2010.5 Citroen C ZERO Owner's Manual

8
Practical information
103
Changing a direction indicator bulb
) Turn the bulb holder to the left and
pull it out. ) Pull the bulb out and replace it.
To r efit, carry out these operations in reverse order.
Access to bulbs
)Remove the two screws. )Disengage the lamp unit by pulling it
towards you.

Changing a brake/sidelamp bulb

All work on the LED lamps must be carried out
by a CITROËN dealer or a qualified workshop.


Changing a reversing lamp bulb
)
Turn the bulb holder to the left and pull it out.)
Pull the bulb out and replace it.
To r efit, carry out these operations in reverseorder.

Practical information
104
Changing a foglamp bulb (W21W - 21W)
)Remove the cover.)Turn the bulb holder to the left andpull it out. )Pull the bulb out and replace it.
To r e f i t , c a r r
y out these operations in reverse order.

Changing the third brake lamp(W5W - 5W)
)
Remove the two screws. )
Remove the bulb holder.)
Pull the bulb out and replace it.
To r efit, carry out these operations in reverse
order.


Changing a number plate lamp
bulb (W5W - 5W)
)Push the cover inwards.)Turn the bulb holder and pull it out.)Pull the bulb out and replace it.
To r efit, carry out these operations in reverse
order.

8
i
!
Practical information
105











Changing a fuse

The extraction tweezer is fitted to the back of
the fusebox cover in the dashboard (right hand side).
For access: )Unclip the cover and remove it completely by pulling it towards you.)Remove the tweezer.



Access to tools
Before changing a fuse, the cause of the failure
must be identified and rectified. ) Check that the ignition switch is in
the "LOCK " position.)
Identify the failed fuse by checking
the condition of its filament.
Changing a fuse
Good Failed
)
Use the special tweezer to extract the fuse from its location.)
Always replace the failed fuse with a fuse
of the same rating. ) Check that the number marked on the box,
the rating marked on the top of the fuse
and the tables below all agree.

CITROËN will not accept responsibility for the cost incurred in repairing your vehicle or for rectifying the malfunctionsresulting from the installation of accessories not supplied and not recommended by CITROËN andnot installed in accordance with itsinstructions, in par ticular when the consumption of all of the additional equipment connected exceeds 10 milliamperes.

Yo u r v e h i c l e’s electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories in your vehicle, contact a CITROËN dealer or a qualified workshop.

Practical information
106
Dashboard fuses
The fusebox is placed in the lower dashboard (right-hand side).
Fuse N°RatingFunctions
17. 5 A Left hand front and rear sidelamps.
215 A
Accessory socket.
3-
Not used.
47. 5 A Starter motor.
520
A Audio system.
6
- Not used.
77.5 A
Vehicle equipment, ri
ght hand front and rear sidelamps.
87. 5 A Electric door mirrors.
97. 5 A Supervisor controller.
107.5 A
Air conditioning.
1110 A
Rear foglamp.
12 15 A
Door locking.
13 10 A
Courtesy lamp.

8
Practical information
107
Fuse N°RatingFunctions
1415 A Rear wiper.
157. 5 A
Instrument panel.
167. 5 A
Heating.
1720 A
Heated seat.
1810 A Option.
1
97. 5 A Door mirror heating.
2020 A Windscreen wiper.
2
17. 5 A Airbags.
2230 A
Heated rear screen.
23
30 A Heating.
24- Non used.
2510 A
Radio.
2
615 A
Passenger compar tment fuse.


Access to the fuses
See "Access to tools".

i
Practical information
108
Fuse N°RatingFunctions
1- Not used.
230 A Internal fuse.
340 A Electric motor.
440 A
Radiator fan.
5
40 A Electric windows.
6
30 A
Vacuum pump.
715 A
Main battery ECU.
815 A
Third brake lamp.
915 A
Front foglamps.
1015 A
Water pump.
Front compartment fuses
The fusebox is placed in the front compar tment
under the heating system reservoir. Only these
fuses can be replaced.

The replacement of fuses for other units (vacuum pump and battery accessories) requires the involvement of a CITROËNdealer or a qualified workshop.

8
Practical information
109

Access to the fuses
)Open the bonnet (refer to the "Checks" section),)Unclip the cover and remove it completely
by pulling towards you. )Change the fuse (refer to the corresponding paragraph).)When you have finished, close the cover carefully to ensure sealing of the fusebox.
Fuse N°RatingFunctions
1110 A On-board charger.
12 10 A
Dir
ection indicator.
1
310 A
Horn.
1410 A Daytime running lamps.
1515 A
Battery fan.
1610 A
Air conditioning compressor.
1720 A
Right hand dipped beam.
1820 A
Left hand dipped beam, headlamp adjusters.
1
910 A Right hand main beam.
20 10 A
Left hand main beam.

i !
!
Practical information
110





Towing the vehicle
Procedure for having your vehicle towed using fixed mechanical equipment.


To w i ng your vehicle

The towing eye is welded to the body below
the front bumper.) Install the towing bar. )
Start your vehicle ("Ready" lamp on).)
Put the drive selector in position N . )
Release the parking brake.)
Switch on the hazard warning lamps onyour vehicle.)
Have your vehicle towed for no more than 20 miles (30 km) without exceeding a speed of 20 mph (30 km/h)
.


When towing the vehicle with the four wheels on the ground, always use a towing bar.
When towing with only two wheels onthe ground, use professional lifting equipment.


Failure to follow these instructions may cause damage to braking components and the electric motor.









Changing
a wiper blade
Removing a front or rear
wiper blade
)Raise the corresponding wiper arm.)Remove the wiper blade, sliding it towards
the outside.
Fitting a front or rear wiper
blade
)Put the new wiper blade in place and
secure it. )Fold down the wiper arm carefully.



To w i ng another vehicle

Your vehicle cannot be used in any circumstances to tow another vehicle.