AUTOMATIC TRANSMISSION
Fault finding - Introduction
23A
23A-2V3 MR-372-J84-23A000$045.mif
123A
AJ0 BVA
Vdiag No.: 04, 05AUTOMATIC TRANSMISSION
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type:
Fault finding procedures (this document):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM)
Type of diagnostic tools:
–CLIP
Special tooling required:
3. REMINDERS
Procedure
To perform fault finding on the vehicle's computers, switch on the ignition in fault finding mode.
Proceed as follows:
–vehicle's card in reader;
–press and hold the Start button (longer than 5 seconds) with start-up conditions not fulfilled,
–connect the diagnostic tool and perform the required operations.
To cut off the + after ignition feed, proceed as follows:
–disconnect the diagnostic tool,
–press the Start button twice briefly (less than 3 seconds),
–ensure that the + after ignition feed has been cut off by checking that the computer indicator lights on the
instrument panel have gone out. Vehicle(s): SCENIC II ph2
Function concerned: Automatic transmissionName of computer: Automatic transmission
Vdiag No.: 04, 05
Special tooling required
Multimeter
Elé. 1681Universal bornier
AJ0_V04_PRELI/AJ0_V05_PRELI
MR-372-J84-23A000$045.mif
