2010.5 Citroen DS4 engine

Press the closed padlock on the remote control. This will switch on the cour tesy lamps and the direction indicators will flash for a few seconds.
Locating your vehicle
This function allows you to identify
your vehicle from a distance, par ticularly in poor light. Your vehicle must be locked.
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible. This electronic engine immobiliser locks the engine management system a few minutes after the ignition is switched off and prevents star ting of the engine by anyone who does not have the key.
In the event of a fault, you are informed by illumination of this warning lamp, an audible signal and a message in the screen. In this case, your vehicle does not star t; contact a CITROËN dealer as soon as possible.
Folding the key
 First press this button to fold the key.

103Access
Starting the vehicle
 Inser t the key in the ignition switch. The system recognises the star ting code.  Turn the key fully towards the dashboard to position 3 (Star ting) .  When the engine star ts, release the key.
 Immobilise the vehicle.
 Turn the key fully towards you to position 1 (Stop) . Remove the key from the ignition switch.
Switching the vehicle off
A heavy object (key fob...), attached to the key and weighing down on its shaft in the ignition switch, could cause a malfunction.
Key left in the "Ignition on" position
If the key has been left in the ignition switch, the ignition will be switched off automatically after one hour. To switch the ignition back on, turn the key to position 1 (Stop) , then back to position 2 (Ignition on) .

Press the closed padlock on the remote control. This will switch on the cour tesy lamps and the direction indicators will flash for a few seconds.
Locating your vehicle
This function allows you to identify
your vehicle from a distance, par ticularly in poor light. Your vehicle must be locked.
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible. This electronic engine immobiliser locks the engine management system a few minutes after the ignition is switched off and prevents star ting of the engine by anyone who does not have the key.
In the event of a fault, you are informed by illumination of this warning lamp, an audible signal and a message in the screen. In this case, your vehicle does not star t; contact a CITROËN dealer as soon as possible.
Folding the key
 First press this button to fold the key.

103Access
Starting the vehicle
 Inser t the key in the ignition switch. The system recognises the star ting code.  Turn the key fully towards the dashboard to position 3 (Star ting) .  When the engine star ts, release the key.
 Immobilise the vehicle.
 Turn the key fully towards you to position 1 (Stop) . Remove the key from the ignition switch.
Switching the vehicle off
A heavy object (key fob...), attached to the key and weighing down on its shaft in the ignition switch, could cause a malfunction.
Key left in the "Ignition on" position
If the key has been left in the ignition switch, the ignition will be switched off automatically after one hour. To switch the ignition back on, turn the key to position 1 (Stop) , then back to position 2 (Ignition on) .

111Access
Doors
Opening
From outside
 After unlocking the vehicle completely using the remote control or the key, pull the
door handle.
From inside
 Pull the front door control to open the door; this unlocks the vehicle completely.  Pull the rear door control to open the door; this unlocks only the door opened.
Closing
When a door is not closed correctly:
- when the engine is running , this warning lamp comes on, accompanied by a message in the multifunction screen for a few seconds,
- when the vehicle is moving (speed higher than 6 mph (10 km/h)), this warning lamp comes on, accompanied by an audible signal and a message in the multifunction screen for a few seconds.
When the selective unlocking is
activated, the first press of the remote control unlocking button permits unlocking of the driver's door only.
With the selective unlocking activated: - the driver’s door control unlocks the driver’s door only. - the passenger’s door control unlocks the other doors and the boot. The interior door controls do not operate when the vehicle is deadlocked.

113Access
Boot
Unlocking the boot
 Press this button to unlock the boot. As a safety measure, this action does
not unlock the doors.
Closing
 Lower the boot lid using the interior grab handle.
If the tailgate is not closed correctly:
- when the engine is running , this warning lamp comes on, accompanied by a message in the multifunction screen for a few seconds,
- when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes on, accompanied by an audible signal and a message in the multifunction screen for a few seconds.
System for mechanical unlocking of the boot in the event of a battery or central locking malfunction.
Tailgate release
Unlocking
 Fold back the rear seats to gain access to the lock from inside the boot.  Inser t a small screwdriver into hole Aof the lock to unlock the tailgate.  After unlocking the boot or the vehicle using the remote control or the key, press the opening control, then raise the tailgate.
Opening
When the selective unlocking is activated, the boot can be opened at the second press of the unlocking button on the remote control.

117Access
Quality of the fuel used
for petrol engines
The petrol engines are per fectly compatible with E10 type petrol biofuels (containing 10 % ethanol), conforming to European standards EN 228 and EN 15376. E85 type fuels (containing up to 85 % ethanol) are reser ved exclusively for vehicles marketed for the use of this type of fuel (BioFlex vehicles). The quality of the ethanol must comply with European standard EN 15293. For Brazil only, special vehicles are marketed to run on fuels containing up to 100 % ethanol (E100 type).
Quality of the fuel used
for Diesel engines
The Diesel engines are per fectly compatible with biofuels which conform to current and future European standards (Diesel fuel which complies with standard EN 590 mixed with a biofuel which complies with standard EN 14214) available at the pumps (containing up to 7 % Fatty Acid Methyl Ester). The B30 biofuel can be used in cer tain Diesel engines; however, this use is subject to strict application of the special ser vicing conditions. Contact a CITROËN dealer or a qualified workshop. The use of any other type of (bio)fuel (vegetable or animal oils, pure or diluted, domestic fuel...) is strictly prohibited (risk of
damage to the engine and fuel system).
The petrol or Diesel engine of your vehicle is fitted with a catalytic conver ter, a device which helps to reduce the level of harmful emissions in the exhaust gases. For petrol engines, the use of unleaded fuel is compulsor y. The filler neck is narrower, admitting unleaded petrol nozzles only.
Fuel supply cut-off
Your vehicle is equipped with a safety device which cuts off the fuel supply in the event of a collision.
If you have put in the wrong fuel for your vehicle, you must have have the tank drained and refilled with the correct fuel before you star t the engine.

Misfuel prevention Mechanical device which prevents filling the tank of a Diesel vehicle with petrol. It avoids the risk of engine damage that can result from filling with the wrong fuel. Located in the filler neck, the misfuel prevention device appears when the filler cap is removed.
When a petrol filler nozzle is introduced into the fuel filler neck of your Diesel vehicle, it comes into contact with the flap. The system remains
closed and prevents filling. Do not persist but introduce a Diesel type filler nozzle.
Operation
It is still possible to use a fuel can to fill the reser voir. In order to ensure a good flow of fuel, do not place the nozzle of the fuel can in direct contact with the flap of the misfuel prevention device.
This equipment will become available during the year.