2009 SKODA YETI remove seats

Seats and Stowage
82 Pack static separation net– Press the red button of the joint - so that it releases. – Put the separation net folded together in the bag and close it. – Attach the bag with the aid of the plastic carabines to the eyes on the left and right
luggage compartment trim panel.
Installing and removing the static separation net behind the rear seats with variable loading floor*
⇒page 82 is carried out analogously as
behind the rear seats without
variable loading floor. Use the lower fixing ey
es on the carrier rails in order to attach
the carabines. The opening
⇒page 81, fig. 80
in the static separation net is designed to feed
through the three-point seat belt
⇒page 144.
Variable loading floor*Remove variable loading floorFig. 81 Luggage compartment: fold up variable
loading floor / remove variable loading floor
The variable loading floor makes it easier to handle bulky goods and creates an even luggage compartment floor when the rear seat backrests are folded forward. The maximum permissable surface load of the variable loading floor is 75 kg.
Remove variable loading floor– You can fold together the loading floor
by moving in direction of arrow
⇒ fig. 81
.
– Raise the floor in direction of arrow
⇒fig. 81
.
– Pull on both sides of the locking levers in direction of arrow
⇒fig. 81
.
– Pull the loading floor up and out in direction of arrow . – The installation of the variable loading floor is carried out in the reverse order.Secure the variable loading floor in the raised position– Fold up the hooks on the fastening strip in direction of arrow
⇒page 79, fig. 77
.
– Fold up the variable loading floor behind
the seat backrests of the rear seats.
– Fold down the hooks in direction
of arrow as far as the stop
⇒page 79, fig. 77
.
– Support the variable loading floor on the hooks folded downwards.
WARNING
Pay attention when installing that the ca
rrier rails and the variable loading floor
are correctly fixed, otherwis
e the occupants are at risk.
Note
If the variable loading floor* is installed, no flexible storage compartment can be installed.
AA
AD
A1
A2
A3
A4
A1
A3
sgg.6.book Page 82 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
83
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Remove carrier railsFig. 82 Luggage compartment: Slacken
check points / remove carrier rails
Install carrier rails– Slacken the check points on the carrier rails using the vehicle key or a flat screw-
driver
⇒fig. 82
.
– Grasp the carrier rail at the position
⇒fig. 82
and slacken it by pulling in the
direction of arrow.
– Grasp the carrier rail at the position ,
slacken it by pulling in the direction of
arrow and take it out.
– The carrier rail on the other side of
the luggage compartment can be removed in
the same way.
Install carrier rails– Position the carrier rails on the
sides of the luggage compartment.
– Press both check points on each carrier rail up to the stop. – Check the attachment of the carrier rails by pulling it.
WARNING
Pay attention when installing that the carrier rails are correctly fixed, otherwise the occupants are at risk.
Variable loading floo
r* with spare wheel*
Use variable loading floorFig. 83 Luggage compartment: Fold the side parts of the loading floor / example for using the variable loading floorThe variable loading floor makes it easier to handle bulky goods and creates an even luggage compartment floor when the rear seat backrests are folded forward. The maximum permissable surface load of the variable loading floor is 75 kg. You can fold down the side parts of the loading floor in direction arrow in order to enlarge the space foreseen for stowing items of luggage
⇒fig. 83
.
Note
If the variable loading floor with spare wheel*
is installed, no flexible storage compart-
ment can be installed.•
The variable loading floor with spare wheel*
can be secured in the raised position
in the same way as the variable loading floor without spare wheel*
⇒page 82, “Secure
the variable loading floor in the raised position”.
AB
AA
A1
AA
A2
sgg.6.book Page 83 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
84Removeable storage boxThe storage box is housed under the vari
able loading floor. If
necessary, you can
remove it. There is a space for the vehicle tool kit under the storage box
⇒page 223.
WARNING
The removeable storage box must be lo
cated under the loading floor for the
safe use of the vari
able loading floor.
