AUTOMATIC TRANSMISSION
Fault finding - Interpretation of statuses
23A
23A - 133V3 MR-372-J84-23A000$675.mif
AJ0 BVA
Vdiag No.: 04, 05
ET263
CLUTCH 3
Note:
Status ET263 "Clutch 3" is applicable to the following sub-function:
–"Gear changes".
STATUS
DEFINITIONACTIVE: shows that clutch 3 is active.
INACTIVE: shows that clutch 3 is inactive.
NOTESSpecial notes:
Check (engine running) that status ET263 Clutch 3 is active, gear engaged 4, 5, 6.
Conformity check during a road test.
ACTIVE
INACTIVE
Status ET263 "Clutch 3" becomes "ACTIVE" for the following engaged gears:
This status only arises during the road test, with the lever in position "D" or "M", ET013
"Gear engaged" = "4", "5", "6".
IMPORTANT
It is essential to have 2 people to perform these checks during a road test.
In the event of a fault, consult the interpretation of statuses DF275 Clutch 3 solenoid
valve circuit and DF303 Clutch 3 pressure switch circuit.
If the fault is still present, contact Techline.
Status ET263 "Clutch 3" must be "INACTIVE" on all other gear ratios except:
–Lever in "D" position, status ET013 "Gear engaged" = "4", "5", "6".
–Lever in "M" position, status ET013 "Gear engaged" = "4", "5", "6".
In the event of a fault, consult the interpretation of statuses DF275 Clutch 3 solenoid
valve circuit and DF303 Clutch 3 pressure switch circuit.
If the fault is still present, contact Techline.
AFTER REPAIRCarry out a road test, then check with the diagnostic tool.
AJ0_V04_ET263/AJ0_V05_ET263
AUTOMATIC TRANSMISSION
Fault finding - Interpretation of commands
23A
23A - 150V3 MR-372-J84-23A000$855.mif
AJ0 BVA
Vdiag No.: 04, 05
AC030
CLUTCH 3 SOLENOID VALVE
NOTESSpecial notes:
Engine speed zero, vehicle speed zero and gear lever in position P.
Switch on the ignition, run command AC030 "Clutch 3 solenoid valve".
In the event of a fault, consult the interpretation of fault DF275 "Clutch 3 solenoid valve circuit".
AFTER REPAIRCarry out a road test, then check with the diagnostic tool.
AJ0_V04_AC030/AJ0_V05_AC030
