2010.5 Citroen DS4 light

Customisable colour instrument panel with audio system
1. Rev counter (x 1 000 rpm or tr/min). 2. Gear shift indicator with manual gearbox or gear lever position and gear for the
electronic gearbox system. 3. Analogue speedometer (mph or km/h). 4. Cruise control or speed limiter setting. 5. Digital speedometer (mph or km/h).
Dials and screens Control buttons
6. Engine oil level indicator. 7. Ser vice indicator (miles or km) then,
total mileage recorder. These two functions are displayed successively on switching on the ignition. Lighting dimmer setting (when making an adjustment). 8. Trip mileage recorder (miles or km). 9. Fuel gauge. 10. Range (miles or km).
A. Dial COLOUR: customisation of the background colour of the dials. B. Screen COLOUR: customisation of the
background colour of the screens. C. Lighting dimmer (available in night mode). D. Reminder of the ser vicing information Reset the ser vice indicator or the trip mileage recorder.

37Monitoring
1. Rev counter (x 1 000 rpm or tr/min). 2. Gear shift indicator with manual gearbox or gear lever position and gear for the
electronic gearbox system. 3. Speedometer (mph or km/h). 4. Central colour screen associated with the satellite navigation system.
Dials and screens
5. Fuel gauge. 6. Trip mileage recorder (miles or km). 7. Ser vice spanner (if a ser vice is due or
missed), total mileage recorder. (miles or km)
Control buttons
Customisable colour instrument panel associated
with the satellite navigation system
A. Dial COLOUR: customisation of the background colour of the dials. B. Screen COLOUR: customisation of the
background colour of the screens. C. Lighting dimmer (in night mode). D. Star t a manual test (procedure for checking the status of systems and display of vehicle aler ts). Reset ser vice indicator or trip mileage recorder.

Warning lampis onCauseAction/Obser vations
Left-hand
direction indicator
flashing with buzzer. The lighting stalk is pushed down.
Right-hand direction indicator flashing with buzzer. The lighting stalk is pushed up.
Sidelamps fixed. The lighting stalk is in the "Sidelamps" position.
Dipped beam headlamps fixed. The lighting stalk is in the "Dipped beam headlamps" position.
Main beam headlamps fixed. The lighting stalk is pulled towards you. Pull the stalk to return to dipped beam headlamps.
Front foglamps fixed. The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off the front foglamps.
Rear foglamps fixed. The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the rear foglamps.
Hazard warning lamps flashing with audible signal. The hazard warning lamps switch, located on the dashboard, has been operated.
The left-hand and right-hand direction indicators a nd their associated indicator lamps flash simultaneously.
Operation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has come into o peration. It may be accompanied by an audible signal and a message on the multifunction screen.

Lighting dimmer fixed. The lighting dimmer is making an adjustment. You can adjust the level of illumination of the instruments between 1 and 16.
Passenger's airbag system fixed in the seat belt and passenger’s front airbag warning lamps display.
The control switch, located in the glove box, has been placed in the "ON" position.The passenger's front airbag is activated. In this case, do not install a "rear facing" child seat.
Move the control switch to the "OFF" position to deactivate the passenger's front airbag. In this case, you can install a "rear facing" child seat.
Automatic wiping fixed. The wiper control is pushed downwards. Automatic front wiping is activated.
Warning lampis onCauseAction/Obser vations
Stop & Star t
fixed. The Stop & Star t system has put the engine in STOP mode at a vehicle stop (traffic lights, traffic jam, or other...).
The warning lamp goes off and the engine restar ts automatically in START mode, as soon as you want to move off.
flashes for a few seconds, then goes off.
STOP mode is temporarily unavailable. or START mode is invoked automatically.
Refer to "Driving - § Stop & Star t" for special cases with STOP mode and START mode.
Parking space sensors fixed. The parking space sensors function is selected. To star t measurement, operate the direction indica tor on the side of the space to be measured, and do not exceed 12 mph (20 km/h). A message is displayed once the measurement has been completed.

55Monitoring
Lighting dimmer
Permits manual adjustment of the brightness of the instruments and controls in relation to the exterior brightness. Only operates when the vehicle lighting is on in night mode.
Activation
 Press button A to change the brightness of the instruments and controls.  When the lighting reaches the minimum setting, release the button, then press again to increase it. or  When the lighting reaches the maximum setting, release the button, then press again to reduce it.  When the lighting reaches the level of brightness required, release the button.
This indicator and the lighting
value appear in the middle of the instrument panel during adjustment to show the lighting level compared to the 16 levels available.
You can also modify the level of lighting by turning the thumb wheel B , located on the left of the steering wheel:  upwards; to reduce the level,  downwards; to increase the level.
Deactivation
When the vehicle lighting is off, or in day mode (daytime running lamps on), pressing the button or turning the thumb wheel does not have any effect.

System allowing cer tain screens to be switched
off for night driving. The instrument panel remains on with the analogue vehicle speed, manual or electronic gearbox system gear selected, cruise control or speed limiter information, if in use, and the low fuel aler ts as appropriate. If there is an aler t or a change in a function or to a setting, the black panel mode is interrupted.
Black panel (black screen)
Activation
 With the vehicle lighting on, press this button again to activate the black panel.  Press once more to illuminate on the
various screens again. The dashboard lighting dimmer remains operational when in black panel mode.
In the instrument panel, you can change the colour of its dials (button A ) independently from Athat of the screens (button B ). There are five colour variants, from white to blue.  press the appropriate button as many times as needed to obtain the desired colour.
Customising the instrument
panel colours
In order to retain the digital reading of the speed in km/h, activation of black panel mode is prohibited in countries that use metric units.

57Monitoring
Customising the polyphonic
sounds
This menu allows you to choose a family of polyphonic sounds from the four available. These sounds are grouped together in a family and are adapted to suit the situation and context (aler t, confirmation, rejection, direction indicators, lighting left on, key in ignition...).
For the customisable colour instrument panel associated with the satellite navigation system
 Press the thumb wheel for access to the main menu.  Select the "Choice of sounds" line and confirm.  Select the desired family of sounds and
confirm.  Save the modifications by confirming "OK".
For safety reasons, the driver must only carry out these operation when stationary.
For safety reasons, these operations are only possible when stationary.
For the customisable colour instrument panel with audio system
 Press the "MENU" button for access to the main menu.  Select the "Personalisation-configuration" menu and confirm.  Select the "Choice of sounds" line and confirm.
 Select the desired family of sounds and confirm.  Save the modifications by confirming "OK".

63Multifunction screens
 Press the "  " or "  " buttons to set the value required (15, 30 or 60 seconds), then press the "OK" button to confirm.
Choice of language
Once this menu has been selected, you can choose the language used by the display from a pre-defined list.
Display confi guration
This menu gives access to the following settings:
- "Choice of units", - "Date and time adjustment", - "Display parameters",
- "Brightness".
Choice of sounds
This menu allows you to choose a family of polyphonic sounds from the four available. These sounds are grouped together in a family and are adapted to suit the situation and context (aler t, confirmation, rejection, direction indicators, lighting left on, key in ignition...).
For safety reasons, configuration of the multifunction screen by the driver must only be done when stationary.
 Press the "  " or "  " buttons, then the "OK" button to select the "OK" box and confirm or press the "ESC" button to cancel.