Roof rackRoof rail
Pay attention to the following points if you
wish to transport luggage or other items on
the roof of your vehicle:•
A special roof luggage rack system was de
veloped for the vehicle, that is why you
should only use a roof luggage rack which has been released for use by Škoda Auto.•
The roof rail is the basis for a complete
roof luggage rack system. Separate addi-
tional holders are required for safety reasons for transporting luggage, bikes, surf-boards, skis and boats.•
The basic version of the roof luggage rack system and further components are
obtainable as accessories from the specialist garages.
Caution
•
Ensure that the opened boot lid do
es not collide with the roof load.
•
On models fitted with a power sliding/tilting roof, ensure that the opened
sliding/tilting roof does not strike any items of luggage transported on the roof.
For the sake of the environment
The increased aerodynamic drag resu
lts in a higher fuel consumption.
Roof loadDistribute weight evenly over the roof lu
ggage rack system. The maximum permissible
roof load (including roof rack system) of
75 kg
and the maximum
permissible total
weight of the vehicle should not be exceeded. You cannot make full use of th
e permissible roof load if
you use a roof luggage rack
system with a lower load carr
ying capacity. The load transported on the roof luggage
rack system must not exceed the weight limit
which is stated in the fitting instructions.
WARNING
•
The items which you transport on the roof bar system must be reliably
attached - risk of accident!•
You must on no account exceed the pe
rmissible roof load, the permissible
axle loads and the permissible gross weight of your vehicle - risk of accident!
Fig. 84 Luggage compartment: Storage box
AA
Fig. 85 Roof rail
sgg.6.book Page 84 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
86Note holderThe note holder is designed e.g. for atta
ching a car park ticket in parking areas.
The attached note has to always be
removed
before starting off in order not to restrict
the driver's vision.Ashtray*Front ashtrayRemoving ashtray– Remove the ashtray
⇒fig. 89
upwards. When removing do not hold the ashtray at
the cover - risk of breakage.
Replacing ashtray– Insert the ashtray vertically.
WARNING
Never lay flammable objects in the ashtray basin - risk of fire!Rear ashtray - low centre consoleOpening ashtray– Grasp the ashtray cover at the lower edge and fold it open in the direction of
arrow
⇒fig. 90
.
Removing ashtray– Grasp the ashtray at the handle and
pull it out in an upward direction.
Replacing ashtray– Insert the ashtray into the console and press it in. There is a beverage holder attached to
the inner side of the ashtray cover.
WARNING
Never lay flammable objects in the ashtray basin - risk of fire!
Fig. 88 Windscreen: Note holderFig. 89 Centre console: Front ashtray
Fig. 90 Low centre console: Rear ashtrayAA
AB
sgg.6.book Page 86 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
87
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Caution
The ashtray in the rear part of the centre
console must be closed
(otherwise it could
get damaged) before folding forward the rear middle seat.Rear ashtray - high centre console*Opening ashtray– Press on the top part of the cover of the ashtray in area
⇒fig. 91
.
Removing ashtray insert– Press the cover of the ashtray do
wn slightly as far as the stop.
– Grasp the ashtray insert at the cover and pull it out.Insert ashtray insert– Insert the ashtray insert into the mount and press it in.
WARNING
Never lay flammable objects in the ashtray basin - risk of fire!
Caution
The ashtray in the rear part of the centre
console must be closed
(otherwise it could
get damaged) before folding forward the rear middle seat.
Cigarette lighter*, power socketsCigarette lighter You can also use the socket on the cigarette lighter for other electrical appliances.Using the cigarette lighter– Press in the button of the cigarette lighter
⇒fig. 92
.
– Wait until the button jumps forward. – Remove the cigarette lighter immediately and use it. – Insert the cigarette lighter again into the socket.Using the socket– Remove the cigarette lighter or the cover of the power socket.– Connect the plug of the electrical appliance to the socket. The 12 volt power socket can also be used
to supply power to additional electrical
accessories with a power uptake up to 120 watts.
WARNING
•
Take care when using the cigarette lighter! Not paying proper attention or
incorrect use the cigarette lighter in an uncontrolled manner may result in burns.
