It is fi tted with an electrically con-
trolled blind.

Opening the roof blind



)
Rotate the control knob B
to slide
the roof blind to the desired posi-
tion (positions 1
to 9
).



Closing the roof blind



)
Rotate the control knob B
to po-
sition 0
to close the roof blind.

Recommendations



- Pressing the locking button on
the remote control for more than
two seconds will close the blind
(practical when, for example,
you leave your vehicle in a sunlit
car park).

- On returning to your vehicle, a
press on control knob B
reposi-
tions the blind to the last position
selected.



Anti-pinch

The blind has an anti-pinch func-
tion.
At the end of its travel, when the blind
encounters an obstacle on closing, it
stops and moves back slightly.
Following a fault or after a battery
disconnection during the movement
of the blind or after it has stopped,
you must re-initialise the anti-pinch
function:


)
place the blind in the closed po-
sition,

)
press control knob B
for approxi-
mately two seconds.

Downloaded from www.Manualslib.com manuals search engine IV
92
ACCESS
FUEL TANK

Capacity of the tank: approxi-
mately 60 litres.



Low fuel level

When the low fuel level is
reached, this warning lamp
on the instrument panel
comes on, accompanied by
an audible warning and a message
on the multifunction screen.
When it fi rst comes on, about 7 litres

of fuel remain in the tank.
Until suffi cient fuel has been
added, this warning lamp appears
every time the ignition is switched
on, accompanied by an audible
warning and a message. Depending
on version, this audible warning
and message are repeated with
increasing frequency as the fuel
level drops towards " 0
".
Refuel as soon as possible to avoid
running out. A label on the inside of the fuel fi ller
fl ap reminds you of the type of fuel
to use, depending on your engine
type.
Additions of fuel must be of at least
5 litres to be registered by the fuel
gauge.

Refuelling


If you are fi lling your tank to
the top, do not persist after the
3rd cut-off; this could cause
malfunctions.






With Stop & Start, never refuel with
the system in STOP mode; you
must switch off the ignition with the
key. Opening the fi ller cap may result in
an inrush of air. This is entirely nor-
mal and results from the sealing of
the fuel system.


)
Press control switch A
, situated
on the switch panel on the left of
the dashboard, until the fuel fl ap
opens.
This control switch remains ac-
tive for a few minutes after
switching of the ignition. If nec-
essary, switch the ignition on
again to reactivate it.

)
Take care to select the pump
that delivers the correct type of
fuel for your vehicle.

)
Introduce the nozzle so as to push
in the metal non-return fl ap B.

)
Make sure that the nozzle is
pushed in as far as possible
before starting to refuel (risk of
blowback).

)
Maintain this position throughout
the refuelling operation.

)
Push the fuel fl ap to close it.

Downloaded from www.Manualslib.com manuals search engine IV
93
ACCESS
The petrol or Diesel engine of your ve-
hicle is fi tted with a catalytic converter, a
device which helps to reduce the level of
harmful emissions in the exhaust gases.

For petrol engines, you must use
unleaded fuel.
The fi ller neck is narrower, allowing only
unleaded petrol nozzles to be intro-
duced.

If you have put in the wrong fuel
for your vehicle, you must have
the fuel tank drained and fi lled
with the correct fuel before start-
ing the engine.













Quality of the fuel used for
petrol engines











Quality of the fuel used for
Diesel engines

Fuel cut-off

Your vehicle is equipped with a safe-
ty device which cuts off the fuel sup-
ply in the event of a collision.
The petrol engines are perfectly
compatible with E10 or E24 type pet-
rol biofuels (containing 10 % or 24 %
ethanol), conforming to European
standards EN 228 and EN 15376.
E85 type fuels (containing up to
85 % ethanol) are reserved exclu-
sively for vehicles marketed for the
use of this type of fuel (BioFlex ve-
hicles). The quality of the ethanol
must comply with European stan-
dard EN 15293.
For Brazil only, special vehicles are
marketed to run on fuels containing
up to 100 % ethanol (E100 type).

The Diesel engines are perfectly
compatible with biofuels which con-
form to current and future European
standards (Diesel fuel which com-
plies with standard EN 590 mixed
with a biofuel which complies with
standard EN 14214) available at the
pumps (containing up to 7 % Fatty
Acid Methyl Ester).
The B30 biofuel can be used in cer-
tain Diesel engines; however, this
use is subject to strict application
of the special servicing conditions.
Contact a CITROËN dealer or a
qualifi ed workshop.
The use of any other type of (bio)fuel
(vegetable or animal oils, pure or di-
luted, domestic fuel...) is strictly pro-
hibited (risk of damage to the engine
and fuel system).

Downloaded from www.Manualslib.com manuals search engine V
94
VISIBILITY
EXTERIOR LIGHTING
CONTROLS
Control stalk for the selection and con-
trol of the various front and rear lamps
providing the vehicle's lighting.

Main lighting

The various front and rear lamps of
the vehicle are designed to adapt
the driver's visibility progressively in
relation to the climatic conditions:


- sidelamps, to be seen,

- dipped beam headlamps to see
without dazzling other drivers,

- main beam headlamps to see
clearly when the road is clear.



Additional lighting

Other lamps are fi tted to fulfi l the require-
ments of particular driving conditions:


- a rear foglamp to be seen from a
distance,

- front foglamps for even better
forward vision,

- directional headlamps for improved
visibility when cornering,

- daytime running lamps to be
seen during the day.



Programming

Various automatic lighting control
modes are also available depending
on options:


- guide-me-home lighting,

-
automatic illumination of headlamps,


- directional lighting.



Manual controls

Lamps off.





Automatic illumination of head-
lamps.
Sidelamps.
Dipped headlamps or
main beam headlamps.

B.
Stalk for switching headlam-
ps: pull the stalk towards you
to switch the lighting between
dipped and main beam head-
lamps.
In the lamps off and sidelamps
modes, the driver can switch on the
main beam headlamps temporarily
("headlamp fl ash") by maintaining a
pull on the stalk.

Displays

Illumination of the corresponding
indicator lamp in the instrument pan-
el confi rms that the lighting selected
is on. The lighting is controlled directly by
the driver by means of the ring A

and the stalk B
.
A.
Main lighting mode selection
ring: turn it to position the symbol
required facing the mark.