Fig. 91 High centre console: Rear ashtray
AA
AB
Fig. 92 Centre console: Cigarette lighter
sgg.6.book Page 87 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
92
Note
Push the lid of the armrest up to stop to the rear before operating the handbrake.Storage compartment in rear centre console*The storage compartment is equipped with a removeable insert. – Open the storage compartment by pulling on the upper edge of the storage
compartment in the direction of arrow
⇒fig. 102
.
WARNING
The storage compartment is not a substitu
te for the ashtray and must also not
be used for such purposes - risk of fire!
Caution
The storage compartment in the rear part of the centre console must be closed (other-wise it could get damaged) before folding forward the rear middle seat.
Storage compartments in the luggage compartment*Fig. 103 Luggage compartment: Storage compartmentsStorage compartments are located on bo
th sides of the luggage compartment.
The removeable storage compartment on the left side
⇒fig. 103
is suitable for
stowing small objects weighing up to 1.5 kg. The storage compartment on the right side
⇒fig. 103
is suitable for stowing small
objects weighing up to 0.5 kg.Flexible storage compartment*A flexible storage compartmen
t is located on the right side of the luggage compart-
ment. The flexible storage compartment is foreseen for storing small objects of up to 8 kg in weight.
Fig. 102 Centre console at rear: Storage compartment
AA
AA
AB
Fig. 104 Flexible storage compartment
sgg.6.book Page 92 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
93
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Removing– Take hold of the flexible storage
compartment at both upper corners.
– Press the upper corners to the inside
and release the storage compartment by
pulling upwards.
– Remove by pulling towards you.Installing– Insert both ends of the flexible storage
compartment into the openings of the right
side trim panel of the luggage compartment and push it downwards until it locks.
Clothes hooksThe clothes hooks are located on the middle
pillar and on the handle of the headliner
above each of the rear doors.
WARNING
•
Ensure that any clothes hanging from the hooks do not impair your vision to
the rear.•
Use the hooks for hanging only light item
s of clothing and ensure that there
are no heavy or sharp-edge
d objects in the pockets.
•
The maximum permissable load of the hooks is 2 kg.
•
Do not use clothes hangers for hanging up items of clothing otherwise this
will interfere with the protection offered by the head airbag*.
Removeable through-loading bag*The removeable through-loading bag
is solely used for transporting
skis.The removeable through-loading bag is foreseen for two pairs of skis. The total weight of the skis which are transported must not exceed 10 kg.Loading– Open a rear side door of the vehicle. – Fold the backrest of the middle seat forwards
⇒page 74.
– Place the empty removeable through-loading bag in the gap between the front and
rear seats in such a way that the end of
the bag with the zip lies in the luggage
compartment.
– Open the boot lid.– Push the skis into the removeable through-loading bag from the luggage compart-
ment
⇒
.
– Close the removeable through-loading bag with the zip.Securing– Pull the securing belt with both lock to
ngues out of the pocket of the removeable
through-loading bag.
– Insert the lock tongues in the belt locks
of the rear middle seat belt , first of
all on the one side and then on the other side
⇒fig. 105
.
Fig. 105 Securing the removeable through-loading bag
AA
AC
sgg.6.book Page 93 Thursday, September 24, 2009 2:32 PM

Seats and Stowage
94– Place the securing belt in the middle of
the skis between the heel and the tip of the
bindings and pull the secu
ring belt tight at the free end of the belt .
Stowing– Carefully fold the empty (dry) removeable through-loading bag together, place it in
the luggage compartment and secure it to prevent it slipping.
WARNING
•
After placing the skis into the remove
able through-loading bag, you must
secure it with the securing belt .•
The securing belt must hold the skis tight.
•
Ensure that the securing belt for skis
grasps the middle between the tip and
the heel element of the binding (see al
so imprint on the removeable through-
loading bag).
Note
•
You must put the skis and the sticks in
the removeable through-loading bag with
the tips facing the rear.•
If there are skis with different lengths in the removeable through-loading bag,
ensure that the bindings are always positioned at the same height.•
The removeable through-loading bag must never be folded together or stowed
when moist.
AB
AA
sgg.6.book Page 94 Thursday, September 24, 2009 2:32 PM